Netgear A6100 Ac600 Dual Band Wifi Usb Mini Adapter User Manual

							Troubleshooting and Frequently Asked Questions31
 A6100 WiFi USB Mini Adapter
Frequently Asked Questions
Do USB ports go into a sleep mode if no traffic is going to or from the \
port?
USB devices go into sleep mode if a USB feature called Selective Suspend\
 is enabled, which 
it is by default. If a USB device goes into Selective Suspend mode, the \
network disconnects. 
T

o prevent this type of network disconnection, disable Selective Suspend.\
 
To disable Selective Suspend mode:
1. Select  Start > Control Panel > Hardware and Sound > Power Options > Edit Plan 
Settings > Change 
 Advanced Power Settings > USB Settings .
2. Change the setting for Selective Suspend mode to  Disabled.
How can I improve the speed of my wireless connection?
The connection speed can vary depending on the type of USB port on your \
computer, the  capacity of the router or access point for the wireless network, and the\
 type of Internet 
connection. 

You can view the physical rate in the status bar at the bottom of the NET\
GEAR 
genie screen:
• If the physical rate is 54 Mbps, you might be connected to an 802.1
 1g network, or the 
wireless-N network might be set with WPA (TKIP) security.
When WPA (TKIP) security mode is configured on the router or access point, Wi\
Fi 
regulations allow the mini adapter to connect at up to 54 Mbps only
 . For a faster 
connection, configure the security for the router or access point as WPA2 or 
WPA  +  WPA2 mixed wireless security. The connection speed still depends on the 
wireless capacity of the router or access point.
• If you do not have a USB 2.0 port on your computer
 , the physical rate is limited to the 
14
  Mbps of the older USB 1.1 standard.
How can I view the IP address for the mini adapter?
Click the 
 icon to open NETGEAR genie and click the  Other button to view the IP 
address. 
						

							32
A
A.   Factory Default Settings and 
Technical Specifications
This appendix covers the following topics:
•Factory Default Settings
•Technical Specifications  
						

							Factory Default Settings and Technical Specifications33
A6100 WiFi USB Mini Adapter
Factory Default Settings
The following table lists the default settings of your mini adapter.
Table 1.  Factory Default Settings
Default Settings
Wireless communication
Enabled
Country/region United States (varies by region)
Operating mode 802.11ac draft 2.0, 802.11n, 802.11a, 802.11g, or 802.11b
Data rate • Up to 433 Mbps with a router or access point that supports 802.11ac
• Up to 150 Mbps with a router or access point that supports 802.11n 
						

							Factory Default Settings and Technical Specifications34
A6100 WiFi USB Mini Adapter
Technical Specifications
The following table provides technical specifications for the mini adapt\
er. 
Table 2.  Technical Specifications
FeatureDescription
Antenna 1 PIFA antenna
Standards  • 802.11ac draft 2.0
• 802.11n
• 802.11g
• 802.11b
• 802.11a
Radio data rate Autosensing
Frequency • 2.4 GHz to 2.5 GHz CCK and OFDM Modulation
• 5 GHz OFDM, 802.11n MCS0-7, and 802.11ac MCS0-9 coding scheme
Encryption • WPA2-PSK [AES]
• WPA-PSK [TKIP]
• 40-bit (also called 64-bit) WEP data encryption
• 128-bit WEP data encryption
Power  5V bus powered
Bus interface USB 3.0, USB 2.0, compatible with USB 1.1
Provided drivers • Microsoft Windows 8
• Microsoft Windows 7
• Microsoft Vista
• Microsoft Windows XP (32/64-bit)
Dimensions 37 x 20 x 8.1 mm (1.46 x 0.79 x.0.32 in.)
Weight 5 g (0.18 oz)
Operating temperature 0–40C (32–104F)
Emissions FCC, CE 
						

							35
B
B.   Notification of Compliance
Regulatory Compliance Information
This section includes user requirements for operating this product in ac\
cordance with National laws for usage of radio spectrum and operation of radio devices. Failure of the end-user to comp\
ly with the applicable requirements may 
result in unlawful operation and adverse action against the end-user by \
the applicable National regulatory authority.
This product’s firmware limits operation to only the channels allowed in a particular\
 Region or Country. Therefore, all  options described in this users guide may not be available in your vers\
ion of the product.
Europe – EU Declaration of Conformity 
Products bearing themarking comply with the following EU directives:
•   Directive 2004/108/EC
•   Low V

