Miele F 5122 Ui Operating And Installation Instructions

In normal use, ice and frost will form on
the evaporator plates. If allowed to
accumulate, this will impair the
efficiency of the freezer and increase
the consumption of electricity.
Do not scrape ice and frost off the
evaporator plates as this can
damage them and render the
appliance unusable.
The freezer should be defrosted from
time to time. It must be defrosted if a
layer of ice approx. 0.5 cm thick has
accumulated. It is best to defrost when
only very little food or no food at all is
left in the...

Do not use defrosting sprays or
de-icers, as they could contain
substances which may damage the
plastic parts and which may cause a
build-up of gases and pose a
danger to health.
After defrosting
Take the bottom drawer out of the
appliance and empty it.
Use a sponge or towel to soak up
any water from defrosting still in the
appliance.
Clean the appliance, and then dry it
thoroughly.
Plug the appliance in again, and
switch on using the On/Off button.
The indicator light will come on.
Switch on the...

A range of Miele branded cleaning
and conditioning products is
available to order from Miele or
www.miele-shop.com.
Make sure that water cannot get into
the electronics.
Never use steam cleaning
apparatus to clean the appliance.
Steam could reach the electrical
components and cause a short
circuit.
The data plate located inside the
appliance must not be removed.
It contains information which is
required in the event of a service call.
To avoid damaging the surface of
your appliance, do not use:
–...

Door seal
Do not use any oils or grease on the
door seal as these will cause the
seal to deteriorate and become
porous over time.
The door seal should be cleaned
regularly with clean water and then
wiped dry with a soft cloth.
After cleaning
Close the appliance door.
Reconnect to the mains and switch
the appliance on using the On/Off
button.
The indicator light will come on.
Switch on the Super freeze function
so that the freezer can cool down
quickly.
The indicator light will come on.
Once the...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure that current is not supplied to
the appliance until after
maintenance or repair work has
been carried out.
What to do if...
. . . the appliance does not get cool.
Make sure that the temperature...

. . . the On/Off button indicator light
is not on.
Check if the Super freeze indicator
light comes on when you press the
Super freeze button.
If it does, then the indicator light for
the On/Off button is defective.
Call the Service Department.
If the Super freeze indicator light
does not come on either, then check
whether
- the plug is correctly inserted in the
socket.
- the mains fuse has tripped. If it has
there is a fault. Call the Service
Department.
. . . the Super freeze indicator light
does not...

Normal noises What causes them
Brrrrr...Humming noise made by the motor (compressor). This noise can
get louder for brief periods when the motor is switching on.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds are made when the thermostat switches the
motor on and off.
Sssrrrrr....On multi-zone and frost-free appliances you can sometimes just
hear the movement of air circulating inside the appliance.
Creak ...Creaking sounds can be...

In the event of a fault which you cannot
correct yourself, or if the appliance is
under guarantee, please contact:
–your Miele Dealer
or
–Miele (see back cover for contact
details).
Please note that telephone calls may
be monitored and recorded for
training purposes (UK only).
When contacting your Dealer or the
Miele Customer Contact Centre, please
quote the model and serial number of
your machine. This information is given
on the data plate.
Guarantee
Please see the guarantee card
supplied.
In the U.K....

The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220 – 240 V 50 Hz supply. Connection
should be made via a fused plug and
suitable switched socket which is easily
accessible after installation.
For extra safety it is advisable to install
a suitable residual current device
(RCD).
Connection should be made via a fused
plug and suitable switched socket
which is easily accessible. Do not
connect the appliance to the mains
electricity supply by an...

This appliance must be built in,
otherwise it could tip up.
Location
This appliance should be installed in a
dry, well-ventilated room. It should not
be installed where it is exposed to
direct sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator. The room
temperature should not go above or
below the climate range for which the
appliance is designed. The higher the
ambient temperature of the room, the
more energy the appliance requires to
operate.
Important: tropical /...