Pocket Radio Sangean Dt300vw Operating Instruction

 WX      CH.0-9                 External-Make sure earphone or 
                                           pigtail antenna is inserted into 
                                           Earphone jack
A.Scan Tuning
Turn on the radio by pressing On/Off Button        . Select the desired band 
by pressing Band Selection Button        Press and hold the Tuning Control
Button      or       for more than 1/2 second . The radio will start to scan and 
will stop at the first active station. Repeating the procedure...

1213145 118111314until the desired station is reached or pressing and holding the Tuning
Control      or      until the station is reached.
C. Setting Presets Manually
Turn on receiver by pressing On/Off Button        .Select desired band by
pressing Band Selector Button         .Tune to the desired station using the
Manual or Scan Tuning Method as described above. When the desired
station is reached press Memory Button        . Memo  flashes in the LCD
display and a suggested preset position flashes....

1311
115 8121314station is selected to take its place. When the memory is full for a
particular band pressing the Memory Selection Button        will cause all
the positions to flash. In this case,select the desired position. press the
Memory Selection Switch        and the original station will be eliminated
and the new station will take its place.
D.Selecting Memory Presets
Turn on receiver by pressing On/Off Button        . Select desired band by 
pressing Band Selector Button        Move the Select...

5 81112115 8On/off Button        .Select desired band by pressing Band Select or Button      .
Press Memory Button        . Memo will flash in display. Press Select Button  
for move than 2 seconds until auto/memo appears and flashes in display.
press memory Button        again. The receiver will automatically begin to scan
and set memory preset positions. It will dliminate any memory presets already
with in the band.
F.Memory Scan Play
Turn on receiver by pressing On/Off Buttons        .Select desired...

15Note: If the Select Cursor     points at the frequency the 
Tuning Control Up/Down Button            will continue to change frequency
within the band selected. If the Selector Cursor      points at the position
digits for the memory presets      the Tuning Control Up/Down Button  
and        will select the memory presets.
G.Deleting Memory Positions
If The memory is full or you would like to delete a memoey position select
the preset youy would like to delete.Press Memory Button        , display
will...

1697 3 3 Mono/Stereo Button
Monaural or Stereo headphone reception may be selected durning FM
reception by alternately pressing the Mono/Stereo Button        The Speaker
On/OffSwitch         must be in the Off
Lock Switch
To Prevent accidental changing of any of the radio settings move the Look
Switch         to the locked position. When engaged in the  locked position
the icon key      will appear in the LCD display. To release the lock switch
simply move the switch to the off position. Make sure lock...

Specification
Type:         FM- Stereo (Via earphone)
                   AM- Standard (mono)
                    TV Band (Mono Ch,2-13 VHF) DT-300V/VW
                    Weather Band (WX) (Mono Ch. 0-9) DT-300VW
Earphone jack:                     3.5 mm mini-plug
                   16 or 32 ohm impedance (Stereo)
Output Power:                      50 mW (10THD) via built-in speaker
Speaker:   1.1inch diameter,4ohm impedance
Batteries:  3 volt(AAA/UM-4 size) x 2
Dimension (WxHxD):2 1/4  X 3 3/4  X3/4...