oltage Directive 2006/95/EC
If this product has telecommunications functionality, it also complies with the requirements of the following EU 
Directive:
•   R&TTE Directive 1999/5/EC
Compliance with these directives implies conformity to harmonized Europe\
an standards that are noted in the EU 
Declaration of Conformity
 . 
For indoor use only. Valid in all EU member states, EFTA states, and Switzerland.
This device may not be used for setting up outdoor radio links in France\
 and in some areas the RF output power may  be limited to 10 mW EIRP in the frequency range of 2454 - 2483.5 MHz. Fo\
r detailed information the end-user should 
contact the national spectrum authority in France.
FCC Requirements for Operation in the United States
FCC Information to User
This product does not contain any user serviceable components and is to \
be used with approved antennas only. 
Any product changes or modifications will invalidate all applicable regu\
latory certifications and approvals
Devices operating within the frequency range of 5.15–5.25GHz are for \
indoor use only.
FCC RF Radiation Exposure and SAR Statements
SAR Statement
This product has been tested for body-worn Specific Absorption Rate (SAR) compliance. The FCC has established detailed SAR requirements and has established that these requirements ha\
ve been met while the product was 
installed in a host notebook computer. The SAR limit set by the FCC is 1.6 W/kg.
RF Exposure Information
The radio module has been evaluated under FCC Bulletin OET 65C (01-01)\
 and found to be compliant to the requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (\
4) addressing RF Exposure from radio  
						

							Notification of Compliance
36 A6100 WiFi USB Mini Adapter
frequency devices. This model meets the applicable government requirements for exposure to radio frequency 
waves. The highest SAR level measured for this device was 1.17 W/kg.
This product complies with the US / Canada portable RF exposure limit set forth for an uncontrolled environment 
and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved 
if the product can be kept as far as possible from the user body or set the device to lower output power if such 
function is available.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
SAR compliance has been established in typical laptop computer(s) with USB slot, and product could be used in 
typical laptop computer with USB slot. Other application like handheld PC or similar device has not been verified 
and may not compliance with related RF exposure rule and such use shall be prohibited.
The USB dongle transmitter is approved for use in typical laptop computers. To comply with FCC RF exposure 
requirements, it should not be used in other devices or certain laptop and tablet computer configurations where the 
USB connectors on the host computer are unable to provide or ensure the necessary operating configurations 
intended for the device and its users or bystanders to satisfy RF exposure compliance requirements.   
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, 
all WiFi product marketed in US must fixed to US operation channels only.
FCC Declaration of Conformity
We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the 
A6100 WiFi USB Mini Adapter complies with Part 15 Subpart B of FCC CFR47 Rules. 
Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Warnings and Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following methods:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is 
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (A6100 WiFi USB Mini Adapter) does not exceed the Class B limits for radio-noise emissions 
from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of 
Communications.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two 
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. 
Lexploitation est autorisée aux deux conditions suivantes: (1) lappareil ne doit pas produire de brouillage, et (2) 
lutilisateur de lappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible den 
compromettre le fonctionnement. 
						

							Notification of Compliance
37 A6100 WiFi USB Mini Adapter
Caution:
(i) The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful 
interference to co-channel mobile satellite systems;
(ii) The maximum antenna gain permitted for devices in the bands 5250–5350 MHz and 5470-5725 MHz shall comply 
with the e.i.r.p. limit.
(iii) The maximum antenna gain permitted for devices in the band 5725–5825 MHz shall comply with the e.i.r.p. limits 
specified for point-to-point and non point-to-point operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the 
bands 5250–5350 MHz and 5650–5850 MHz and that these radars could cause interference and/or damage to 
LE-LAN devices.
Advertissement
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions 
susmentionnées, notamment :
(i) Les dispositifs fonctionnant dans la bande 5150–5250 MHz sont réservés uniquement pour une utilisation à 
l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes 
canaux;
(ii) Le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5250–5350 MHz et 5470–5725 MHz doit 
se conformer à la limite de p.i.r.e.;
(iii) Le gain maximal d’antenne permis (pour les dispositifs utilisant la bande 5725–5825 MHz) doit se conformer à la 
limite de p.i.r.e. spécifiée pour l’exploitation point à point et non point à point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont 
désignés utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les bandes 5250–5350 MHz et 5650–5850 MHz et 
que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
Radiation Exposure Statement
The product complies with the Canada portable RF exposure limit set forth for an uncontrolled environment and are 
safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the 
product can be kept as far as possible from the user body or set the device to lower output power if such function is 
available.
Déclaration dexposition aux radiations:
Le produit est conforme aux limites dexposition pour les appareils portables RF pour les Etats-Unis et le Canada 
établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux expositions RF peut être 
augmentée si lappareil peut être conservé aussi loin que possible du corps de lutilisateur ou que le dispositif est réglé 
sur la puissance de sortie la plus faible si une telle fonction est disponible.
Warning for Installations in Japan
It is established by Radio Law that 5GHz transmitters are allowed to be used only indoors.
7Á
						

							Notification of Compliance38
A6100 WiFi USB Mini Adapter
Interference Reduction Table
The following table shows the recommended minimum distance between NETGE\
AR equipment and household 
appliances to reduce interference (in feet and meters).
Household ApplianceRecommended Minimum Distance
(in feet and meters) 
Microwave ovens 30 feet / 9 meters
Baby Monitor - Analog 20 feet / 6 meters
Baby Monitor - Digital 40 feet / 12 meters
Cordless phone - Analog 20 feet / 6 meters
Cordless phone - Digital 30 feet / 9 meters
Bluetooth devices 20 feet / 6 meters
ZigBee 20 feet / 6 meters