Panasonic Kx Prw120 Operating Instructions Manual

Answering system settings
Call screeningWhile a caller is leaving a message, you can
listen to the call through the handset’s
speaker. To adjust the speaker volume, press
M D N or  MC N repeatedly. You can answer the call
by pressing  M
N on the handset. Call
screening can be set for each handset. The
default setting is  “On ”.
1 MMenu N (right soft key)  #310
2 Mb N: Select the desired setting.  a
M Save N a  M OFF N
Number of rings before the unit
answers a call
You can change the number of times the...

Smartphone integration
You can install the free Smartphone Connect
app on your smartphone and use your
smartphone as an extension of your phone
system. The following features are available
when using the app.
– Making and receiving calls using yourlandline
– Making and receiving intercom calls
– Playing answering system messages
– Checking your call log
– Copying phonebook entries from your smartphone to your phone system
– Transferring landline calls between your smartphone and your handsets
– Copying...

performing this procedure, and then
change it back when finished.
3 Mb N: Select your wireless router’s SSID.
a  M Select N
4 Confirm the SSID and then press  MOK N.
5 Enter the password required to access
the wireless network.  a M OK N
R After the base unit connects to the
wireless router,  “Connected to ” and
your wireless router’s SSID is
displayed.
6 MOFF N
Simplified configuration (WPS,
DHCP)
This procedure requires a wireless router that
supports WPS. If your wireless router supports
WPS, make...

using Wi-Fi repeater mode can cause the
sound to cut out briefly during landline calls.
R Do not use Wi-Fi repeater mode if you
already have a Wi-Fi range extender. If you
already have a Wi-Fi range extender, using
Wi-Fi repeater mode can cause network
problems such as not being able to access
the Internet, and the sound may cut out
briefly during landline calls.
Confirming network status
1 MMenu N (right soft key)  #526
2 Mb N and  MFE N: Display the desired
information.  a M OFF N
Confirming your...

Voice mail serviceVoice mail is an automatic answering service
offered by your service provider/telephone
company. After you subscribe to this service,
your service provider/telephone company’s
voice mail system answers calls for you when
you are unavailable to answer the phone or
when your line is busy. Messages are
recorded by your service provider/telephone
company, not your telephone. Please contact
your service provider/telephone company for
details of this service.
Important:
R To use the voice...

*1 If there are no new messages in the voicemail,  MVM N is not displayed.
Note:
R If the handset still indicate there are new
messages even after you have listened toall new messages, turn it off by pressing
and holding  # until the handset beeps.
Error messages
Display messageCause/solution
Ask phone
company for
VM access #R You have not stored the voice mail access number. Store the
number (page 45).
Base no power  
or No link to base.
Reconnect main
base AC adaptor.R The handset has lost...

TroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
ProblemCause/solution
The handset does not turn
on even after installing
charged batteries.R Place the handset on the base unit or charger to turn on the
handset.
The unit does not work.RMake sure the batteries are installed...

ProblemCause/solution
I cannot display the
wallpaper.RWallpaper is displayed in the standby mode only when you
select  “Digital(Small) ” or  “Off ” for the clock setting.
Change the clock setting (page 24).
I cannot register a handset
to a base unit.R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 33).
Battery recharge
ProblemCause/solution
The handset beeps and/or flashes.RBattery charge is low. Fully charge the...

ProblemCause/solution
The handset does not ring.RThe ringer volume is turned off. Adjust ringer volume (page 14,
23).
R Silent mode is turned on. Turn it off (page 28).
I cannot make a call.RThe dialing mode may be set incorrectly. Change the setting
(page 13).
I cannot make long
distance calls.R Make sure that you have long distance service.
Caller ID/Talking Caller ID
ProblemCause/solution
Caller information is not
displayed.RYou must subscribe to a Caller ID service. Contact your
service...

ProblemCause/solution
The 2nd caller’s
information is not
displayed during an
outside call.RIn order to use Caller ID, call waiting, or Call Waiting Caller ID
(CWID), you must first contact your service provider/telephone company and subscribe to the desired service.
After subscribing, you may need to contact your service
provider/telephone company again to activate this specific
service, even if you already subscribed to both Caller ID and
Call Waiting with Caller ID services (CWID).
Answering system...