Home > Ford > Automobile > Ford E250 Owners Manual

Ford E250 Owners Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Ford E250 Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 41 Ford manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    Page
    of 443
    							WARNING:Never place, or allow a child to place, the shoulder
    belt under a child’s arm or behind the back because it reduces
    the protection for the upper part of the body and may increase the risk
    of injury or death in a crash.
    WARNING:To avoid risk of injury, do not leave children or pets
    unattended in your vehicle.
    Restraint
    TypeCombined
    weight of
    child and
    child
    restraint
    seatUse any attachment method as indicated
    below by X.
    LATCH
    (lower
    anchors
    and
    top
    tether
    anchor)LATCH
    (lower
    anchors
    only)Safety
    belt
    and
    top
    tether
    anchorSafety
    belt and
    LATCH
    (lower
    anchors
    and top
    tether
    anchor)Safety
    belt
    only
    Rear-facing
    child seat
    Up to 65 lb
    (29.5 kg)XX
    Rear-facing
    child seatOver 65 lb
    (29.5 kg)X
    Forward-
    facing
    child seat
    Up to 65 lb
    (29.5 kg)
    XXX
    Forward-facing
    child seatOver 65 lb
    (29.5 kg)XX
    Note:The child seat must rest tightly against the vehicle seat upon
    which it is installed. It may be necessary to lift or remove the head
    restraint. See theSeatschapter for information on head restraints.
    20Child Safety
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							BOOSTER SEATS
    WARNING:Never place, or allow a child to place, the shoulder
    belt under a child’s arm or behind the back because it reduces
    the protection for the upper part of the body and may increase the risk
    of injury or death in a crash.
    Use a belt-positioning booster seat for children who have outgrown or no
    longer properly fit in a child safety seat (generally children who are less
    than 4 feet 9 inches (1.45 meters) tall, are greater than age four (4) and
    less than age twelve (12), and between 40 pounds (18 kilograms) and
    80 pounds (36 kilograms) and upward to 100 pounds (45 kilograms) if
    recommended by your child restraint manufacturer). Many state and
    provincial laws require that children use approved booster seats until
    they reach age eight (8), a height of 4 feet 9 inches (1.45 meters) tall, or
    80 pounds (36 kilograms).
    Booster seats should be used until you can answer YES to ALL of these
    questions when the child is seated without a booster seat.
    •Can the child sit all the way
    back against their vehicle seat
    with knees bent comfortably at
    the edge of the seat cushion?
    •Can the child sit without
    slouching?
    •Does the lap belt rest low across the hips?
    •Is the shoulder belt centered on the shoulder and chest?
    •Can the child stay seated like this for the whole trip?
    Always use booster seats in conjunction with your vehicle lap and
    shoulder belt.
    Child Safety21
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							Types of Booster Seats
    •Backless booster seats
    If your backless booster seat has a removable shield, remove the shield.
    If a vehicle seating position has a low seat back or no head restraint, a
    backless booster seat may place your child’s head (as measured at the
    tops of the ears) above the top of the seat. In this case, move the
    backless booster to another seating position with a higher seat back or
    head restraint and lap and shoulder belts, or consider using a high back
    booster seat.
    •High back booster seats
    If, with a backless booster seat, you cannot find a seating position that
    adequately supports your child’s head, a high back booster seat would be
    a better choice.
    22Child Safety
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							Children and booster seats vary in size and shape. Choose a booster that
    keeps the lap belt low and snug across the hips, never up across the
    stomach, and lets you adjust the shoulder belt to cross the chest and rest
    snugly near the center of the shoulder. The following drawings compare
    the ideal fit (center) to a shoulder belt uncomfortably close to the neck
    and a shoulder belt that could slip off the shoulder. The drawings also
    show how the lap belt should be low and snug across the child’s hips.
    If the booster seat slides on the vehicle seat upon which it is being used,
    placing a rubberized mesh sold as shelf or carpet liner under the booster
    seat may improve this condition. Do not introduce any item thicker than
    this under the booster seat. Check with the booster seat manufacturer’s
    instructions.
    Child Safety23
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							INSTALLING CHILD SEATS
    Child Seats
    Use a child safety seat (sometimes
    called an infant carrier, convertible
    seat, or toddler seat) for infants,
    toddlers or children weighing
    40 pounds (18 kilograms) or less
    (generally age four or younger).
    Using Lap and Shoulder Belts
    WARNING:Airbags can kill or injure a child in a child seat.
    Never place a rear-facing child seat in front of an active airbag. If
    you must use a forward-facing child seat in the front seat, move the
    seat upon which the child seat is installed all the way back.
    WARNING:Airbags can kill or injure a child in a child seat.
    Children 12 and under should be properly restrained in the rear
    seat whenever possible.
    WARNING:Depending on where you secure a child restraint,
    and depending on the child restraint design, you may block
