Panasonic LUMIX DMC LC33 User Manual

							Recording images (advanced)
51
Taking Pictures using Burst Mode
By continuously pressing the shutter button, it 
is possible to record in burst mode.
[Preparation]
 Set the mode dial except for [ ]/[ ]. 
(P22)
1Press [ ].
 Every time you press it, what is displayed 
changes as shown below.
: High speed
: Low speed
When these indicators are not displayed, 
burst mode is cancelled.
2Press the shutter button halfway to 
lock the focus, then press it fully to 
take pictures in sequence.
 It is possible to record 4 frames in 1 second 
in burst mode, at a shutter speed higher 
than 1/60, but the flash does not fire 
simultaneously.
 If the flash fires, it is possible to record only 
1frame.
 In simple mode [ ], the shutter speed is 
fixed to the low speed. (P27)
 You cannot take still pictures with audio in 
the burst mode.
 Burst mode will not perform as described if 
a MultiMediaCard is used in place of SD 
Memory Card. The reading/writing speed of 
a MultiMediaCard is slower than an SD 
Memory Card.
Burst 
speedNumber of recordable 
pictures
4 frames/
second5 frames 8 frames
2 frames/
second5 frames 8 frames
H
L
2

LHOFF
H
L
KC52-PP.book  51 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Playback
52
Playback
Playing Back Still Pictures
1Set the mode dial to playback [ ].
 The last recorded picture is played back.
2Press 2 to play back the previous 
picture.
Press 1 to play back the next picture.
 Every time you press 2/1, the previous 
(or next) picture is played back.
 The first picture follows the last one.
[Fast forwarding/Fast rewinding]
During playback, continue pressing 2/1.
1: Fast forward
2: Fast rewind
 The file number increases/decreases. When 
releasing 2/1, the picture corresponding to 
the current file number is displayed.
 This camera is based on the DCF standards (Design rule for Camera File system) 
which were established by the Japan Electronics and Information Technology 
Industries Association (JEITA).
 The file format that can be played back with this camera is JPEG. (There are also 
pictures that cannot be played back in JPEG format)
 When playing back still pictures that have been recorded with other equipment, the 
quality of pictures may be deteriorated and pictures may not be able to be played 
back.
 When changing the folder name or file name on PC, the pictures may not be able 
to be played back.
2
1
2048
KC52-PP.book  52 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Playback
53
Playing Back Still Pictures with Audio
1Set the mode dial to playback [ ].
2Press 2/1 to select the file with audio 
icon [ ] 1
.
3Press the 4/[REVIEW/SET] button to 
play back the audio.
 Audio cannot be played back from this 
camera. Connect to a television to play back 
audio.
2,3
1
2048
PLAY AUDIO
111110:00 NOV. 1.2003100:0OV20033011N
KC52-PP.book  53 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Playback
54
9 Images Multi Playback
It is possible to display 9 images at once.
[Preparation]
 Set the mode dial to playback [ ]. (P22)
1During playback, rotate the zoom lever 
towards [ ].
 Multi playback (9 frames) starts.
2Press 3/4/2/1 to select images.
 To return to the normal indication, rotate 
the zoom lever towards [ ]. The image 
with the file number colored in yellow is 
displayed.
2
1WT
123
456
789
101112
1314
SELECT
CANCEL
SELECT
CANCEL
KC52-PP.book  54 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Playback
55
Using the Playback Zoom
During playback it is possible to enlarge 
pictures. (2 times/4 times/8 times/16 times)
[Preparation]
 Set the mode dial to playback [ ]. (P22)
1During playback, rotate the zoom lever 
towards [ ].
 The more the zoom lever rotates towards 
[ ], the more the zoom magnification 
ratio increases.
 The more the zoom lever rotates towards 
[ ], the more the zoom magnification 
ratio decreases.
 Use 3/4/2/1 to change the area to be 
enlarged.
ª To delete a picture during the 
playback zoom
Press the [ ] button.
When this message is displayed “DELETE 
THIS PICTURE?”, press 2/1 to select 
[YES], and press the 4/[REVIEW/SET] 
button. (P57)
 The more the zoom magnification increases, the more the picture quality 
deteriorates.
 The playback zoom may not operate if pictures have been recorded with other 
equipment.
1WT
DELETE CANCEL
KC52-PP.book  55 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Playback
56
Playing Back Motion Images
[Preparation]
 Set the mode dial to playback [ ]. (P22)
1Press 2/1 to select the file with the 
motion image icon [ ] 1.
2Press the 4/[REVIEW/SET] button to 
play back the motion image.
 By pressing 4, motion image playback 
will stop.
 The icon 2 is corresponding to the 
3/4/2/1 button.
[Fast forwarding/Fast rewinding]During motion image playback, continue 
pressing 2/1.
1: Fast forward
2: Fast rewind
 When releasing the button, it turns to 
normal motion image playback.
[To pause]
Press 3 during motion image playback.
Press 3 again to cancel pause.
 Audio cannot be played back from this camera. Connect to a television or PC to play 
back audio.
 The play back zoom cannot be used while playing back motion images.
 The file format that can be played back with this camera is QuickTime Motion 
JPEG.
 It could happen that the Motion JPEG file recorded by a PC or other equipment 
cannot be played back with this camera.
 When playing back motion images that have been recorded with other equipment, 
the quality of images may be deteriorated or images may not be able to be played 
back.
 When using a high capacity Memory Card, it is possible that fast rewinding may be 
slower.
1,2
PLAY MOTION
IMAGE
10:00 NOV. 1.2003
10s REMAIN
KC52-PP.book  56 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Editing
57
Editing
Deleting Images
Images recorded on the card can be deleted.
Once deleted, images cannot be recovered.
[Preparation]
 Set the mode dial to playback [ ]. (P22)
 When an image is protected, it cannot be 
deleted. Cancel the protect setting. (P63)
[Delete single image]
1Press 2/1 to select the image to be 
deleted.
2Press [].
3Press 2 to select [YES].
4Press the 4/[REVIEW/SET] button.
 The selected image is deleted.
1,3,42
DELETE SINGLE
DELETE THIS PICTURE?
YESNO
SETSELECTMULTI/ALL
2,3
KC52-PP.book  57 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Editing
58 [Delete multi images]
It is possible to delete up to 50 images all at 
once.
1Press [] 2 times.
2Press 3/4 to select [MULTI DELETE] 
and then press 1
.
3Press 2/1 to select the images to be 
deleted.
4Press the 4/[REVIEW/SET] button.
 The selected images are displayed with 
[ ]. Pressing the 4/[REVIEW/SET] 
button again, the setting is cancelled.
 The indication [ ] blinks red if the 
selected image is protected. Cancel the 
protect setting. (P63)
5Press [].
6When this message is displayed 
“DELETE THE PICTURES YOU 
MARKED?”, press 2 to select [YES].
7Press the 4/[REVIEW/SET] button.
 The selected multi images are deleted all 
at once.
1, 52,3,4,6,7
MULTI/ALL DELETE
MULTI DELETEALL DELETE
SELECTSET CANCEL
2
789
1011
MULTI DELETE
SELECTMARK/UNMARKDELETEEXITMENU
3,4
MULTI DELETE
SELECTSET
DELETE THE PICTURES
YOU MARKED?
YESNO
6
KC52-PP.book  58 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Editing
59 [Delete all images]
Once deleted, images cannot be recovered.
1Press [ ] 2 times.
2Press 3/4 to select [ALL DELETE] 
and then press 1
.
3When this message is displayed 
“DELETE ALL PICTURES?”, press 
2/1 to select [YES].
4Press the 4/[REVIEW/SET] button.
 Images that are protected or out of DCF 
standards (P52) are not deleted.
 Do not turn the power switch off or remove 
the card during deleting.
 When the remaining power is low or many 
pictures are deleted, use new batteries or 
the AC adaptor (optional, DMW-AC1).
MULTI/ALL DELETE
MULTI DELETEALL DELETE
SELECTSETCANCEL
2
SELECTSET
ALL DELETE
DELETE ALL PICTURES?
YESNO
3
KC52-PP.book  59 ページ  ２００３年３月１３日　木曜日　午後２時２９分 
						

