Home > Honeywell > Controller > Honeywell T775abm Manual

Honeywell T775abm Manual

Add to Favourites
    Download as PDF

    View the Honeywell T775abm Manual for free. All the Honeywell manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 INSTALLATION INSTRUCTIONS 62-0254-13 T775A/B/M Series 2000 Electronic Stand-Alone Controllers PRODUCT DESCRIPTION The T775 electronic stand-alone controllers are the next generation of commercial and agricultural controls capable of remote sensing of temperature and providing switched and/or proportional outputs to various types of loads. Five models have analog (modulating) outputs for actuator and motor control, and NEMA-4 weatherproof enclosures are available for wet environments. IMPORTANT...
    Page 2 T775A/B/M SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLERS 62-0254—132 Temperature Sensorsa The controller accepts 1,097 Ohms PTC at 77°F (25°C): • 50021579-001 – Standard sensor (included with all models except NEMA 4X models) • T775-SENS-STRAP– Strap on sensor with wiring box • T775-SENS-WR – Water resistant with 5 foot leads (included with NEMA 4X models) • T775-SENS-WT – Watertight with 6 foot lead • T775-SENS-OAT – Outdoor air temperature sensor • C7031B2005 – 6 inch duct mount with wiring box •...
    Page 3 T775A/B/M SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLERS 362-0254—13 BEFORE INSTALLATION Review the “SPECIFICATIONS” on page 35 before installing the controller. When Installing This Product 1.Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous condition. 2.Check ratings given in instructions and on the product to ensure the product is suitable for your application. 3.Installer must be a trained, experienced service technician. 4.After...
    Page 4 T775A/B/M SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLERS 62-0254—134 Wiring Connections Access To access the wiring connections, remove the two screws on the left side of the enclosure and gently swing open the top. Be careful to not stress the ribbon cables that connect the keypad and LCD display to the controller circuit board. Temperature Sensor Wiring CAUTIONElectrical Shock Hazard. Can short equipment circuitry. Make sure that metal tube of sensor does not short against T terminals in...
    Start reading Honeywell T775abm Manual

    Related Manuals for Honeywell T775abm Manual

    All Honeywell manuals