Smeg Sa561x9 Manual

							Cleaning and maintenance
23
EN
4.10 Extraordinary maintenance
Replacing the internal light bulb
1. Completely remove all accessories from 
inside the oven.
2. Remove the racks/trays support frames.
3. Remove the bulb cover using a tool (e.g. 
a screwdriver).4. Slide out and remove the lamp.
5. Replace the lamp with one of the same 
type (40W).
6. Replace the cover correctly, so that the 
moulded part of the glass is facing the 
door.
7. Press the cover completely down so that 
it attaches perfectly to the bulb support.
Removing the door seal
To permit thorough cleaning of the oven, the 
door seal may be removed. There are 
fasteners on all four sides to attach it to the 
edge of the oven. Pull the 4 edges of the 
seal outwards to detach the fasteners.
Live parts
Danger of electrocution

Do not touch the halogen lamp 
directly with your fingers, but wrap 
it in an insulating material. 
						

							Installation
24
5 Installation
5.1 Electrical connection
General information
Check the grid characteristics against the 
data indicated on the plate.
The identification plate bearing the 
technical data, serial number and brand 
name is visibly positioned on the appliance.
Do not remove this plate for any reason.
The appliance works at 220-240 V~.
Use a H05V2V2-F type three-core cable (3 
x 1.5 mm
2 cable, referring to the cross 
section of the internal conductor).
Perform the ground connection using a wire 
that is 20 mm longer than the other wires.Fixed connection
Fit the power line with an omnipolar circuit 
breaker in compliance with installation 
regulations.
The circuit breaker should be located near 
the appliance and in an easily reachable 
position.
Connection with plug and socket
Make sure that the plug and socket are of 
the same type.
Avoid using adapters and shunts as these 
could cause overheating and a risk of 
burns.
5.2 Cable replacement
1. Unscrew the rear casing screws and 
remove the casing to access the terminal 
board.
2. Replace the cable.
3. Make sure that the cables (for the oven 
or any hob) follow the best route in order 
to avoid any contact with the appliance.
Power voltage
Danger of electrocution

performed by authorised technical 
personnel.

earth in compliance with electrical 
system safety standards.

Power voltage
Danger of electrocution
 
						

							Installation
25
EN
5.3 Positioning
Fastening bushings
Remove the bushing covers inserted on the 
oven front. Mount the appliance into the recess.
Secure the appliance to the piece of 
furniture using screws.
Cover the bushings with the covers 
removed previously.
Appliance overall dimensions (mm)
Heavy appliance
Danger of crush injuries

furniture with the aid of a second person.
Pressure on the open door
Risk of damages to the appliance

installation, 
do not use the door handle 
to lift up or move this appliance.

appliance into place when fitting.

oven door when open.
Heat production during appliance 
operation
Risk of fire

is heat resistant.

required slots. 
						

							Installation
26
Mounting under worktops (mm) Mounting into a column (mm)
Make sure that the piece of 
furniture rear/bottom part has an 
opening of approx. 60 mm.
Make sure that the piece of 
furniture top/rear part has an 
opening approx. 35-40 mm deep.