Panasonic Kx-T1450, Kx-T1451 Automatic Telephone Answering System Operating Instructions

Panasonic 
Automatic Telephone 
Answering System 
KX-T1450 
EASA-PHONE 
MODEL NO. KX-T1451 
The unit in this picture is the 
La refrencia rapida en espatiol puede ser 
encontrada en las peginas 21-23. 
(Spanish Quick Reference can be found 
on pages 21-23.) KX-Ti 450.  

Table of Contents 
Locations of the Controls .................... 
Introduction 
............................... 
Preparation 
CONNECTION ........................ 
INITIAL SETTINGS 
.................... 
TOLL SAVER ......................... 
CASSETTE TAPE INSTALLATION ....... 
How to Record an Outgoing Message (OGM) 
RECORDING THE OGM . . 
CHECKING YOUR OGM . . 
SAMPLE OGMS . . . . . 
Setting Prior to Leaving 
RECORDING THE CALLERS’ MESSAGES 
PREPARING THE ICM TAPE . . . . 
. 
. 
Listening to the...

Location of the Controls 
Rewind (REW) Button 
Fast Forward (FF) Button 
(page 10) 
MEMO Button 
RING Selector (RINGS) 
POWER ON/OFF Switch 
ANSWER/CALL Indicator - 
I - (pane 6) 
(page 10) L PLAYBACK/PAUSE Button 
(page 10) 
VOLUME CONTROL 
REMOTE CODE Selector 
Telephone Jack (page 4) 
Telephone Line Jack (page 4) 
CPC Selector (page 5) 
Keep this overleaf unfolded while you are 
reading this Operating Instructions. This 
makes it easier to locate the controls and 
switches mentioned in the...

Introduction 
Thank you for purchasing the Panasonic Telephone 
Answering System. 
You can use this Model KX-T1450/KX-T1451 to: 
w Answer calls and record messages when you cannot answer the telephone or do 
not want to be disturbed 
n Monitor (screen) calls 
n Record your personal messages 
By using the advanced remote-control features of your KX-T1450/KX-T1451, you can 
also 
w Call in from another touch tone telephone to listen to your messages 
n Record a new Outgoing Message even when you are away...

Preparation 
CONNECTION 
To Power Outlet 
(AC1 20 V, 60 Hz) 
Do not connect the AC adaptor to 
.USE ONLY PANASONIC AC ADAPTOR KX-All. 
oThe unit must not be connected to a coin operated line. If you are on a party line, 
check with your local telephone company. 
l While operating the unit, the cabinet of the AC Adaptor may feel warm, this is a 
normal condition. 
-4-  

Preparation 
INITIAL SETTINGS 
Calling Party Control (CPC) Setting 
Set to “A”. (no call waiting service line.) 
If you have call waiting service or 
some Incoming Messages are 
interrupted, set to “B”. 
02 __............ The unit will answer a call on the 
l AUTO...... 
Recording 
l vox . . . . . . . . 
01 minute.. 
(1 MIN) See “TOLL SAVER” on this 
page. 
Time Selector 
The unit will record for as long as 
the caller speaks. 
The unit will record up to I minute. 
Remote Code 
The remote code number is...

Preparation 
CASSETTE TAPE INSTALLATION 
1 Open the panel, and insert the Outgoing 
Message (OGM) and Incoming Message 
(KM) tapes as shown. 
l TWO cassette tapes are included. Use 
Cl5 for OGM and C60 for ICM. 
@Do not use endless loop cassette tape. 
2 Connect the AC adaptor to the AC outlet. 
3 Set the POWER ON/OFF switch to ON. 
l The unit will start to reset the OGM tape. 
NOTES: 
03 minutes after connecting the AC adaptor, 
the unit will be powered ON automatically 
and reset the OGM tape even when...

How to Record an Outgoing Message (OGM) 
Before operating your unit, you must record an Outgoing Message (OGM). 
The OGM will inform the calling party of your absence and your message. 
RECORDING THE OGM 
POWER/IN USE Indicator 1 Push OGM REC until a long beep is 
heard, then release it. 
2 After the long beep, speak clearly and 
loudly into the microphone (MIC), 
approximately 8 inches away. 
l The IN USE indicator will flash. 
l The recording time is up to the tape 
length that you use. 
3 When...

CHECKING YOUR OGM 
You can check your OGM at any time. 
I Push OGM PLAY. 
l The unit will play back the OGM, then 
rewind the tape to the beginning. 
l Use the VOLUME control on the left side 
of your unit to regulate the volume 
during playback if necessary. 
l To stop the operation while playing back 
the OGM, push the OGM PLAY button. 
NOTES: 
l The unit will automatically change to the 
Answer mode 7 seconds after completing 
the OGM recording or checking. 
l Answer mode: 
When a call is received,...

Setting Prior to Leaving 
RECORDING THE CALLERS’ MESSAGES 
1 Push POWER ON/OFF to ON. 
l The POWER indicator will light. 
NOTES: 
l The unit will automatically switch itself to 
the Answer mode 7 seconds after you set 
the POWER ON/OFF switch or you 
complete some other operations. When the 
telephone rings, the unit will play back your 
OGM, then it will record the callers’ 
messages on the tape. 
elf you do not want to set the unit to the 
Answer mode, set the POWER ON/OFF 
switch to OFF. 
PREPARING...