Philips Css2113b User Manual

							9
English
EN
MP3 player
Connect your MP3 player to play your audio files 
or music.
What you need
• An MP3 player.• A 3.5mm stereo audio cable.
Play music
1 Connect the MP3 player to the SoundBar as 
described in the Quick star t guide. 
2 Press MUSIC iLINK. »MUSIC iLINK indicator  on the front 
panel lights up.
3 Press the buttons on the MP3 player to select 
and play audio files or music.
Apply factory settings
You can reset your SoundBar to the default 
settings programmed at the factor y.
Within three seconds, press BASS+, VOL-,  and 
TREBLE+.
 » When the restore factor y settings process 
is complete, the SoundBar automatically 
switches off and turns back on again.
7 Wall mount
Before you mount your SoundBar on the wall, 
read all safety precautions (see 'Safety' on page 3). 
If you have any quer y, contact Philips Consumer 
Care in your countr y. 
Screw length/diameter
Depending on the type of wall, make sure that you 
use screws of a suitable length and diameter to 
mount this SoundBar.
  
For information about how to wall your SoundBar, 
see the Quick star t guide.
> 25mm
3 - 3.5mm
 
						

							10EN
8 Product specifications
Note
 •Specifications and design are subject to change 
without notice.
Amplifier
• Total output power : • Europe/Asia Pacific/China/Russia/India: 
60W RMS (30% THD)
• Latin America: 48W RMS (10% THD) • Frequency response: 20 Hz-20 kHz / ±3 dB• Signal-to-noise ratio: > 65 dB (CCIR) / 
(A-weighted)
• Input sensitivity:• AUX: 600 mV• Music iLink: 250 mV
Audio
• S/PDIF Digital audio input:• Coaxial: IEC 60958-3• Optical: TOSLINK
Main unit
 •Power supply: 110-240 V~, 50-60 Hz •Power consumption: 20 W •Standby power consumption: ≤ 0.5 W  •Speaker impedance: 4 ohm woofer, 4 ohm tweeter •Speaker drivers: 25 x 120 mm (1 x 5") 
woofer, 38 mm (1.5") tweeter
 •Frequency response: 150 Hz-20 kHz •Dimensions (WxHxD): 708 x 47 x 65 mm •Weight: 1.03 kg
Subwoofer
• Impedance: 8 ohm• Speaker drivers: 130 mm (5.25") woofer• Frequency response: 20 Hz-150 Hz• Dimensions (WxHxD): 165 x 240 x 295 mm• Weight: 2.6 kg• Cable length: 3 m
Remote control batteries
• 1 x CR2025 
9 Troubleshooting
Warning
 •Risk of electric shock. Never remove the casing 
of the product.
To keep the warranty valid, never tr y to repair the 
product yourself. 
If you have problems using this product, check the 
following points before you request ser vice. If you 
still have a problem, get suppor t at   
www.philips.com/suppor t. 
Sound
No sound from SoundBar speakers.• Connect the correct audio cable from your 
SoundBar to your TV or other devices.
• On your SoundBar remote control, press the 
Source buttons  to select the correct audio 
input.
• Make sure that the SoundBar is not muted. 
Press VOL +/- to restore the sound (see 
'Adjust the volume' on page 9).
Distorted sound or echo.
• If you play audio from the TV through the 
SoundBar, make sure that the TV is muted.
 
						

							© 2011 Koninklijke Philips Electronics N.V.
All rights reserved.
Sgpam_1216/CSS2113-2113B-2115-2123_12_05_v4