Philips Htr5000 User Manual

English
11
8239 300 38591
●Connect the AV receiver’s  COAXIAL
OUT  jack to the DIGITAL (COAXIAL)
IN jack on a digital recording device
(DTS-Digital Theatre System compatible,
with a Dolby Digital decoder, for
example).
➜ This will allow you to make digital or
analogue recordings from the signals
r eceived from this AV receiver.
AND/OR
● Connect the AV receiver’s  AUDIO
OUT  jacks to the AUDIO IN jacks on an
analogue recording device.
➜ This will allow you to make analogue
stereo (two-channel, left and...

English
12
8239 300 38591
Functional Overview
* = Press and hold the button for more than five seconds.
1STANDBY ON (B)
– Switches to standby mode or turns on
the system.
2SOUND
– Selects a sound effect.
3 BASS
–  Selects BASS (low tone) sound mode and
use the VOLUME control to change the
tone level.
4 TREBLE
–  Selects TREBLE (high tone) sound mode
and use the VOLUME control to change
the tone level.
5PROG
– *Enters receiver setup menu.
– TUNER: starts automatic/manual preset
programming.
6...

English
13
8239 300 38591
Control buttons available on the
remote only
0 
– Use       to select a preset radio station.
!SURROUND
– Selects multichannel surround or stereo
mode.
@SUBW  +-
– Adjusts subwoofer’s sound level.
REAR  +-
– Adjusts rear speakers’ sound level.
CENTER  +-
– Adjusts centre speaker’s sound level.
TV VOL  +-
– Adjusts TV volume (Philips TV only).
#SLEEP
– Sets the sleep timer function.
$DIM
– Selects different levels of brightness for
display panel.
%MUTE
– Mutes or restores the...

English
14
8239 300 38591
Step 1: Inserting batteries intothe remote control
1
3
2
1Open the battery compartment.
2Insert two batteries type R06 or AA,
following the indications ( +-) inside
the compartment.
3Close the cover.
Using the remote control to operate
the system
1Aim the remote
control directly at the
r emote sensor (iR) on
the front panel.
2Select the source you
wish to control by
pressing one of the
source select buttons
on the remote control
(for example TV,
TUNER).
3Then select the
desired...

English
15
8239 300 38591
Getting Started
CENTER DELAY –  Select this to set
the delay time in relation to the listening
position/distance  from the centre
speaker: 5ms, 3ms, 2ms, 1ms or OFF
(default setting).
REAR DELAY  – Select this to set the
delay time in relation to the listening
position/distance  from the rear speakers :
     15ms, 12ms, 9ms, 6ms, 3ms or OFF (default setting).
TEST TONE  –  Select this to turn ‘ON’
or ‘OFF’ (default setting) the test tone.
     If you have turned on the test...

English
16
8239 300 38591
IMPORTANT!
For proper surround sound, make
sure the speakers and subwoofer are
connected (see page 7).
Selecting surround sound
● In DISC COAX or DISC OPTI mode, if
the audio signal received is Dolby Digital
or DTS, pressing  SURROUND button
will  cyclically go  through :
DOLBY DIGITAL / DTS  ™ STEREO
●  Otherwise,  pressing  SURROUND
button will  cyclically go  through :
MOVIE  ™  MUSIC  ™  PRO LOGIC
™  STEREO
Helpful Hints:
– The available Surround outputs include:
Dolby...

English
17
8239 300 38591
Volume control
● Adjust  VOLUME  control (or press
V OL  +/-  on the remote) to increase
or decrease the volume level.
➜ VOL MIN  is the minimum volume
level and “ VOL MAX” is the maximum
v olume level.
F or Philips TVs only
● Press  TV VOL  +/-  on the remote
control to adjust the TV’s volume level.
To  listen through the headphones
●  Plug the headphones  to the  PHONE
socket at the front of the AV receiver.
➜  The speakers will be  muted .
➜ The current surround sound will...

English
18
8239 300 38591
Tuning to radio stations
1
Press  TUNER  on the remote (or press
SOURCE  control on front panel) to
select “ FM” or “ MW”.
2Press and hold  S / T  on the
r emote until the frequency indication
starts to change, then release.
➜ FM SEARCH  appears.
➜  The next radio station will  be tuned
automatically.
➜
 lights up for FM stereo reception.
3To  tune a weak station, press  S /  T
briefly and repeatedly until an optimal
r eception is found.
RDS Function
     RDS (Radio Data System)...

English
19
8239 300 38591
4Press PROG  again to store.
5Repeat steps 1~4 to store other radio
     stations.
Helpful Hints:
– If you attempt to  programme more than
40 preset radio stations, “ PROG FULL”
appears.
– The system will exit presetting mode if no
button is pressed within two seconds.
Selecting a preset radio
station
● Press        or use the  numeric keypad
(0-9)  to select a preset number.
➜  The preset number  followed by the
radio frequency will appear on the display
panel.
T uner Operations
 

English
20
8239 300 38591 WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty.  Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
No power.
No sound or distorted sound.
There is no sound from the centre and
rear speakers.
Radio reception...