Smeg Sap112-8 Manual

Instructions for the User
42
DISHESWEIGHTFUNCTION
PIZZAFan-assisted static
BREADCircular
FOCACCIATu r b o
DESSERTS
DOUGHNUT Fan-assisted static
FRUIT TART Fan-assisted static
FRUIT TART Static
SHORT PASTRY Circular
JAM TARTS Turbo
PARADISE CAKE Fan-assisted static
PARADISE CAKE Static
ECLAIR Turbo
LIGHT SPONGE CAKE Circular
RICE PUDDING Turbo
RICE PUDDING Static
CROISSANTS Circular
APPLE PIE Static
The times indicated in the following tables do not include the preheating times
and are provided as a guide...

Instructions for the User
43
RUNNER POSITION 
FROM BOTTOMTEMPERATURE
°CTIME IN MINUTES
1250 - 2806 -10
2190 - 20025 -30
2180 - 19015 -20
2 160 55 - 60
2 160 30 - 35
2 170 35 - 40
2 160 - 170 20 - 25
2 160 20 - 25
2 160 55 - 60
2 170 50 - 60
2 150 - 160 40 - 50
2 150 - 160 45 - 50
2 160 40 - 50
2 170 50 - 60
2 160 25 - 30
3180 60 

Instructions for the User
44
7.4 Proving and defrosting functions
On pyrolytic models, the special defrosting and
proving functions are brought together under the
same function indicated by  .
The choice of temperature determines whether
defrosting or proving takes place based on the table
below.
On multifunction models, it is not possible to vary the temperature in the
defrosting and proving functions.
Temperature 
(°C)FunctionRunner position 
from the bottomTime in 
minutes
30 Defrosting 1
Depending on...

Instructions for the User
45
8. CLEANING AND MAINTENANCE
NEVER USE A STEAM JET FOR CLEANING THE APPLIANCE.
We recommend the use of cleaning products distributed by SMEG.
8.1 Cleaning stainless steel
To keep stainless steel in good condition it should be cleaned regularly after
use. Let it cool first.
8.2 Ordinary daily cleaning
To clean and preserve the stainless steel surfaces, always use only specific
products that do not contain abrasives or chlorine-based acids.
How to use: pour the product onto a...

Instructions for the User
46
8.5 Cleaning the inside of the oven
For the best oven upkeep, clean it regularly after having allowed it to cool. 
 Take out all removable parts.
 Clean the oven racks with hot water and non-abrasive detergent. Rinse and
dry.
 For easier cleaning, the door can be removed (see “9.2 Removing the
door”).
The oven should be operated at the maximum heat setting for 15/20 minutes
after use of specific products, to burn off the residues left inside the oven.
On pizza models only, to...

Instructions for the User
47 Lift up the edge of the lower
heating element a few centimetres
and clean the bottom.
Put the pizza plate support back in
place, pushing it in until it hits the
back of the oven, and push it down
so that the heating element plate
is embedded into the base itself.
When the operation is complete, damp parts should be dried thoroughly.
8.5.1 Removing guide frames
Removing the guide frames makes
it easier to clean the side parts,
and it also needs to be done
whenever the...

Instructions for the User
48
8.6 Cleaning the pizza plate
The pizza plate (where included) should be washed separately according to the
following instructions:
Pyrolytic models: leave the pizza stone inside and activate the pyrolysis
function, then at the end, when the stone has cooled down to lukewarm, wipe it
with a damp microfibre cloth to remove any residues.
Multifunction models the stone must be cleaned after every use. Do not heat it
again if it has any encrustations.
To clean, pour 55 cc of...

Instructions for the User
49
8.7 Pyrolysis: automatic oven cleaning (on some models only)
Pyrolysis is an automatic high-temperature cleaning procedure which causes
dirt to dissolve. Thanks to this process, it is possible to clean the inside of the
oven very easily.
During the first automatic cleaning cycle, unpleasant smells may occur due to the
normal evaporation of oily manufacturing substances. this is an absolutely normal
phenomenon which disappears after the first cleaning cycle.
Before starting...

Instructions for the User
50 Remove the guide frames, see “8.5.1
Removing guide frames”.
 At the end of the cleaning cycle, when
the oven has cooled down, reinsert
the frames by repeating the previously
used procedure in reverse order.
 Make sure that the oven door is firmly
closed.
Refer to the following diagram for setting the cleaning cycle duration:
CLEANING
DURATION
LIGHT DIRTMEDIUM DIRTHEAVY DIRT
90 MIN. 135 MIN. 180 MIN.
During the automatic cleaning cycle, the fans produce a more intense level...

Instructions for the User
51
8.7.2 Setting the cleaning cycle
In ON mode (see 6.5 Operating modes), turn the
ON/OFF knob right or left to select one of the two
cleaning cycles out of   and  .
(ON-OFF knob)
To start the cleaning cycle (pyrolysis), the
temperature selection knob must be pressed. 
will light up to indicate that it is now possible to set
the cycle duration.
(Temperature knob)
Turn the knob right or left to increase or decrease the
duration of the cycle between a minimum of 1h 30m
and a...