Electrolux Ew 1289 W Manual

ENGLISH
• Drain only
- Press the SKIP/RESET button
(ILERLETME/IPTAL) once, so as tocause the
DRAIN light (BOSALTMA) to light up, then press
the START/PAUSE button.
Important!
If you accidentally press the SKIP/RESET button
more than once, the display will show three blinking
dashes. To cause the washing machine to drain the
water, select any washing programme by means of
the FABRIC button, then press SKIP/RESET three
timesin order to select the DRAIN position (only the
DRAIN light will remain...

• Duration of washing programmein hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the START/PAUSE button
BASLAT/BEKLET), the displayed time value
decreases by one unit every minute.
• The selected drying timeis displayed in minutes
or hours and minutes.
• The washing machine has stopped with water in
the tub, at the end of a programme with the RINSE
HOLD (SUDA BEKLETME) option: this is indicated
by a static zero.
• The washing machine has...

ENGLISH
10 START/PAUSE button 
(Baslat/Beklet)
This button has three functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of
button 11, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progressis interrupted. The light
above the button will start flashing. To...

• If the machine is switched off:
- depress ON/OFF (AÇMA/KAPAMA) button to
switch it on;
- select the type of fabric by means of button
“ÇAMASIR”;
- select the special programme as previously
described.
12 DELAY START button
(GECIKTIRME)
This button makes it possible to delay the starting of
the programme by up to 24 hours. The delay you
have selected is shown on the display for about 5
seconds; afterwards, the duration of the programme
reappears.
You must select this option afteryou have set the...

ENGLISH
15
Washing hints
Sorting the laundry
Follow the wash code symbols on each garment
label and the manufacturer’s washing instructions.
Sort the laundry as follows:
whites, coloureds, synthetics, delicates, woollens.
Temperatures
95°for normally soiled white cottons and linen
(e.g. tea cloths, towels, tablecloths,
sheets...)
60°for normally soiled, colour fast garments
(e.g. shirts, night dresses, pyjamas....) in
linen, cotton or synthetic fibres and for
lightly soiled white cotton (e.g....

Quantity of detergent to be used
The type and quantity of detergent will depend on
the type of fabric, load size, degree of soiling and
hardness of the water used.
Water hardness is classified in so-called “degrees” of
hardness. Information on hardness of the water in
your area can be obtained from the relevant water
supply company, or from your local authority.
Follow the product manufacturers’ instructions on
quantities to use.
Use less detergent if:
– you are washing a small load,
– the laundry is...

ENGLISH
17
Drying hints
As a dryer, the machine works on the condensation
principle.
Therefore, the water tap must be open and the
drain hose must drain water into a sink or into
the drain pipe, even during the drying cycle.
Load
Warning:
Loads of washed laundry exceeding these values
must be divided before being dried, otherwise
poor results will be obtained.
Garments not suitable for drying
• Particularly delicate items such as synthetic
curtains, woollen and silk,  garments with metal
inserts, nylon...

18
4. Switch the machine on
Press the ON/OFF button (AÇMA KAPAMA) to
switch the machine on.
The display will show three blinking dashes or a
blinking zero. The light above the button will light up.
5. Select the desired programme
Press the FABRIC button (ÇAMASIR) repeatedly, in
order to select the desired programme/ fabric.
The relevant light will light up.
The lights relevant to the phases that form the
programme will light up.
The display will show the duration of the selected
programme, calculated on...

ENGLISH
9. Select the DELAY TIME
Before you start the programme, if you wish the
starting to be delayed, press the DELAY button
GECIKTIRME repeatedly, or keep it pressed, to
select the desired delay.
The selected delay time value (up to 24 hours) will
appear on the display for 3 seconds, then the
duration of the programme will appear again.
10. Start the programme
Press the START/PAUSE button. The relevant light
will stop flashing, the DOOR LOCKED light will light
up, and only the light relevant to the...

If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the SKIP/RESET button (ILERLETME/IPTAL)
repeatedly, until only the DRAIN light (BOSALTMA)
remains lit;
• press the START/PAUSE button again.
When the water has been drained, the display shows
a blinking zero.
You may now select a new programme and press
the START/PAUSE
button to start it.
12. How to cancel a programme
during its cycle
To...