Miele G 1202 Sci Operating Instructions

Check your dishwasher regularly
(approx. every4-6months). This
way faults and problems can be
avoided.
Miele branded cleaning and
conditioning products are available
from the Miele Spare Parts
Department or via the Internet at
www.miele-shop.com.
,The external surfaces of the
dishwasher are susceptible to
scratching.
Contact with unsuitable cleaning
agents can alter or discolour the
outer surfaces.
Cleaning the wash cabinet
The wash cabinet is largely
self-cleaning, provided that the correct
amount of...

Cleaning the filters in the wash
cabinet
The filter combination in the base of the
wash cabinet retains coarse soil from
the suds solution, preventing it
accessing the circulation system and
re-entering the cabinet through the
spray arms.
,The dishwasher must not be
used without all the filters in place.
Collection of coarse soil may cause the
filters to clog. The level of soiling and
time it takes before the filters need
cleaning will vary depending on use.
Check the condition of the filters
regularly...

To clean the inside of the filter, the flap
must be opened:
^Press catchesatogether in the
direction of the arrows as shown,
and open the filterb.
^Rinse all the filters under running
water.
^Then close the flap so that the catch
engages.^Replace the filter combination so that
it lies flat in the base of the wash
cabinet.
^Then turn the handle clockwise, until
the arrows line up, to lock the filter
combination in place.
,Take care when you are fitting
the filter combination that it is
secured in position...

Cleaning the spray arms
Particles of food can get stuck in the
spray arm jets and bearings. The spray
arms should therefore be inspected
and cleaned regularly (approx. every
4 - 6 months).
^Switch the dishwasher off.
Remove the spray arms as follows:
^Take out the cutlery tray (if your
dishwasher is fitted with one).
^Push thetopspray arm upwards to
engage the inner ratchet. Then
unscrew the spray arm.
^
Push themiddlespray arms upwards
ato engage the ratchet. Then
unscrew the spray armb.^Remove the...

With the aid of the following guide, faults in the performance of the appliance,
some of which may result from incorrect operation can be put right without
contacting the Miele Service Department.
,Repairs should only be carried out by a suitably qualified and trained
person in strict accordance with current local and national safety regulations.
Unauthorised or incorrect repairs could cause personal injury or damage to the
appliance.
Technical problems
Problem Possible cause Remedy
The Start/Stop...

Problem Possible cause Remedy
The Wash/Rinse,
Drying and End
indicator lights flash
simultaneously.
Fault code FXX shows
in the display.There may be a
technical fault.–Clean the water inlet filter
and clean the drain pump
and non-return flap as
described in Maintenance.
If this does not resolve the
problem:
–switch the dishwasher off
with the On/Off buttonK.
After a few seconds:
–Switch the dishwasher back
on.
–Select the programme
required with the
programme selector button.
– Press the Start/Stop...

The dishwasher does not fill/drain.
Problem Possible cause Remedy
The Inlet/Drain
check indicator
flashes.The stopcock is
closed.Open the stopcock fully.
The dishwasher
stops during a
programme.
The Inlet/Drain
check indicator
flashes.
Fault code FXX
shows in the
display.Before rectifying the problem
you must:
–Switch the dishwasher off with
the On/Off buttonK.
Fault F12/F13:
Water inlet restricted.–Open the stopcock fully.
–Clean the water inlet filter (see
Maintenance).
– The water pressure at the...

General problems
Problem Possible cause Remedy
The display is dark.The time display switches
off automatically in
Standby Mode to save
energy.Press any button to come
out of Standby mode.
Detergent residue is left
in the dispenser at the
end of a programme.The dispenser was still
damp when detergent was
added.Make sure the dispenser
is dry before adding
detergent.
The detergent
dispenser lid cannot be
closed properly.Clogged detergent
residue is blocking the
catch.Clean the detergent from
the catch.
At...

Noises
Problem Possible cause Remedy
Knocking noise in the
wash cabinet.A spray arm is knocking
against an item in a
basket.Interrupt the programme,
and rearrange the items
which are obstructing the
spray arm.
Rattling noise in the
wash cabinet.Items of crockery are
insecure in the wash
cabinet.Interrupt the programme,
and rearrange the items of
crockery.
Knocking noise in the
water pipes.This may be caused by
the on-site installation or
the cross-section of the
piping.This has no influence on
dishwasher...

Unsatisfactory washing result
Problem Possible cause Remedy
The dishes are not
clean.The dishes were not loaded
correctly.See notes in Loading the
dishwasher
The programme was not
powerful enough.Select a more intensive
programme. See
Programme chart.
There is some stubborn
soiling although most of the
crockery is only lightly soiled
(e.g. with tea stains).Use the Adjust Sensor
wash function (see
Additional functions).
Not enough detergent was
dispensed.Use more detergent, or
change your detergent.
Items...