Home > SMC Networks > Router > SMC Networks Router SMCWBR14T User Manual

SMC Networks Router SMCWBR14T User Manual

Add to Favourites

Download as PDF Print this page Share this page

Have a look at the manual SMC Networks Router SMCWBR14T User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 10 SMC Networks manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

Page 122 TROUBLESHOOTING
A-4
Wireless Problems
A wireless PC
cannot associate
with the
Barricade.• Make sure the wireless PC has the same SSID settings
as the Barricade. See “Channel and SSID” on page 25.
• You need to have the same security settings on the
clients and the Barricade. See “Security” on page 27.
The wireless
network is often
interrupted.• Move your wireless PC closer to the Barricade to find
a better signal. If the signal is still weak, change the
angle of the antenna.
• There may be...

Page 123 B-1
APPENDIX B
CABLES
Ethernet Cable
Caution:Do not plug a phone jack connector into an RJ-45 port. For
Ethernet connections, use only twisted-pair cables with RJ-45
connectors that conform to FCC standards.
Specifications
Wiring Conventions
For Ethernet connections, a twisted-pair cable must have two pairs of
wires. Each wire pair is identified by two different colors. For example, one
wire might be red and the other, red with white stripes. Also, an RJ-45
connector must be attached to both ends of...

Page 124 CABLES
B-2
Each wire pair must be attached to the RJ-45 connectors in a specific
orientation. The following figure illustrates how the pins on an Ethernet
RJ-45 connector are numbered. Be sure to hold the connectors in the same
orientation when attaching the wires to the pins.
Figure B-1. RJ-45 Ethernet Connector Pin Numbers
RJ-45 Port Ethernet Connection
Use the straight-through CAT -5 Ethernet cable provided in the package
to connect the Barricade to your PC. When connecting to other network...

Page 125 RJ-45 PORT ETHERNET CONNECTION
B-3
Pin Assignments
With 10BASE-T/100BASE-TX cable, pins 1 and 2 are used for
transmitting data, and pins 3 and 6 for receiving data.
Straight-Through Wiring
If the port on the attached device has internal crossover wiring (MDI-X),
then use straight-through cable.
RJ-45 Pin Assignments
Pin Number Assignment*
1Tx+
2Tx-
3Rx+
6Rx-
* The “+” and “-” signs represent the polarity of the
wires that make up each wire pair.
Straight-Through Cable Pin Assignments
End 1 End 2
1...

Page 126 CABLES
B-4
Crossover Wiring
If the port on the attached device has straight-through wiring (MDI), use
crossover cable.
Crossover Cable Pin Assignments
End 1 End 2
1 (Tx+) 3 (Rx+)
2 (Tx-) 6 (Rx-)
3 (Rx+) 1 (Tx+)
6 (Rx-) 2 (Tx-)

Page 127 C-1
APPENDIX C
SPECIFICATIONS
Standards Compliance
CE Mark
Safety
TÜV
IEEE 802.3 10 BASE-T Ethernet
IEEE 802.3u 100 BASE-TX Fast Ethernet
LAN Interface
4 RJ-45 10 BASE-T/100 BASE-TX ports
Auto-negotiates the connection speed to 10 Mbps Ethernet or 100 Mbps
Fast Ethernet, and the transmission mode to half-duplex or full-duplex
WAN Interface
1 ADSL RJ-45 port
Indicator Panel
LAN 1~4, WLAN, PPPoE/DSL, WAN, Power
Dimensions
145 x 95 x 36 mm (5.70 x 3.74 x 1.41 in)
We ig h t
0.175 kg (0.469 lbs)
Input...

Page 128 SPECIFICATIONS
C-2
Advanced Features
Dynamic IP Address Configuration – DHCP, DNS, DDNS
Firewall – Client privileges, hacker prevention and log ging,
Stateful Packet Inspection
Virtual Private Network – PPTP, IPSec pass-through, VPN pass-through,
VLAN Ping
Internet Standards
RFC 826 ARP, RFC 791 IP, RFC 792 ICMP, RFC 768 UDP, RFC 793 TCP,
RFC 783 TFTP, RFC 1483 AAL5 Encapsulation, RFC 1661 PPP,
RFC 1866 HTML, RFC 2068 HTTP, RFC 2364 PPP over ATM
Radio Features
Wireless RF module Frequency Band...

Page 129 SPECIFICATIONS
C-3
RF Output Power Modulation Rate-Output Power (dBm)
802.11b - 1Mbps 16
802.11b - 2Mbps 16
802.11b - 5.5Mbps 16
802.11b - 11Mbps 16
Modulation Rate-Output Power (dBm)
802.11g - 6Mbps 15
802.11g - 9Mbps 15
802.11g - 12Mbps 15
802.11g - 18Mbps 15
802.11g- 24Mbps 15
802.11g - 36Mbps 15
802.11g- 48Mbps 15
802.11g - 54Mbps 15
Sensitivity Modulation Rate-Receiver 2.412 ~ 2.484 HGz Sensitivity
(dBm)
802.11b - 1Mbps -90
802.11b - 2Mbps -88
802.11b - 5.5Mbps -85
802.11b- 11Mbps -84
Modulation...

Page 130 SPECIFICATIONS
C-4
Environmental
SMCWBR14T-G complies with the following standards:
Te m p e r a t u r e
Operating 0 to 40 °C (32 to 104 °F)
Storage -40 to 70 °C (-40 to 158 °F)
Humidity
5% to 95% (non-condensing)
Vibration: IEC 68-2-36, IEC 68-2-6
Shock: IEC 68-2-29
Drop: IEC 68-2-32
IEEE Standards
IEEE 802.3, 802.3u, 802.11g, 802.1D
ITU G.dmt
ITU G.Handshake
ITU T.413 issue 2 - ADSL full rate

View all the pages

Add page 131 to Favourites

Add page 132 to Favourites

All SMC Networks manuals Comments (0)

Related Manuals for SMC Networks Router SMCWBR14T User Manual

SMC Networks Router SMCWBR14T User Manual
132 pages | SMC Networks Router