Fujitsu Fujifilm X S1 Instruction Manual

7
Before You Begin
Introduction
 • Playback
100-0001100-0001
12/31/205012/31/2050
1 / 1000 F4 . 510 :00  AM10 : 00  AM2-13
3:23:2FF
200
INFORMATION ON INFORMATION OFF
:
:
: :OFF
ISO 4001/250F4.5
2
3-112 / 31 / 2050 10 : 00  AM
100-00014:3N100-0001100-0001
3
12/31/205012/31/205010 : 00  AM10 : 00  AM
DETAIL
INFORMATION I FAVO R I T ES
c  Highlights
Overexposed areas blink on and 
off.
  Histograms
Histograms show the distribution of tones in the im-
age.  Brightness is shown by the horizontal axis, the...

First Steps
8
Attaching Accessories
First Steps
 The Strap The  Strap
Attach the strap to the two strap eyelets as shown 
below.
c
To avoid dropping the camera, be sure the strap is cor-
rectly secured.
The Lens CapThe Lens Cap
Attach the lens cap as shown.
To avoid losing the lens cap, pass the supplied string 
through the eyelet (q) and secure the lens cap to the 
strap ( w).
The Lens HoodThe Lens Hood
Rotate the lens hood in the direction shown until 
it clicks into place. 

First Steps
9
 Charging the Battery
The battery is not charged at shipment.  Charge 
the battery before use.
 1  Place the battery in the supplied battery charger.
Insert the battery in the orientation indicat-
ed by the  DFC labels.
The camera uses an NP-95 rechargeable battery.
Battery charger
DFC 
label
Battery
DFC label
Charge  lamp Arrow
c
Attach the supplied adapter 
before charging the battery 
(the adapter is attached at 
shipment).
Adapter
 2  Plug the charger in. Plug the charger into an indoor...

10
 Inserting the Battery
Insert the batteries in the camera as described 
below.
   1  Open the battery-chamber cover.Slide the battery-cham-
ber latch in the direction 
shown and open the bat-
ter y-chamber cover.
a
Be sure the camera is off before opening the bat-
ter y-chamber cover.
c
•  Do not open the battery-chamber cover when 
the camera is on.  Failure to observe this pre-
caution could result in damage to image files or 
memory cards.
•  Do not use excessive force when handling the...

First Steps
11
Inserting the Battery
 3  Close the battery-chamber cover.Press the cover down un-
til it clicks into place.
 Removing the Battery
Before removing the battery, 
turn the camera off  and open 
the battery-chamber cover.  To 
remove the battery, press the 
battery latch to the side, and 
slide the battery out of the cam-
era as shown.
Battery latch c 
Batteries
•  Remove dirt from the battery terminals with a clean,  dry cloth.  Failure to observe this precaution could 
prevent the battery...

12
 Inserting a Memory Card
Although the camera can store pictures in inter-
nal memory, optional SD, SDHC and SDXC mem-
ory cards  (sold separately) can be used to store 
additional pictures.
   1  Open the memory card slot cover.
a
Be sure the camera is off be-
fore opening the memory 
card slot cover.
   2  Insert the memory card. Holding the memory card in the orientation 
shown below, slide it in until it clicks into 
place at the back of the slot.
Click
c
•  Be sure card is in the correct...

First Steps
13
Inserting a Memory Card
 3  Close the memory card slot cover. Removing Memory Cards
After confirming that the cam-
era is off, press the card in and 
then release it slowly. The card 
can now be removed by hand.
c
• The memory card may spring out if you remove  your finger immediately after pushing the card in.
•  Memory cards may be warm to the touch after be- ing removed from the camera. This is normal and 
does not indicate a malfunction. 

14
Inserting a Memory Card
 ■ ■  Compatible Memory Cards  Compatible Memory Cards
FUJIFILM and SanDisk SD, SDHC, and SDXC mem-
ory cards have been approved for use in the cam-
era. A complete list of approved memory cards 
is available at  http://www.fujifilm.com/support/
digital_cameras/compatibility/ .  Operation is not 
guaranteed with other cards.  The camera can not 
be used with xD-Picture Cards  or MultiMedia Card 
(MMC) devices.
 c  Memory Cards
•  Do not turn the camera off or remove the memory...

First Steps
15
 Turning the Camera on and Off
Rotate the ON/OFF switch to ON to turn the camera 
on.
Select  OFF to turn the camera off.
 b  Switching to Playback Mode
Press the a button to start playback.  Press  a button 
again or press the shutter button halfway to return to 
shooting mode. b  Auto Power Off
The camera will turn off automatically if no operations 
are performed for the length of time selected in the 
M AUTO POWER OFF menu (
P 102).  To reactivate the 
camera after it has turned off...

16
 Basic  Setup
A language-selection dialog is displayed the first time the camera is turned on.  Set up the camera as 
described below (for information on resetting the clock or changing languages, see page 99).
START MENU
SET NO
ENGLISH
PORTUGUÊS ESPAÑOL
FRANCAIS
DEUTSCH1  Highlight a language and press MENU/OK .
a
Press DISP/BACK  to skip the current step.  Any steps you skip will be displayed 
the next time the camera is turned on.
SET NO 
DATE / TIME NOT SET 
2013 
2012 
2010 
2009 
YY.  MM.  DD...