GTE Omni Si Database Technical Practices Manual

Table 4.4Entry Fields for Record Code OFCOMMENTS
etermines theFRL default value
timeout value.
the queue time, the FRL assigned here will
temporarily be assigned to the station.
-This value should be set up to allow the call
to be routed over a more expensive route as a
reward to the station user for havingstayed
in
- = featurenot
Code Number
of Digits-This number must be consistent throughout
the network.
-If one switch in the network has 4-digit
authorization codes, then all other switches in
the...

TL-130400-1001Table 4.4Entry Fields for Record Code OF (Continued)COMMENTS
feature is activated.
-For these features to work,the tonemust be
camp-on/call waiting calls that can be in
- = featurenoteffect at the same time per station.
-A station that has calls camped on must
complete the call-back sequence before
calls can be placed. Therefore this number
must be kept low, or making calls could be a
problem. However, if this field is too low or is
set at 
1, the attendant could be flooded with
calls; 2 or...

-
TL-130400-1001
Table 4.4Entry Fields for Record Code OF (Continued)COMMENTS
This field determines the number of times the
system will try calling a busy station before
dropping it from the on-hook queue.
-Trunk call queuing, defined in columns 28-
36, and MERS list queuing, defined on Record
Code OV, columns 12-17, are mutually
exclusive features.
-When the station is called back by the
system and it does not answer, it is dropped
Maximum
se- = N/Athe same time for the entire system.
Number of Calls...

-TL-130400-1001
Table 4.4Entry Fields for Record Code OF (Continued)
r
LThis field determines the n-displayable class
of service assigned to the remote access
dashed, this field
-These messages are defined onRecord
Code SM, columns 14-29.
for 
CASACD)M = militarymilitary time is displayed at the Agent
Instrument and on FADS (Force Administration
Data System) reports.
45Number of1-4 = number
This field determines the number of attendant
Active Attendant2 = defaultloops on which incoming calls can appear....

--TL-130400-1001
Table 4.4Entry Fields for Record Code OF (Continued)COMMENTS
or 
4-digit numberingplan)is used at thesite.
-This feature can be used to provide a
uniform numbering plan to a private network.
-Record Code NT determines the network
ment this feature refer toNumbering Plandetermine if theHNPA needs tobedeletedor
if it must be left on.
-If the routing is over ATT, the field must
-=dial tone is not
tone is heard.
required-The customer determines whether or not
this field should be activated...

TL-130400-1001Table 4.4Entry Fields for Record Code OF (Continued)COMMENTS
-The fielddetermines whether or not an
incoming network trunk is required to have an
FRL value assigned to it.
-This feature can only beusedif column
21NOTE: If a remote switch cannot assign an
FRL value to an outgoing trunk, the 
OMNI SI
can assign one. This is done on Record
Code 
Tl, column 69.
-If an incoming default FRL is not assigned
by this switch and this field is dashed, the call
will still come through.
-If the column...

--TL-130400-1001
Record Code OT:
Off ice Timeout Values4.5 Record Code OT, Figure 4.5, defines the timeout intervals
required for the various call conditions.
r---------
I -
r-----------------------------------------------------------------~
IIIT6081ir ,ItI
r-----
j T6081
r-----------------------------------------~-----
I
~---------------~-~
T608Di T533D :I IIT639AI II-III IIII
,
II I*T: M F
I
R C
:i
I
R S
: :
RkE T
CA H
bfD
I
Iw
I ‘z
i T
I ONI EI
I
tT QIR U‘U E‘N U;K INi; G
‘L TIL I
I zI...

TL-130400-1001Table 4.5Entry Fields for Record Code OTCOMMENTS
seconds before the call is automatically
disconnected after message completion.
suggested value,-The timing value must exceed the length of
themessage for the completemessage to be
-It is recommended that this field be made 3
000-255 = time inWhen the attendant camps on to a busy
station and the station remains busy, this field
determines the number of seconds that pass
before the call is returned to the console.
station user has to dial the...

TL-130400-1001Tabie 4.5Entry Fields for Record Code 0T (Continued)Recall on Hold
suggested valuecall put on hold and not retrieved to recall to
the attendant.
-Depending on how busy the attendant is, the
recommended value may prove too long for
some sites. A shorter value of 045 may work
better at sites where there are complaints of
Attendant Call
suggested valueAnswer) service.
-If the attendant is busy when an incoming
trunk call comes in, the call is automatically
routed toUNA whenthis timingparameter...

TL-130400-1001COL.NO.
Table 4.5Entry Fields for Record Code CT (Continued)
COL.VALID
NAME
ENTRIESCOMMENTS
45-47Attendant No-000-255 = time inThis field determines the number of seconds it
Answer Timesecondstakes for a trunk-originated call to return to
the console if the attendant extended the call
%-./ .”Go=to a station that did not answer.
suggested value
48-50Information
000-255 = time inFor a CAS Branch application, indicate the
Tone Delay 
,_milliseconds
amount of time between the detection of an...