Flir ThermovisionNavigator II Installation Manual

Fuse and on /off s witch Mounting – stat Ic co NFIgUrat Io N
Caution!   Changing  the  wiring  configuration  of  the  Navigator  II  or  attempting  to  utilize  controllers  or 
wiring harnesses other than those supplied by FLIR may cause permanent damage to the unit and may 
void the warranty. 
Caution!   Do  not  connect  the  camera  to  any thing  other  than  12VDC  power.  Operating  the  camera 
outside  of  the  specified  input  voltage  range  or  the  specified  operating  temperature  range...

disassembly and assembly of the camera Base – 
For stat Ic co NFIgUrat Io N o NlY
If  you  are  mounting  the  camera  with  wood  screws,  it  may  be  necessary  to  partially  or  completely   
remove the base from the camera in order to securely attach the base to the vessel. With the camera 
removed, there is a screwdriver access hole for each mounting screw in the base flange. Remove the 
camera from its base as described in the following steps.
Note:  Removing  the  camera  from  its  base  for...

NaVI gator II s PlIc E KI t – a pplies to both configurations
For  installations  requiring  the  easy  removal  and  re-installation  of  the  Navigator  II  camera  body,  the   
camera comes with a Splice Kit. The Splice Kit includes:
Installation procedure:
Step 1 Determine the place you would like to install the Splice Kit.
Step 2 Trim of f outer cable jacket exposing four insulated wires and the un-insulated signal drain.
Step 3 Strip approximately ¼” of insulation of f each wire.
Step 4 Slide...

Step 6 When finished, all 5 terminations should look like this (female termination shown). 
Note that the un-insulated signal drain is also terminated.
Step  7  Insert  the  male  terminations  in  the  grey  shrouds  and  the  female  terminations  in  the  black  
towers.  Push  them  in  until  you  hear  them  click  into  place.  (More  detailed  Weather  Pack  termination 
instructions are available on their website, http://w w w.weatherpack.com/weatherpackfaqs.html.) 
CAUTION!!!  The  shroud  and...

The Splice Kit also includes Snap-N-Seal video connectors; their use is optional. 
Step 1 Slide connector assembly over cable as shown. 
Step 2 Prepare cable end. Cut the cable end of f square before starting 
the prep. 
Step  3  If  using  single  braid  cables,  fold  the  braid 
over  the  jacket.  Fold  the  inner  braid  over  the  jack-
et. 
Step  4  Twist  connector  to  remove  from  plastic 
sleeve.  (Plastic  ring  may  stay  attached  between   
connector  collar  and  nut).Place  connector...