Honda 75 Outboard Motor Manual

Thank you for purchasing a Honda Outboard Motor. 
This manual covers operation and maintenance of the Honda .Outboard 
Motor. All information in this publication is based on the latest product 
information available at the time of approval for printing. 
Honda Motor Co., Ltd. reserves the right to make changes at any time without 
notice and without incurring any obligation. 
No part of this publication may be reproduced without written permission. 
This manual should, be considered a permanent part of...

2  

CONTENTS 
1. SAFETY INSTRUCTIONS ........................................................... 
2. WARNING LABELS ................................................................... 
3. COMPONENT IDENTIFICATION .................................................. 
4. INSTALLATION ....................................................................... 
5. PRE-OPERATION CHECK ........................................................... 
6. STARTING THE ENGINE...

.I. SAFETY lNSTF?UCTUONS 
To ensure safe operation- 
0 Understand the operation of all controls, and know how to stop the 
engine quickly -READ THIS OWNER’S MANUAL CAREFULLY. 
0 Do not exceed the boat manufacturer’s power recommendation, and be 
sure the outboard motor is properly mounted. 
0 Never permit anyone to operate the outboard motor without proper 
instruction. 
0 Stop the engine immediately if any passenger falls overboard. 
0 Do not run the motor while the boat is near any person in the water....

2. WARNING LABELS 
FRONT LABEL 
Check oil level before starting. 9 
B d’huile avant de d8marrer.  Controler obligatoirement le niveau 
1 
I 
STARTING CAUTION LABEL 
II . DO NOT OPERATE WITH ENGINE COVER REMOVED 
. PULL STARTER LIGHTLY UNTIL SOME RESISTANCE IS FELT. 
II 
THEN PULL k lARD AND FAST. 
. OTEUR EN MARCHE AVEC LE LEVIER DES 
VlTESSES AV POINT MORT. 
CAMSHAFT PULLEY LABEL . NE PAS FAIRE FONCTIONNER LE MOTEUR LE CAPOT RELEVE 
1 
II * TIPER LE LANCEUR DOUCEMENT. PUIS FORIEMENT A LA 
II 
RECOIL...

3. COMPONENT ODENTUFICATOON 
FUEL LINE CONN 
STARTER GRIP 
THROTTLE FRICTION KNOB 
ENGINE COVER LOCK LEVER 
GEAR OIL LEVEL BOLT 
WATER INTAKE 
GEAR OIL DRAIN BOLT 
FUEL TANK 
TOOL KIT 
PRIMER BULB 
 SPARE OIL 
CONTAINER 
FUEL LINE CONNECTOR 
(FEMALE) 
6  

DIPSTICK _ 
c ;;;;;r;-;TTON 
SPARE SHEAR PINS 
AND COTTER PINS 
TILT LEVER 
ENGINE OIL DRAIN SCREW 
CLAMP SCREW 
ENGINE SERIAL NUMBER 
* Always list the serial number when 
ordering parts. 
ANTI-CAVITATION PLATE 
EXHAUST 
WATER CHECK TUBE 
7  

4. INSTALLATION 
TRANSOM HEIGHT 
It is your responsibility to choose a 
boat suitable for the engine (9.9 
horsepower BFlOO, 7.5 horsepower 
BF75). 
M Do not exceed the boat 
manufacturer’s power recommen- 
dation. Damage and injury may 
result. 
1. Installation Position 
Install at the stern at the center line 
of the boat. 
2. Installation Height 
Make sure that the transom height 
is correct for the motor. Incorrect 
installation height will reduce per- 
formance. 
The motor should be installed so...