Keurig B 30 Manual

USING YOUR BREWER
OWNER’S MANUAL: Getting the most from your new  
B30 MINI Keurig® Brewer
COMMENT UTILISER VOTRE CAFETIÈREMANUEL D’UTILISATION : Tirez le meilleur de  votre nouvelle cafetière MINI B30 de Keurig® 

3
IMPORTANT SAFEGUARDS Safe Operation & Use
When using electrical appliances, basic  safety precautions should be followed,  
including the following:
1.  
Read all instructions before using.
2.  
Do not touch hot surfaces. Use handles and 
knobs when available.
3.  
This appliance must be properly installed and 
located in accordance with these instructions 
before it is used.
4.  
The use of accessory attachments not recom-
mended by the appliance manufacturer may re-
sult in fire, electrical shock or...

3
Th IS PRODU cT IS FOR  cOMMER cIa L  aND  hOUSE hOLD USE  
To reduce the risk of injury, do not drape cord over the counter 
top or table top where it can be pulled on by children or tripped  
over unintentionally.
WARNING THIS PRODUCT CONTAINS CHEMICALS, INCLUDING 
LEAD, WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, 
BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
TABLE OF CONTENTS
KEURIG® GOURMET SINGLE CUP HOME BREWING SYSTEM
MINI  —  Model B30 
Using Your Brewer
SE cTION 1  —  SETUP &...

B30 MINI Keurig® Brewer

BREW
a
B
c
D
EF
G
I
J
a
B
c
D
E
F
G
h
J
Place Cup Indicator (Green)
Heating Indicator (Red)
BREW Button
Power Button
Drip Tray Plate
Drip Tray
Cup Sensors
PRESS TO OPEN and Insert K-Cup®
Funnel
h
I
K-Cup® Portion Pack Holder  (I and J are the K-Cup Holder Assembly)       


SECTION 1  Set-up & Operation
1.  
Plug Brewer into its own grounded 
outlet. If the electric circuit is over-
loaded with other appliances, your 
Brewer may not function properly. 
If possible, the Brewer should be 
operated on its own circuit, sepa-
rate from other appliances.
2.  Select a K-Cup® portion pack.  
Do not remove the foil lid or punc-
ture the K-Cup portion pack.
3.   Make sure the Brewer is plugged 
in. Press the Power Button found 
on the front of the Brewer.
4.  
Depress the...


5.  Place chosen K-Cup® into the  
K-Cup Assembly Housing. 
CAUTION: There are two sharp 
needles that puncture the K-Cup,  
one above the K-Cup Holder and 
the other in the bottom of the K-Cup 
Holder. To avoid risk of injury, do  
not put your fingers in the K-Cup  
Housing Assembly.6.   
Lower the Handle
 completely  
and firmly  to close the Lid 
 
and puncture the  K-Cup®  
portion pack. 
7.  
The Hot Water Tank cover will  
open automatically.
8.  
Fill the Hot Water Tank 
with filtered or...


9.  Close the Hot Water  
Tank cover. The  
“PL ACE CUP” light  
 will be flashing.
911121310
13. Enjoy!10.   Place a 10 oz coffee cup  
in the dispense area on  
the Drip Tray Plate. 
        NOTE: Do not use a clear,  glass mug. Cup  sensor will  not “read” the glass mug  and the “Place Mug” light  
will flash.
11.  
Press the flashing  
BREW Button. The  
HEATING light will  
be illuminated.
12.  When the water  
reaches temperature,  
(less than 3 minutes)  
the HEATING light 
will go off and...




cleaning External Parts
IMPORTANT: Make sure the Brewer is unplugged before cleaning
Regular cleaning of the Brewer’s external components is recommended.
1.  Never immerse the Brewer in water or other liquids. The Housing  
and other external components may be cleaned with a soapy, damp,  
non-abrasive cloth.
2.   The Drip Tray can accumulate liquids. The Drip Tray and Drip Tray Plate 
should be periodically inspected and cleaned with a damp soapy non-
abrasive lint free cloth. The Drip...




cleaning the  hot Water Tank
To access the Hot Water Tank, press the PRESS TO OPEN Button and then 
lower the handle completely, the water fill lid will pop open. Inspect the Hot 
Water Tank area and clean with a damp lint free cloth as necessary. Close 
the water fill lid when finished.
Emptying the  hot Water Tank
1.  
Ensure that the water fill lid is closed.
2.  
Place a cup on the drip plate then press and hold the BREW Button until all 
the water has been dispensed. Note, there will...

SECTION 2De-Scaling Your Brewer (continued)
Step 6:  Fill the Hot Water Tank with   ounces of bottled water, close the water 
fill lid, place a cup on the Drip Tray Plate and perform a brew.
Step 7:  
Repeat Step   three times using bottled water (with no K-Cup in place) 
to cleanse the Brewer plumbing and get rid of any residual taste from 
the vinegar. The Brewer is now ready for normal use again.
Service
Beyond these recommended cleaning and maintenance procedures this 
Brewer is not user...