Sharp Esn70esa Manual

							11
GUIDES FOR OTHER USEFUL PROGRAMS
2Set the washing
time.
2Set the rinsing
time.
2Set the washing
time and rinsing
time.
2Set the washing
time and spinning
time.
2Set the spinning
time.
2Set the rinsing
time & spinning
time.
2Select the
spinning time.
Partial process Process Procedure
Reservation Washing
• Reservation can be made from 2 hours to 48hours.
Press
START/PAUSE
button Set the
reservation
time
• Wool and tub clean course cannot be reserved.
• Your reservation time will show at display panel.
Select the
course
Wash, Rinse or Spin Selection
Only Wash
Only Rinse
Wash & Rinse
Wash & Spin
Only Spin
Repeat rinse &
Spin after
washing
Only Drain1Press
the Power
button.3Set the water
level.4Close the lid
(door) and press the
Start/Pause button.
Drain process is not
applicable for this
cycle. Please refer
below for the spin
function.The buzzer will
sound after process
complete and power
will switch off
automatically.
3Close the lid (door) and press the
Start/Pause button.
3Open the lid (door) and press the
Start/Pause button.The buzzer will
sound and display
panel will show LE
signal. But, the
power will not turn
off automatically. 
						

							12
GENERAL PROCEDURE FOR OPERATION
2. OPTIONAL STEP
• Pour liquid fabric softener into the dispenser using the amount recommended on the
package.
Avoid dripping or spilling any fabric softener on the load.
• Dilute fabric softener with warm water.
Fill dispenser with warm water until liquid reaches the base line in the case.
The dispenser is for liquid fabric softener use only.
• The liquid fabric softener will be put into the TUB automatically when final Rinse process.
3. Close the washer lid (door).
4. Press the power button.
5. Select the cycle.
6. Press the “Start/Pause” button. 1. Add measured detergent to the detergent case. (Follow manufacturers directions for safe use)
Inlet Hole
Base Line
Softener inlet Detergent 
						

							13
CARING FOR YOUR WASHER
Proper care of your washer can extend its life. This section explains how to care for
your washer properly and safely.
Cleaning your washer
Winter storage or moving care
Install and store your washer where it will not freeze. Because some water may stay in the hoses,
freezing can damage your washer.
If storing or moving your washer during freezing weather, winterize it.
Non-use or vacation care
Operate your washer only when you are at home.
If will be on vacation or not using your washer for an extended period of time, you should:
• Unplug the power supply cord or turn off eletrical power to the washer.
• Turn off the water supply to the washer .
This helps avoid accidental flooding (due to a water pressure surge) while you are away.Wipe up detergent, bleach, and other spills with
a soft, damp cloth or sponge as they occur.
Occasionally wipe the outside of the washer to
keep its looking like new one.Clean interior with 250ml of chlorine bleach
mixed with 500ml of detergent.
Run washer through a complete cycle.
Repeat this process if necessary.
Exterior Interior
Do not put sharp or metal object in your washer, or they can
damage the finish. Check all pockets for pins, clips, money,
bolts, nuts, etc.
Do not lay these objects in your washer after emptying
pockets.
• Turn off water faucet.
• Disconnect and drain water inlet hoses.
• Run washer on a drain and spin setting
(see page 11) for 1 minute.
• Unplug the power supply cord.• Flush water pipes and hoses.
• Reconnect water inlet hoses.
• Turn on water faucet.
• Reconnect power supply cord.
To winterize washer To use washer again 
						

							14
HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
• Clean the filter when water leaks from the water inlet.
Cleaning the Lint Filter
• This washer has two type of lint Filter in order to increase lint filtering performance.
It is assembled in the middle area of Tub.(Option)
1Pull the power
plug out before
cleaning it.2Turn off the water
supply to the
washer and
sperate the inlet
hose.3Pull the inlet filter
out.4Remove the dirt
from the inlet filter
with a brush.
1Pull the button with pulling
upward.2Open the Cover and get rid of
lint being the Inside of Filter
then close the Cover.3Assemble the Lint Filter as it
was, by pushing toward wall
with fixing slot. 
						

