InFocus Projector In5312 User Manual

User’s Manual 
8.  Reverse steps 1 to 7 to 
install the new lamp 
module.  
While installing, align the 
lamp module with the 
connector and ensure it is 
level to avoid damage. 
Note:  
The lamp module must sit 
securely in place and the 
lamp connector must be 
connected properly before 
tightening the screws. 
9.  Turn on the projector and reset the lamp after the lamp module is replaced. 
Lamp Reset:  
Press Menu  → Select Installation II  / Advanced  → Select Lamp Hour Reset → Press 
the ◄►  buttons...

IN5312/IN5314 – User’s Manual 
  – 45  – 
Cleaning the Projector 
Cleaning the projector to remove dust and grime will help ensure trouble-free operation.  
Warning: 
1.  Be sure to turn off and unplug the projector at  least 60 minutes before cleaning. Failure to do so 
could result in a severe burn. 
2. Use only a dampened cloth when cleaning. Do not allow water to enter the ventilation openings 
on the projector.  
3. If a little water gets into the projector interior  while cleaning, leave unplugged...

User’s Manual 
– 46 – 
TROUBLESHOOTING 
Common Problems and Solutions 
These guidelines provide tips to deal with problem s you may encounter while using the projector. If 
the problem remains unsolved, contact InFocus at  www.infocus.com/support
. 
Often the problem is traced to something as simple as a loose connection. C heck the following before 
proceeding to problem-specific solutions. 
•   Use another electrical device to confirm that the electrical outlet is working. 
•   Ensure the projector is...

IN5312/IN5314 – User’s Manual 
  – 47  – 
LED Error Messages 
Error Code Messages PWR LED TEMP LED READY LED 
Over temperature  Off Solid Red  Off 
Thremal break  Flashing Red 4x Off Off 
Lamp strike fail  Flashing Red 5x Off Flashing Red 1x 
Ballast said Lamp off  Flashing Red 5x Off Flashing Red 2x 
Ballast said OVT when Lamp strike  Flashing Red 5x Off Flashing Red 3x 
Ballast said OVT when SYS operation   Flashing Red 5x Off Flashing Red 4x 
Fan 1 error  Flashing Red 6x Off Flashing Red 1x 
Fan 2...

User’s Manual 
– 48 – 
Problem: The image is streaked  
1. Set the Frequency  and Tracking settings on the  Computer menu of the OSD to the de-
fault settings. 
2.  To ensure the problem is not caused by a connected PC’s video card, connect to another 
computer.  
Problem: The image is flat with no contrast  
Adjust the  Contrast setting on the Image  menu of the OSD. 
Problem: The color of the projected image does not match the source imag\
e. 
Adjust the Color Temperature  and Gamma settings on the...

IN5312/IN5314 – User’s Manual 
  – 49  – 
Audio Problems 
Problem: There is no sound 
1.  Adjust the volume on the remote control.  
2.  Adjust the volume of the audio source. 
3.  Check the audio cable connection. 
4.  Disconnect audio out cable. 
5.  Test the source audio output with other speakers. 
6.  Have the projector serviced. 
Problem: The sound is distorted  
1. Check the audio cable connection. 
2.  Test the source audio output with other speakers. 
3.  Have the projector serviced. 
Having the...

User’s Manual 
– 50 – 
HDMI Q & A 
Q. What is the difference between a “Standard” HDMI cable and a “High-Speed” HDMI 
cable? 
Recently, HDMI Licensing, LLC announced that  cables would be tested as Standard or High-
Speed cables.  
˙ Standard (or “category 1”) HDMI cables have b een tested to perform at speeds of 75Mhz or 
up to 2.25Gbps, which is the equivalent of a 720p/1080i signal.  
˙ High Speed (or “category 2”) HDMI cables have been tested to perform at speeds of 340Mhz 
or up to 10.2Gbps, which...

IN5312/IN5314 – User’s Manual 
  – 51  – 
SPECIFICATIONS 
Specifications   
Model 
IN5312 IN5314 
Display type TI DMD XGA 0.7” 
TI DMD WXGA 0.65” 
Native Resolution   1024x768 1200x800 
Projection distance 
(standard lens)  1.5 meters ~ 7 meters ( 4.92 ft ~ 22.97 ft ) 
Projection screen size
 
(standard lens)  37.3 ~ 215 ( 95cm ~ 546cm ) 
34.3 ~ 200 ( 87cm ~ 508cm ) 
Projection lens  Manual Focus/Manual Zoom 
Zoom ratio
 (standard lens)  1.25 
Vertical keystone correc-
tion  +/- 30 degrees 
Projection...

User’s Manual 
Projection Distance vs. Projection Size 
For XGA 
Projection Distance
Image Height
 
Standard projection lens: TR: 1.6~2; offset=100% 
IN5312 TELE WIDE 
Distance (m/inch) 1.63/ 
64 3.25/ 
128 
4.06/ 
160  8.13/ 
320  1.63/ 
64 3.25/ 
128  6.50/ 
256  9.75/ 
384 
Diagonal (inch/ ft) 40/3.3 80/6.7 
100/8.3 200/16.7 50/4.2 100/8.3  200/16.7300/25 
Keystone  
Correction angle 
(degree) 
10.62 
10.62 10.62  10.62 13.19 13.19 13.19  13.19 
Image Height 
(mm/inch) 609.6/ 
24 1219.2/ 
48  1524.0/...

IN5312/IN5314 – User’s Manual 
  For WXGA 
Projection Distance
A
Image Height
 
Standard projection lens: TR: 1.6~2.03; offset=105% 
IN5314 TELE WIDE 
Distance (m/inch) 1.75/  
69 3.50/ 
138  4.37/ 
172 8.74/ 
344  1.74/   
68  3.49/ 
137  6.98/ 
275  10.47/ 
412 
Diagonal (inch/ ft)  40/3.3 80/6.7  100/8.3200/16.7 50/4.2 100/ 8.3 200/16.7 300/25 
Keystone  
Correction angle 
(degree)  9.61 9.61 
9.61 9.61  11.98 11.98  11.98 11.98 
Image Height 
(mm/inch)  538.5/ 
21 1077.0/ 
42  1346.2/ 
53 2692.4/...