    access to certain safety belt buckle assemblies or LATCH lower
    anchors, rendering those features potentially unusable. To avoid risk of
    injury, occupants should only use seating positions where they are able
    to be properly restrained.
    When installing a child safety seat with combination lap and shoulder belts:
    •Use the correct safety belt buckle for that seating position.
    •Insert the belt tongue into the proper buckle until you hear a snap
    and feel it latch. Make sure the tongue is securely fastened in the
    buckle.
    •Keep the buckle release button pointing up and away from the safety
    seat, with the tongue between the child seat and the release button,
    to prevent accidental unbuckling.
    24Child Safety
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							•Place the vehicle seat upon which the child seat will be installed in
    the upright position.
    •Put the safety belt in the automatic locking mode. See Step 5. This
    vehicle does not require the use of a locking clip.
    Perform the following steps when installing the child seat with lap and
    shoulder belts:
    Note:Although the child seat illustrated is a forward facing child seat,
    the steps are the same for installing a rear facing child seat.
    1. Position the child safety seat in a
    seat with a combination lap and
    shoulder belt.
    2. Pull down on the shoulder belt
    and then grasp the shoulder belt
    and lap belt together.
    3. While holding the shoulder and
    lap belt portions together, route the
    tongue through the child seat
    according to the child seat
    manufacturer’s instructions. Be sure
    the belt webbing is not twisted.
    Child Safety25
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							4. Insert the belt tongue into the
    proper buckle (the buckle closest to
    the direction the tongue is coming
    from) for that seating position until
    you hear a snap and feel the latch
    engage. Make sure the tongue is
    latched securely by pulling on it.
    5. To put the retractor in the
    automatic locking mode, grasp the
    shoulder portion of the belt and pull
    downward until all of the belt is
    pulled out.
    Note:The automatic locking mode is available on the front passenger
    and rear seats. This vehicle does not require the use of a locking clip.
    6. Allow the belt to retract to remove slack. The belt will click as it
    retracts to indicate it is in the automatic locking mode.
    7. Try to pull the belt out of the retractor to make sure the retractor is
    in the automatic locking mode (you should not be able to pull more belt
    out). If the retractor is not locked, unbuckle the belt and repeat Steps 5
    and 6.
    8. Remove remaining slack from the
    belt. Force the seat down with extra
    weight, for example, by pressing
    down or kneeling on the child
    restraint while pulling up on the
    shoulder belt in order to force slack
    from the belt.
    26Child Safety
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							This is necessary to remove the remaining slack that will exist once the
    extra weight of the child is added to the child restraint. It also helps to
    achieve the proper snugness of the child seat to your vehicle.
    Sometimes, a slight lean toward the buckle will provide extra help to
    remove remaining slack from the belt.
    9. Attach the tether strap (if the child seat is equipped). SeeUsing
    Tether Straps.
    10. Before placing the child in the
    seat, forcibly move the seat forward
    and back to make sure the seat is
    securely held in place.
    To check this, grab the seat at the belt path and attempt to move it side
    to side and forward and back. There should be no more than 1 inch (2.5
    centimeters) of movement for proper installation.
    Ford recommends checking with a NHTSA Certified Child Passenger
    Safety Technician to make certain the child restraint is properly installed.
    In Canada, check with your local St. John Ambulance office for referral
    to a Child Passenger Safety Technician.
    Child Safety27
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							Using Lower Anchors and Tethers for CHildren (LATCH)
    WARNING:Never attach two child safety seats to the same
    anchor. In a crash, one anchor may not be strong enough to hold
    two child safety seat attachments and may break, causing serious injury
    or death.
    The LATCH system is composed of three vehicle anchor points: two
    lower anchors located where the vehicle seat back and seat cushion meet
    (called the seat bight) and one top tether anchor located behind that
    seating position.
    LATCH compatible child safety seats have two rigid or webbing mounted
    attachments that connect to the two lower anchors at the LATCH
    equipped seating positions in your vehicle. This type of attachment
    method eliminates the need to use safety belts to attach the child seat,
    however the safety belt can still be used to attach the child seat. For
    forward-facing child seats, the top tether strap must also be attached to
    the proper top tether anchor, if a top tether strap has been provided
    with your child seat.
    LATCH lower anchors
    Top tether anchors
    28Child Safety
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    							Your vehicle has LATCH lower anchors, top tether anchors, or both at
    the following locations:
    •Five passenger crew van
    •Seven passenger wagon
    •Eight passenger wagon
    Child Safety29
    2014 Econoline(eco)
    Owners Guide gf, 2nd Printing, September 2013
    USA(fus) 
    						
    All Ford manuals Comments (0)

    Related Manuals for Ford E250 Owners Manual