							15
Removing stains
Stained, heavily-soiled, or greasy items may need to be prewashed or soaked for best results.
Soaking helps remove protein-type stains like blood, milk, or grass. Prewashing helps loosen
soil before washing.
Stain removal rules
• Use warm water for soaking or prewashing stained laundry. Hot water can set stains.
• Most stains are easier to remove when they are fresh.
• Before treating any stain, find out what kind of stain it is, how old the stain is, what kind of
fabric it is, and if the fabric is color fast. (Check the care label)
• Washing and drying can set some stains.
• Start with cold or warm water, hot water can set some stain.
• When bleach is recommended, use a bleach that is safe for the fabric.
• Put the stained area face down on a paper towel or white cloth. Apply the stain remover to
the back of the stain. This forces the stain off the fabric instead of through it.
Stain removal guide
Blood
Chewing gum
Cocoa, Chocolate
Coffee
Cream/Milk
Ice cream
Deodorant
Egg
Fabric/Softener
Fruit stains
Grass
Grease and oil
Iron or rust
Lipstick
Mildew
Mud
Oil-based Paints
Water-based Paints
Scorch marks
Rinse immediately in COLD water.
If stain remains, soak in cold water with an enzyme prewash.
Use ice in plastic bag to harden the gum.
Scrape off what you can and the sponge with white spirits.
Sponge with COLD water and soak in an enzyme prewash.
If stains persist, rub in a little detergent and rinse in cold water.
Blot up quickly and rinse out in COLD water.
Rub in a little detergent and wash in the maximum temperature allowed for the
fabric type.
Rinse in COLD water and wash normally.
If stain is still apparent, sponge with white spirits.
Rub affected area with white vinegar and then rinse out in COLD water.
Sponge with white spirits.
Treat stiffened areas with enzyme prewash.
Soak in a COLD enzyme prewash, rinse and wash normally.
Rub affected area with bar soap and wash normally.
Treat as soon as possible by sponging with COLD water.
Rub a little detergent on the stain and wash normally.
Sponge with white spirits.
Rub in an enzyme prewash and wash as normally.
Lay the affected area face down on an absorbent cloth and work from the back.
Sponge with white spirits or dry cleaning fluid. Wash normally.
Apply lemon juice and salt and place in the sun. Wash normally.
Sponge with white methylated spirits and wash normally.
Wash in WARM water and detergent.
Moisten area with lemon juice, dry in the sun and wash normally.
If stain persists and the fabric allows, use a bleach.
Brush off any dry mud. Rinse in cold water.
If stain persists rub in a little detergent and wash normally.
Scrape off any fresh paint and sponge with a non flammable dry cleaning fluid
and wash normally.
Treat while still wet, rinse in WARM water and wash normally.
Dampen a cloth with hydrogen peroxide, lay it over the affected area and press
with a fairly hot iron.
STAIN TO REMOVE 
						

							16
• Is there a power failure?
• Is the power cord correctly connected to an electric outlet?
• Is the electric fuse broken?
• Did you turn on the power?
• Did you press Start/Pause button?
• Is there correct amount of water in the tub?
• Did you connect the inlet hose and open the water tap?
• Is the inlet hose or the water tap frozen?
• Is the water supply shut off?
• Does foreign matter block up the inlet hose filter?
• Is the drain hose frozen or blocked up by dirt?
• Is the drain hose kinked or deformed?
• Is the end of the drain hose immersed in water?
• Is there excessive dirt inside the pump housing?
• Is the clothes in the tub collected on one side?
• Is the washing machine installed on an uneven floor or is the
vibration serious?
• Is the lid open?
(The lamp  will light up in this case.)
TROUBLE SHOOTING
Most problems are easily solved if you understand the cause.
Check the following list for problem before calling for service.
Before calling for service, check these
• The washer will not
operate at all.
• Water is not supplied;
If water supply is not finished
within 20 minutes, the lamp 
will light up, and the buzzer will
sound to indicate a problem.
PROBLEM CHECK POINT
■These cases are not malfunctions
• 
The sound “wing” heard during water supply is the operating sound made by the water inlet valve.
• The sound “sha” heard in stopping the tub is the sound that comes from the autobalancer of
the tub.
• The sound “wung” heard during wash or spin is the operating sound made by the air bubble
generator.
• The washer will not drain;
If the drain is not finished within
selected time, lamp  will
light up, and the buzzer will
sound to indicate a problem.
• The washer will not spin;
If the clothes is collected on one side
during spin and the tub becomes
unbalanced, the spin operation will be
interrupted, and then this unbalanced
condition will be corrected by
following operation: WATER SUPPLY
NRINSE NDRAIN However if the
unbalanced condition is unchanged
despite repeating the above
operation, the lamp  will light up,
and the buzzer will sound to indicate
a problem.
NOTE
Please check the point before calling for a service.
If the supply cord is damaged, it must only be replaced by a repair shop appointed by
manufacturer, because special purpose tools are required. 
						

							17
SPECIFICATION
POWER SOURCE 220V/ 50Hz
POWER CONSUMPTION 550W
Dimension (WxHxD,mm) 630 x 1040x 700
Unit Weight 48 kg
Standard Water Consumption 240@
Operating Water Pressure 0.3kgf/cm2~ 8kgf/cm2(0.03MPa ~ 0.8MPa)
Wash Mode Washing Type (Air-Bubble + Ag+ Ion Pulsator)
MODEL NO. ES-D159T-SL / ES-D159T-WH
NOTE
• In case of moving Washing Machine, please follow the following
picture.Front Top 
						

							v vi
is
si
io
on
n@@
c cr
re
ea
at
ti
iv
ve
eL
L@@
i in
nc
cN
N7“ ‚
8 ÃÉ·
VhV