Honeywell Am100us1 Manual

                             
SUBMITTAL 
DATA/INSTRUCTION  SHEET SD/IS 150  EFFECTIVE 
September 2004 
Supercedes March 3, 2004 
AM-1 SERIES
TM 
ANTI-SCALD PROPORTIONAL THERMOSTATIC MIXING AND DIVERTING VALVE 
PATENTED, WITH DUAL ASSE 1016 AND 1017 CERTIFICATION, IAPMO, AND 
CSA APPROVAL IN ONE VALVE 
SUBMITTAL DATA APPROVAL SHEET For:______________________________________________________ 
Job:______________________________________________________ 
Date submitted: _______________by:...

                
                               
                                      
                      
                    
                    
TEMPERATURE RANGE SELECTION: 
Select the correct temperature range for application. 
Temperature Range  M odel Application 
Special low temperature  service. (eliminates condensation on Water Closets, 
60°F - 100°F  (16°C – 38°C)  B 
greenhouse root feeding, photographic process etc.) 
80°F - 120°F  (27°C – 49°C)  C  Anti-scald code valve for domestic...

                                                                                                              
                          
                         
                         
                                                                                     
                                                           
                                                         
                                                         
  
INSTALLATION OF ASSE 1017 APPLICATIONS:
 These AM-1...

                        
SIZING FOR DOMESTIC HOT WATER
 
Table 1 Fixture Units 
Lavatory 
Kitchen Sink 
Bath 
Shower  
Clothes Washer 
Dish Washer   1 
2 
2 
2 
2 
1  Table 2
 Capacity 
Size  Fixture Units 
1/2” 
3/4” 
1”  14 
22 
30 Procedure: 
4 
 

       
 
  
SPACE HEATING               Boiler must operate at a water temperature  higher than the desired temperature in the heating system in order to  perform at      
              maximum effici ency.  Example: Radiant floor heating. 
CAUTION: DO NOT INSTALL PUMP BETWEEN 
CONNECTION “A” AND HEAT SOURCE. 
The installation of the pump at  this point would result 
in  NO FLOW  through the radiation loop(s). 
5 
 

 
AM-1 SERIES Hard water conditions may result in scale deposits causing binding of internal parts in extreme cases. 

VALVE Cleaning the internal parts will usually restore the valve to proper operating conditions.  In some cases it 

MAINTENANCE may be necessary to replace the lower assembly. 

OR ELEMENT
 
REPLACEMENT 
To clean and/or replace the lower assembly, shut off water and:
 
Calibration of AM-1 Series Valves when testing a pparatus is not available. (Field Calibration) 
Model  Lower Assembly...