Panasonic Digital Video Cassette Recorder AG DV1000P Operating Instructions

11
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaOperations Display Symbols
1Insert a video cassette with the closed record (“REC” side) prevention tab (page 8).
ÁIf it has already been inserted, press POWER to turn the VTR on.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
2Set INPUT SELECT on this unit so that DV, S-VIDEO or LINE (VIDEO IN).
ÁOnly DV Indicator will appear.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
3Press REC to start recording....

12
The VTR indications shown on the monitor screen are
known as the On Screen Display (OSD).
This VTR allows many settings to be made at the OSD.
Preparation
ÁTurn on the VTR and monitor.
Settings Using the On Screen Display
To use the On Screen Display:
OSD Mode
Use the SUPER switch to perform the OSD settings.
Set the OSD displays on the monitor screen which is
connected to OUTPUT1 or 2.
The OSD displays simultaneously appear or do not appear
at OUTPUT1 and 2.
AUTO: The On Screen Display will appear on...

13
3Select OFF or S1 using | or {, and then press SET.
OFF: Normal mode.
S1: When the S-Video input socket on the monitor
that is connected is an S1-Video socket.
(If a wide mode video signal is sent to the
monitor, the monitor screen size will
automatically switch to wide mode.)
4Press EXIT to exit the On Screen Display.
INPUT TBC Mode
1Press MENU, and select OPTION SETUP1 using Y or
Z, and then press SET.
2Select INPUT TBC using Y or Z, and then press SET.
3Select ON or OFF using | or {, and then press...

14
3D Y/C Mode
1Press MENU and select OPTION SETUP2 using Y or
Z, and then press SET.
2Select 3D Y/C MODE using Y or Z, and then press
SET.
3Select OFF or ON using | or {, and then press SET.
OFF: To reduce ghosting that occurs when playing
back or recording a fast-moving video.
ON: To record with high quality.
4Press EXIT to exit the On Screen Display.
3D NR Mode
1Press MENU and select OPTION SETUP2 using Y or
Z, and then press SET.
2Select 3D NR MODE using Y or Z, and then press
SET.
3Select OFF,...

15
Audio Displays on Unit’s Display Area
Audio Monitor Display
ST1 display:
This lights when STEREO1 was selected while playback
was underway.
ST2 display:
This lights when STEREO2 was selected while playback
was underway.
When STEREO1i2 (MIX) audio is selected, STEREO2
appears on the display.
Audio Recording Data Display
16bit display:
This lights while a tape containing a 16-bit audio recording
is being played back.
ST1 display:
This lights while a tape containing a 12-bit audio recording
is being...

16
TAPE SPEED
1Press MENU and select OPTION SETUP2 using W or
X, and then press SET.
2Select TAPE SPEED using W or X, and then press
SET.
3Select SP or LP using O or N, and then press SET.
SP: This is the position that is normally used.
LP: In this mode, the duration is 1.5 times longer than
the SP mode.
4Press EXIT to exit the On Screen Display.
Note:
When a tape recorded in the LP mode is used, noise may
be generated in the form of mosaic patterns or other
problems may occur so that normal playback of...

17
[Please insert video tape.]
ÔREC, PLAY (1), FF (5), REW (6) or PAUSE
(;) is pressed when no cassette is in the VTR.
Insert a video cassette.
[LOW RF]
ÔAre the video heads dirty?
Clean the video heads using the accessory Digital
Video Head Cleaner.
Before Requesting Service
Before requesting service, check the following points once again.[Recording not allowed. Check setting of the record-
prevention tab.]
ÔHave you pressed REC while using a cassette tape
whose accidental erasure prevention tab has...

18
Please read these precautions before operating this VTR.
Avoid Sudden Changes in Temperature
If the VTR is suddenly moved from a cold place to a warm
place, condensation may form on the tape and inside the
VTR. In this case, the “8”  dew indicator will flash on and off
and the VTR will not operate.
Dew May Form in the VTR if:
³The VTR is in a room where the heater has just been
turned on.
³The VTR is in a room with steam or high humidity.
³The VTR is brought from cold surroundings into a heated
room....

19
Specifications
Recording System:Digital Video SD Format
Audio Recording System:PCM Digital Recording; 16 bit (48 kHz/2ch), 12 bit (32 kHz/4ch)
Tape Speed:SP; 18.812 mm/sec.
LP; 12.555 mm/sec.
Tape Format:Mini DV tape
Record/Playback Time:Max. 120 min. with DVM80 and in the LP mode
SP; 60 min. LP; 90 min. with DVM60 tape
FF/REW Time:approx.  80 sec. with DVM60 tape
VIDEO
Television System:EIA Standard (525 lines, 60 fields), NTSC color signal
Video Recording System:Digital Component
Input Level:VIDEO...

PANASONIC BROADCAST & TELEVISION SYSTEMS COMPANY
DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA
Executive Office:
3330 Cahuenga Blvd W., Los Angeles, CA 90068 (323) 436-3500
EASTERN ZONE:
One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621
Southeast Region:
1225 Northbrook Parkway, Ste 1-160, Suwanee, GA 30024 (770) 338-6835
Central Region:
1707 N Randall Road E1-C-1, Elgin, IL 60123 (847) 468-5200
WESTERN ZONE:
3330 Cahuenga Blvd W., Los Angeles, CA 90068 (323) 436-3500
Government...