Panasonic Household Massage Lounger Ep30003 Operating Instructions

 10

Confirm that the main unit and the accessories are in the box.
Main unit
Accessories
• Armrests (Right/Left)
Left/Right indication
Small holes on the inside fabric are an intentional 
part of the functional design.
• Pillow• Control Panel Stand
Fixing screw
Control panel 
holder
Clip
• Control Panel Stand Covers
•  Attachment Screws (M6 × 16) — 7
• Allen Key — 1
(Cross-section)
0.2" 
(4 mm)
• Sole Reflexology Plates
This is installed on the sole 
massage section prior to leaving 
the factory....

11

1Attaching the 
armrests
 (On both the right and left 
sides)
1. Insert the armrest into the 
unit.
Be careful to avoid pinching 
your fingers.
•
Assembly
2.  Fasten the armrest with the 
attachment screws.
Set the two attachment 
screws in place by hand 
first and then tighten 
firmly with the allen key.
Use this Screw
Attachment Screw (M6 × 
16)
 × 4
(Black × 2, Silver × 2)
Make sure that the seat 
surface is not damaged.
GrooveArmrest
(1)   Align the 
positionMain unit
Pipe
Right/Left 
indication...

 12

2Attaching the control panel stand to the right or left side panel of the unit
(Diagram shows attachment to right armrest.)
The position of the control panel when seated can be 
selected by choosing the appropriate hole for the screw.
NearApprox.  
20˚
Far
3Attaching the control panel stand covers
(On both the right and left sides)
The method for attaching the covers is the same for both sides. 
The diagram shows the side where the control panel stand is 
attached.
1. Insert the top tabs on the...

13

When removing the control panel stand cover
1. Insert the head of a flat-tip screwdriver in the gap 
under the mark (O).
2.  Push the bottom tab of the cover up to lift the cover.
3.  Perform the same procedures as 1 and 2 above for 
the other gap.
4.  Pull the cover up diagonally.
Performing this procedure with the allen key or a 
Phillips screwdriver could damage the unit.
•
4Raising the backrest to the 
upright position
1.  Insert the power plug into the power outlet.
2.  Confirm the key lock is...

 14

Moving the control panel cord to the left side (when control panel stand is on left 
side)
1. Press the  button on the control panel to turn on the power.
2.  Press the 
 button on the control panel and hold until the legrest 
has risen far as it will go.
Continue pressing until a “beep-beep-beep” sound is heard.
3.  Remove the control panel cord from the cord-holder groove.
4.  Move the control panel cord under the legrest to the left side.
5.  Fasten the control panel cord at two points in the...

15

6Attaching the pillow
1. Attach the pillow to the velcro fastener.
See page 34 for a guide to the position of the pillow
Pillow
Velcro 
fasteners
•
2.
 Fasten the control panel cord using the clip.
Clip
Control panel cord
Fasten the cord so that the 
portion under the clip is 
not slack.
Lift the control panel to remove.

EP30003.indb   152007/07/19   13:05:09 

 16

Before sitting down
Check the following before using the unit
1Check the surrounding area
Make sure there are no objects, people, or pets in the vicinity of the unit.
2Check the power cord and the power plug
Warning
Remove dust from the power plug periodically. 
Failure to observe this precaution may result in 
defective insulation of the cord due to moisture. 
Clean dust from the cord using a dry cloth.
Do not damage the power cord and the power 
plug. 
(Do not damage, expose to heat sources,...

17
3. Make sure the massage heads are in the retracted position.
Caution
Sit on the unit after confirming the massage 
heads are in the retracted position. 
Failure to observe this precaution may result in 
accident or injury.
•
When the massage heads are not in the retracted position
Press the  button twice to return the massage heads to the 
retracted position.
4.  Make sure the legrest is in the fully lowered position.
Caution
Do not stand on the legrest or place any object on 
it when the legrest is...

 18
Program Massages
Pre-Program Quick Massage
1Press the  button to turn on the power.
The power will turn off automatically if the massage does not start within 3 minutes after turning on the power.
2Press one of the flashing buttons () to select the 
program.
Pre-Program and Quick Massage Characteristics (Upper Body)
See page 20 for an overview of the respective programs.•
SHIATSU: Uses mainly shiatsu massage to loosen 
up deep-seated knots of tension. Recommended 
for those with severe stiffness and...

19

2. Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the shoulder 
position, and a soft tapping action begins to determine your shoulder height.
Massage Head
Tapping 
action
Keep your head on the pillow until the soft tapping begins. 
Lifting your head from the pillow will result in incorrect 
determination of the shoulder position.
3.  Confirm that the shoulder position has been correctly determined according to the position of the soft tapping.
Too low
Too...