RCA Rlded3258ae Manual

							RLDED3258A-E
32” LED TV
USER’S MANUAL 
						

							Contents
Introduction  
Warning
Caution
Importa
nt Information 
Attaching or Removing the Stand 
Installing Batteries to the Remote Control 
Identifying Front and Rear Panel 
Connection Suggestion 
Main Unit Description   
Remote Control 
OSD Basic Adjustment 
How Do I Clean The TV 
Troubleshooting 
Specifications
FCC Compliance Statement 
 
						

							Introduction 
Thank you very much for purchasing your LED TV. It serves as a normal colour TV 
and a PC monitor. To enjoy your set fully from the very beginning, read this manual 
carefully and keep it handy for future reference. 
INSTALLATION 
Locate the receiver in the room where direct light does not strike the screen. Total
darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect
lighting is recommended for comfortable viewing.
 Allow enough space between the receiver and the wall to permit ventilation. 
 Avoid excessively warm locations to prevent possible damage to the cabinet or 
premature component failure. 
 This TV can be connected to AC 100-240V~ 50/60Hz. 
 Do not install the TV in a location near heat sources such as radiators, air ducts, 
direct sunlight, or in closed compartments and closed areas. Do not cover the 
ventilation openings when using the TV. 
The indicator light will last for about 30 seconds after the power has been turned 
off. 
 Wait until the indicator light goes out before repowering the TV. 
6
User manual x1
Warranty card x1
Power cable x1
Remote control x1
Battery (pair, AAA) x1 Accessories list for this TV set:x 
x 
x 
x 
x  
						

							Warning 
This symbol is intended to alert the user to avoid the risk 
of electric shock. This equipment may only be disassembled 
by qualified service personnel.
This symbol is intended to alert the user to the presence 
of important operation and maintenance instructions in   
the literature accompanying the equipment. 
  
                                             
CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK. 
DO NOT REMOVE COVER (OR BACK). 
NO USER- SERVICEABLE PARTS INSIDE. 
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
. 
CAUTION 
RISK OF ELECTRIC SHOCK
DO NOT OPEN 
Class I structures of equipment should be connected to the grid 
power output with a protective earth connection on the socket. 
Power plug as a broken applianceÈ
broken installations should 
be easy to operate. 
 
						

							Caution
Caution
                High voltages are used in the operation of this product. 
- Do not open the product's casing. Refer servicing 
    to qualified service personnel . 
  
Caution
  To prevent fire or electrical shock hazard, do not expose 
    the main unit to 
rain or moistureÈdo not place objects 
filled with liquids, such as vases, on the apparatus.
Caution
               Do not drop or push objects into the television cabinet
slots or openings. Never spill any kind of liquid on the 
  television receiver. 
Caution
                Avoid exposing the main unit to direct sunlight and other 
sources of heat. Do not stand the television receiver 
    directly on other products which give off heat: e. g. video 
cassette players and audio amplifiers. Do not block the
    ventilation holes in the back cover. Ventilation is essential 
    to prevent failure of electrical components. Do not squash 
the power supply cord under the main unit or other heavy 
objects.
 
						

							Caution
Caution
           Never stand on, lean on or suddenly push the product
          or its stand. You should pay special attention to 
                          children. 
 Caution 
             Do not place the main unit on an unstable cart stand, 
         shelf or table. Serious injury to an individual and 
                        damage to the television may result if it should fall.   
Caution
              When the product is not used for an extended period
                      of time, it is advisable to disconnect the AC power 
                             from the AC outlet. 
Caution
              The LED panel used in this product is made of glass and   
                  is therefore breakable. This product must not be dropped   
                or banged. If the LED Panel breaks be careful of being 
                           injured by broken glass. 
 
						

							Television Antenna Connection Protection 
Important Information
External Television Antenna Grounding
If an outside 
antenna or cable system is to be connected to the TV, make sure that the antenna or 
cable system is electrically grounded to provide some protection against voltage surges and 
static charges. Article 810 of the National Electrical Code, ANSI/NFPSA 70, provides 
information with regard to proper grounding of the mast and supporting structure, grounding of 
the lead-in wire to an antenna discharge unit, size of the grounding conductors, location of 
antenna discharge unit, connection to grounding electrodes, and requirements of the grounding 
electrode.
Lightning Protection 
For added protection of the TV during a lightning storm or when it is left unattended or unused 
for long periods of time, unplug the TV from the wall outlet and disconnect the antenna or cable 
system. 
Power Lines 
Do not locate the antenna near overhead light or power circuits, or where it could fall into such 
power lines or circuits.
 
						

							  
 
 
 

  
Attacthing or Removing the Stand
1.To attach the base place the display unit flat on a table.   Afterwards attach the stand onto 
the bottom of the stand.  Screw in the 4 screws to secure the stand.  
						

							 

2. To remove the stand, remove the 4 screws in the area and the stand will come off.
Installing Batteries to the Remote Control 
Please insert two AAA batteries into the remote control. Make sure that you match the (+) 
and (-) symbols on the batteries with the (+) and (-) symbols inside the battery compartment.   
Afterwards, re-attach the battery cover. 
Please note: 
Only use AAA batteries. 
Do not mix new and old batteries. This may result in cracking or leakage that may pose a 
fire risk or lead to personal injury. 
Inserting the batteries incorrectly may also result in cracking or leakage that may pose a 
fire risk or lead to personal injury. 
Dispose the batteries in accordance with local laws and regulations.
Keep the batteries away from children and pets. 
If the remote control is not used for a long time, remove the batteries. 
Keep the remote control away from moisture, sunlight, and high temperatures. 
						

							Front View 
Rear View Mounting Pattern 
Identifying Front and Rear Panel
INDICATOR LIGHT – The light is red when power is plugged in but the TV is not turned on.   
The light turns blue when the TV is turned on. Because of the LED  in the panel, the TV 
might take 10 – 12 seconds to power on.
REMOTE SENSOR – The remote sensor receives all the commands from the remote control. 
Mounting Specification : 100mm x 200mm using screw size M6. Length of screw should not 
exceed 8mm.  Please Note : The 8mm length of screw refers to how deep the screw can go 
inside the mounting holes.    When you’re buying screws, you should add the original 8mm to 
the thickness of your mounting plate in order to get the total screw length.

200.00
100.00