Honeywell thermostat ST9100A 1 Day Single Channel Time Switch User Manual

11

OPerATING YOUr ST9100A
Overriding the Operation Without Changing the Programme
In AUTO and ONCe operating modes, the OVerrIDe button switches the system ON or OFF without altering the programme. 
When the indicator lamp is ON, pressing the OVerrIDe button switches the system OFF until the next programmed ON time.
When  the  indicator  lamp  is OFF,  pressing  the OVerrIDe  button  switches  the system ON until the next programmed OFF time.
The LoT™ Display will provide you with information about the...

12

FINe TUNING YOUr ST9100A
Changing from Am/Pm Time Display to the 2 Hour Clock
Your  ST9100A  can  operate  on  the  12  hour  AM/PM  or  24  hour  clock  formats.  To change the format, ensure the slider is in the rUN position then press and hold the   and  buttons together for about 2 seconds. Ignore the ‘NOT VALID’ message that will appear briefly. All the displayed times will be automatically changed to the new format.
Repeating this procedure will change the clock display back to the...

1

FINe TUNING YOUr ST9100A
To enter Installer mode:
a. Ensure the slider is in the rUN position, then press and hold  and  buttons together for 8 seconds. Ignore the ‘NOT VALID’ message that is displayed for a few  seconds.  The  message  ‘SET  UP  MENU’  will  show  briefly,  followed  by  ‘SET INSTALLER OK ?’
b.  Press the  button to take you into the Installer Mode Parameter Menu.
c.  Parameter  1  is  now  available  to  change.  This  is  to  allow  you  to  change  the clock  format  from...

1

FAQ AND TrOUBLeSHOOTING
How  do  I  set  the  time  only,  if  the  ST9100A  clock  is  not correct?
Your ST9100A contains a very accurate digital clock that is factory pre-set. Should you ever need to change the time, just follow this procedure:
a. Move the slider to the DAY/TIme position.
b. Keep  pressing  the  green   button  until  the  message  ‘SET  THE  TIME’  is displayed.  To  change  the  time,  press  the    or   buttons  until  the  correct time is shown. The message ‘IS TIME OK?’...

1

SymptomPossible Causeremedy
ST9100A has a blank LCD displayNo power to the systemCheck that there is power to the system
Fault in ST9100ACall Installer
ST9100A indicates that the system is ON, but radiators are cold and/or taps are running with cold water.
Temperature controls are switched off or set too low
Check that the temperature controls in the system are set to appropriate levels
Boiler or other system controls have malfunctioned
Call Installer
ST9100A shows the message ‘INTERNAL FAULT’...

1 

1 

150022737-001 B
CONFIGUrATION & SerVICe DATA
Configurable FeaturesOptionsInstaller Configured (tick appropriate box)
24hr or am/pm clock displayam/pm display
24hr display
Display backlight operationOff
On if button pressed
On continuously
Automatic time changeEnabled
Disabled
Number of ON/OFFs per day2 on/offs per day
3 on/offs per day
Default programmeA = standard
b = at home
C = economy
Configuration Data (to be completed by Installer)
The  table  below  is  for  the  Installer  to  complete  to...