Indesit Icd 661 S Manual

  
   
 9  
  
 
Cutlery Basket 
  
Cutlery should be placed in the cutlery basket with handles at  the bottom. If the rack has side baskets, the spoon should be  
loaded individually into the appropriate slots, especially long  utensils should be placed in the horizontal position at the front of  
the upper basket as shown.  
  For personal safety and a top quality clean, place the silverware in the basket: 
„  They do not nest together.  
„ Place silverware with handles down. 
„ But place knives and...

 
 
  
 10 
When load bigger Dinner Plates 
 
 
Plate racks of Basket 
When load bigger Dinner plates, please fold the rack 
to left picture showed location. 
The maximum plate can be loaded is 270mm 
(10 inches) diameter.  

  
   
 11 
6. Starting a washing programme 
 
Wash Cycle Table  
 NOTE:  
„  () Means: need to fill rinse into the Rinse-Aid Dispenser. 
„ *En 50242: This program is the test cycle, the rinse-aid dispenser  setting is recommended to Position 6.  
Program Cycle Selection Information Description 
of Cycle DetergentRunning 
time (min) 
Energy 
(Kwh) 
Water 
(l) 
Rinse 
Aid  
For the heaviest soiled loads,  
such as pots, pans, casserole  
dishes and dishes that have  
been sitting with dried food on  
them...

 
 
  
 12 
Change the Programme... 
 
Premise: You can modify the washing program, When the dishwasher just runs 
for a short time. Otherwise, the detergent may have already been released, and 
the appliance may have already drained the wash water. If this is the case, the 
detergent dispenser must be refilled (see the section entitled Loading the 
Detergent). 
Press Start/Pause Button more than three seconds the machine will be in stand 
by state, then you can change the program to the desired cycle...

 
 
  
 13 
7. Maintenance and Cleaning 
 
Filtering System 
 
The filter prevent larger remnants of food or other objects from getting inside the pump. 
 
Filter assembly 
The filter efficiently removes food particles from the wash water, allowing it to be re-cyclated during the cycle. For best 
performance and results, the filter assembly must be regularly. For this reason, it is a good idea to remove the larger food 
particles trapping in the filter after each wash cycle by rinsing the filter and cup...

 
 
  
 14 
Remarks: 
-  Inspect the filters for blocking every time the dishwasher has been used. 
-  By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and clean the filters under 
running water. 
 
 
NOTE: The entire filter assembly should be cleaned once a week. 
 
Cleaning The Filter 
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures in the last 
page and reinsert the entire assembly in...

 
 
  
 15 
Cleaning the Spray Arms 
The spray arms can be easily removed for periodic cleaning of 
the nozzles, to prevent possible clogging. Wash them under 
running water and carefully replace them in their seats, checking 
that their rotary movement is in no way impeded. 
Grasp the middle of the spray arm, pull it up wards to remove it. 
Wash the arms under a jet of running water and return them 
carefully to their seat. After reassembly, check that the spray 
arms turn freely. Otherwise, check that...

 
 
  
 16 
Positioning the Appliance 
 
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent 
cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to 
facilitate proper installation. 
 
About Power Connection 
 
 WARNING! For personal safety: 
„ DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.  
„ DO NOT, UNDER ANY CIRCUMSTANCES, CUT...

 
 
  
 17 
Connection of drain hoses 
 
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, 
making sure to avoid bending or crimping it. Use the special plastic support that comes with the 
appliance. The free end of the hose must be at a height lower than75cm and must not be 
immersed in water to avoid the back flow of it. 
 
 
Attention:  
The special plastic hose support must be solidly fastened to the wall to 
prevent the drain hose from moving and...

 
 
  
 18 
 
How to Drain Excess Water From Hoses 
If the sink is 1000 mm higher from the floor, the excess water in hoses cannot be drained directly into the sink. It will be 
necessary to drain excess water from hoses into a bowl or suitable container that is held outside and lower than the sink. 
Water Outlet 
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure that the water drain hose is 
not kinked or squashed. 
Extension Hose 
If you need a drain...