HP 8610 E Owners Manual

2.Insert the envelopes print-side down and load according to the  graphic.
Make sure the stack of envelopes  does not exceed the lower line marking in the tray. For more
help, refer to the diagra m engraved in the tray.
NOTE:Do not load envelopes while  the printer is printing.
3.Slide the paper-width guides in  the tray until they touch the edge of the stack of envelopes, and
then reinsert the tray.
4. Pull out the output tray extensio n until the intended paper size is reached.
Load cards and photo...

2.Insert the paper print-side down in the center of the tray.
Make sure the stack of paper is i nserted as far inside the printer as possible and does not
exceed the lower line marking in  the tray. For more help, refer to the diagram engraved in the
tray.
If the photo paper has a tab along one edge, make sure the tab  is pointing towards the front of
the printer.
NOTE: Do not load paper while the printer is printing.
3.Slide the paper-width guides in  the tray until they touch the edge of the stack of...

Load an original on the scanner glass
You can copy, scan, or fax originals by loading them on the scanner glass.
NOTE:Many of the special fe atures do not work correctly if the scann er glass and lid backing are
not clean. For more information, see 
Maintain the printer on page 34.
NOTE: Remove all originals from the document feeder tray before lifti ng the lid on the printer.
To load an original on the scanner glass
Use these steps to load an or iginal on the scanner glass.
1. Lift the scanner lid.
2....

Load an original in the document feeder
You can copy, scan, or fax a document by placing it in the docu ment feeder.
CAUTION:Do not load photos in the docume nt feeder; this might cause damage to your photos.
Use only paper that is supp orted by the document feeder.
For more information, see 
Tips for selecting and using paper on page 22.
NOTE: Scanning double-sided documents on A4, Letter-, or legal-size p aper can only be supported
by some models of the printer ADF.
NOTE: Some features, such as the...

Insert a USB flash drive
Using the USB port on the front of the printer, you can connect a USB flash drive. You can also
transfer files from the USB flash drive to your computer or sca n files to the USB flash drive from the
printer.
CAUTION: Attempting to remove a USB flash drive while it is being access ed can damage files on
the USB flash drive. You can saf ely remove a USB flash drive only when the status light is not
blinking.
NOTE: The printer does not support encrypted USB flash drives.
To connect...

Set up and use accessories
If you want to install and set up accessories (such as a second  tray and duplexer), see the following
sections.
When using more than one tray, you can make use of the tray fea tures provided to achieve a better
experience.
NOTE: You can purchase the accessories online at www.hp.com. Look for  Shop for Products and
Services .
●To install a duplexer, see Install the automatic two-sided printing accessory (duplexer)
on page 30.
● To install Tray 2, see 
Install and use second...

To load paper in Tray 2Tray 2 supports only plain paper that are not smaller than A4 o r Letter . For more information about
the capcity of the input tray, see 
Input tray capacity on page 165.
1. Pull the tray out of the printer  by grasping under the front of the tray.
2.Insert the paper print-side down in the center of the tray.
Make sure the stack of paper a ligns with the line on the paper- width guide, and does not exceed
the higher line marking in the tray.
NOTE: Tray 2 can be loaded onl y with...

NOTE:For better experience, load only one type of paper in a tray.
NOTE:Tray 2 supports only plain paper.
To achieve this Follow these steps
Have paper loaded in both trays and use paper from one tray
if the other tray is empty. ●
Load paper in both trays. For more information, see
Load paper on page 23.
● Turn off tray lock.
Have paper loaded in both trays and use paper from one of
the trays first. ●
Load paper in both trays.
● Set the desired tray as the default tray.
Be able to choose from plain paper...

To turn on automatic selection of tray or paper source (OS X)
1. From the  File menu in your software, choose  Print.
2. Make sure your printer is selected.
3. Select  Automatically Select  from the Source drop-down list.
Do the following if you do not s ee options on the Print dialog.
● OS X v10.6
: Click the blue disclosure triangle next to the Printer select ion to access the
print options.
● OS X Lion
 and Mountain Lion : Click Show Details  to access the print options.
ENWW Set up and use...

Maintain the printer
This section provides instructions for keeping the printer in top working condition. Perform these
maintenance procedures as necessary.
●
Clean the scanner glass
●
Clean the exterior
●
Clean the automatic document feeder
Clean the scanner glass
Dust or dirt on the scanner glass, scanner lid backing, or scan ner frame can slow down performance,
degrade the quality of scans, a nd affect the accuracy of specia l features such as fitting copies to
a certain page size.
To clean the...