RCA Rlded3258ae Manual

RLDED3258A-E
32” LED TV
USER’S MANUAL 

Contents
Introduction  
Warning
Caution
Importa
nt Information 
Attaching or Removing the Stand 
Installing Batteries to the Remote Control 
Identifying Front and Rear Panel 
Connection Suggestion 
Main Unit Description   
Remote Control 
OSD Basic Adjustment 
How Do I Clean The TV 
Troubleshooting 
Specifications
FCC Compliance Statement 
 

Introduction 
Thank you very much for purchasing your LED TV. It serves as a normal colour TV 
and a PC monitor. To enjoy your set fully from the very beginning, read this manual 
carefully and keep it handy for future reference. 
INSTALLATION 
Locate the receiver in the room where direct light does not strike the screen. Total
darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect
lighting is recommended for comfortable viewing.
 Allow enough space between the receiver and...

Warning 
This symbol is intended to alert the user to avoid the risk 
of electric shock. This equipment may only be disassembled 
by qualified service personnel.
This symbol is intended to alert the user to the presence 
of important operation and maintenance instructions in   
the literature accompanying the equipment. 
  
                                             
CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK. 
DO NOT REMOVE COVER (OR BACK). 
NO USER- SERVICEABLE PARTS INSIDE. 
REFER SERVICING TO...

Caution
Caution
                High voltages are used in the operation of this product. 
- Do not open the product's casing. Refer servicing 
    to qualified service personnel . 
  
Caution
  To prevent fire or electrical shock hazard, do not expose 
    the main unit to 
rain or moistureÈdo not place objects 
filled with liquids, such as vases, on the apparatus.
Caution
               Do not drop or push objects into the television cabinet
slots or openings. Never spill any kind of liquid on the...

Caution
Caution
           Never stand on, lean on or suddenly push the product
          or its stand. You should pay special attention to 
                          children. 
 Caution 
             Do not place the main unit on an unstable cart stand, 
         shelf or table. Serious injury to an individual and 
                        damage to the television may result if it should fall.   
Caution
              When the product is not used for an extended period
                      of time, it...

Television Antenna Connection Protection 
Important Information
External Television Antenna Grounding
If an outside 
antenna or cable system is to be connected to the TV, make sure that the antenna or 
cable system is electrically grounded to provide some protection against voltage surges and 
static charges. Article 810 of the National Electrical Code, ANSI/NFPSA 70, provides 
information with regard to proper grounding of the mast and supporting structure, grounding of 
the lead-in wire to an antenna...

  
 
 
 

  
Attacthing or Removing the Stand
1.To attach the base place the display unit flat on a table.   Afterwards attach the stand onto 
the bottom of the stand.  Screw in the 4 screws to secure the stand.  

 

2. To remove the stand, remove the 4 screws in the area and the stand will come off.
Installing Batteries to the Remote Control 
Please insert two AAA batteries into the remote control. Make sure that you match the (+) 
and (-) symbols on the batteries with the (+) and (-) symbols inside the battery compartment.   
Afterwards, re-attach the battery cover. 
Please note: 
Only use AAA batteries. 
Do not mix new and old batteries. This may result in cracking or leakage that may pose a 
fire risk or lead...

Front View 
Rear View Mounting Pattern 
Identifying Front and Rear Panel
INDICATOR LIGHT – The light is red when power is plugged in but the TV is not turned on.   
The light turns blue when the TV is turned on. Because of the LED  in the panel, the TV 
might take 10 – 12 seconds to power on.
REMOTE SENSOR – The remote sensor receives all the commands from the remote control. 
Mounting Specification : 100mm x 200mm using screw size M6. Length of screw should not 
exceed 8mm.  Please Note : The 8mm length...