Nitsuko Ds1000 Hardware Manual

1. Installation
Basics
1-9
INSTALLING THE BATTERY AND EXPANSION BOARD
Removing the Top Panel (Figure 1-5)
You must remove the top panel in order to install the system
battery and Expansion Board.
In the event of commercial AC power failure, the battery pro-
vides short-term backup of system memory and the system time
and date (Real Time Clock). The battery will hold memory and
time and date for up to 10-14 days.
The Expansion Board provides an additional 3 analog trunks, 8
digital extensions, 4 analog...

1-10
Installing the Battery (Figure 1-6)

To install the battery:
1. Insert the battery into the battery clips as shown at right.
2. Replace and resecure the top panel.
OR
Go to page 1-12 and install the Expansion Board.
Figure 1-6  INSTALLING THE BATTERY
Battery
80200 -27
INSTALLING THE BATTERY AND EXPANSION BOARD 

1. Installation
Basics
1-11
Replacing the Battery

To replace an existing battery:
You should only need to replace your battery if it fails
to hold a charge (i.e., no longer backs up memory and
the Real Time Clock).
1. Do not power down the system.
If you power down the system and remove the battery,
programmed data and the Real Time Clock will reset
to the factory-installed default settings.
2. Following Figure 1-6, gently push down on the battery and
remove it.
3. Replace the battery with a Sony CR2032...

1-12
Installing the Expansion Board (Figure 1-7)

To install the Expansion Board:
1. Be sure your system’s power cord is unplugged.
The Expansion Board is not hot-swappable.
2. Plug in the Expansion Board as shown at right.
Be sure to snap the Expansion Board into the plastic
standoffs that are supplied with the Expansion Board.
3. Replace and resecure the top panel.
Figure 1-7  INSTALLING THE EXPANSION BOARD
80200 - 32
INSTALLING THE BATTERY AND EXPANSION BOARD 

2. Extension and
Trunk Cabling
2-1
Section 2, EXTENSION AND TRUNK CABLING
In this section . . .
Page
Before You Start Cabling  . . . . . . . . . . . . . .2-3
Reviewing the Installation Method . . . . . . . . . 2-3
The Extension Block  . . . . . . . . . . . . . . . . . .2-4
Installing the Extension Block . . . . . . . . . . . . 2-4
Trunk and AUX Mod Jacks  . . . . . . . . . . . .2-8
Installing Trunk and AUX Mod Jacks . . . . . . . 2-8
!! Important !!
Install telephones connected to the Main Equipment...

2-2
— For Your Notes — 

2. Extension and
Trunk Cabling
2-3
BEFORE YOU START CABLING
Reviewing the Installation Method
Your system uses a different installation method for extensions
and trunk/AUX connections:
Extension Blocks
The system uses a 66M1-50 extension block and a second
66M1-50 cross connect block for connecting extensions.
See The Extension Blockon page 2-4 and the illustration on
page 2-5.
Trunk/AUX Mod Jacks
You’ll use up to 6 mod jacks for the trunk/AUX connections.
Turn to Trunk and AUX Mod Jackson page 2-8 for...

THE EXTENSION BLOCK
2-4
Installing The Extension Block(Figures 2-1
through 2-3).

To connect to the extension block:
1. Arrange your extension and extension cross-connect blocks
according to the illustration below.
2. Following Figure 2-2 on page 2-6, punch down a standard
25-pair cable on the extension block.
The cable should have a female amphenol 50-pin con-
nector on one end and be terminated on the other. 

2. Extension and
Trunk Cabling
THE EXTENSION BLOCK
Cross
Connect
Block 6-Conductor
RJ-11X Plugs
25 Pair
CableExtension
Block
80200 - 8
PTF/MD AUDIO
DOOR1
CO 1-3
X10
RS 232CO 4-6 DOOR2
AC
Outlet
4- or 6-Conductor
Line CordX10
TW 523
Power Line Interface
(Future)Trunk/AUX
Jacks
CO 4-6DOOR
BOX 2PFT
MDM
RS-232
CO 1-3 AUDIO
DOOR
BOX 1
2-5 Figure 2-1  INSTALLATION LAYOUT
!!  Warning  !!
Do not plug in the 25-pair extension
cable with power applied. 

THE EXTENSION BLOCK
2-62-6
n
l-
WHT-BLU
BLU-WHT
WHT-ORN
ORN-WHT
WHT-GRN
GRN-WHT
WHT-BRN
BRN-WHT
WHT-SLT
SLT-WHT
RED-BLU
BLU-RED
RED-ORN
ORN-RED
RED-GRN
GRN-RED
RED-BRN
BRN-RED
RED-SLT
SLT-RED
BLK-BLU
BLU-BLK
BLK-ORN
ORN-BLK
BLK-GRN
GRN-BLK
BLK-BRN
BRN-BLK
BLK-SLT
SLT-BLK
YEL-BLU
BLU-YEL
YEL-ORN
ORN-YEL
YEL-GRN
GRN-YEL
YEL-BRN
BRN-YEL
YEL-SLT
SLT-YEL
VIO-BLU
BLU-VIO
VIO-ORN
ORN-VIO
VIO-GRN
GRN-VIO
VIO-BRN
BRN-VIO
VIO-SLT
SLT-VIO 1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28...