Lucent Technologies CentreVu Call Management System Release 3 Version 8 Guide

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
How to upgrade an Enterprise platform to disk mirroring25
Step 10: Verify disk 
space
2
1. Display available disk space by entering a df -k
 command. The 
system responds with a file system table. For example:
The figures on the 
/dev/md/dsk/d21 line are critical. You will use 
them to determine whether 
Solstice DiskSuite* is administering all 
your disks.
2. Complete the table below by filling in (1a) and (1b) as...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
How to upgrade an Enterprise platform to disk mirroring26
If the stripes of d19 and d20 do not account for all the disk drives on your 
system, check your disk drive connections. If discrepancies persist, 
telephone the Lucent National Customer Care Center at 1.800.242.2121, 
or contact your Lucent representative or distributor.
Step 11: Create an 
alternate boot 
device
2
Set up an alternate boot device by doing the...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
How to upgrade an Enterprise platform to disk mirroring27
3. Reboot the system with the following command:
The system displays the ok 
prompt.
4. Create a device alias for the new boot device by entering the 
following command (for example):
Replace 
 with what you recorded in item 2. For the 
example shown, you would replace 
 with the following:
/sbus@3,0/SUNW,fas@3,8800000/sd@2,0
5. Test the alternate boot device...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring28
Factory installation procedures for disk mirroring2
This section describes how a mirrored system is installed on a new Sun 
Enterprise
 3xxx computer in the factory. You may use these instructions 
in the field to bring an existing system up to factory specifications. 
Step 1: Install the 
hardware
2
Install hardware components as required. For details and...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring29
.
Step 3: Install the 
application 
software
2
Install application software as instructed in the CentreVu CMS R3V8 
Software Installation and Setup 
(585-210-941) document. That will mean 
installing the following packages in order:
lCommon Desktop Environment (CDE)
lSunLink* HSI/S drivers (if using HSI/S ports)
lNTS drivers (if using NTS ports)
lX.25 (if using X.25...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring30
Step 4: Check the 
disk.type file2
The olds
 commands, which you will be using to configure the Solstice 
DiskSuite 
software, obtain information about your disk configuration from 
the 
/olds/disk.type file. If your boot disks are not as specified in the Disks 
table in Step 2, check the 
disk.type file to verify that it names the proper 
boot disks for your system....

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring31
5. Check the disks:
6. Create system files for the 
Solstice DiskSuite software:
7. Make sure all the disk drives on your system have been recognized. 
To do that, read the file 
/olds/md.tab.new into an editor and locate 
the 
#/cms section. It should reflect the precise number of disk drives 
on your system. The following example shows a total of four disk 
drives...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring32
Step 6: Run the 
setup scripts
2
1. Create the state database replicas by entering the following 
command:
2. Mirror the root file system by entering the following command:
3.Check disks with “metastat
” and wait until all disks are synched.
Ignore any FSCK error messages which may be 
generated.
4. Reboot and log in as the root user (boot -r)
: # olds -mirrored...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring33
5. Setup the /cms metadevices by entering the following commands:
6. Create and mount the 
/cms file system by entering the following 
commands:
Step 7: Verify disk 
space
2
1. Display available disk space by entering a df -k
 command. The 
system responds with a file system table. For example:
The figures on the 
/dev/md/dsk/d21 line are critical. You will use 
them...

  Installing Mirrored Systems  CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring34
2. Complete the table below by filling in (1a) and (1b) as instructed.
3. Compare the figures in (1a) and (1b). They should be 
approximately 
equal. The two will not correspond exactly, but they should be within 
about 10% of the /cms size figure. A major discrepancy between the 
disk space you should have and the space recognized by the 
software usually indicates a...