							Editing
60
Writing the Print Information to the Card 
(DPOF Setting)
DPOF is the abbreviation for Digital Print 
Order Format. This feature allows you to 
designate which images will be printed. Some 
photo printers as well as many commercial 
photo-processing companies support DPOF.
[Preparation]
 Set the mode dial to playback [ ]. (P22)
[Single copy setting]
1Press the [MENU] button.
2Press 3/4 to select [DPOF PRINT] 
and then press 1
.
3Select [SINGLE] and then press 1.
4Press 2/1 to select 1 image.
5Press 3/4 to select the number of 
sheets.
 The number of sheets can be set from 1 
to 999.
6Press the [MENU] button 2 times.
 The menu will disappear.
[To cancel]
Set the number of sheets to 0 in step 5 of the 
[Single copy setting].
1,6 2,3,4,5
SINGLE
MULTI
 CANCEL INDEX
SETUPPLAY1/2
SELECT SETEXITMENU
2,3
PROTECTDPOF PRINTSLIDE SHOWAUDIO DUB.RESIZE
SELECTEXITMENU
DPOF SET THIS
DPOF SET THIS
COUNT
SELECT EXITMENU
COUNT1
4
5
KC52-PP.book  60 ページ  ２００３年３月１３日　木曜日　午後２時２９分