Stiga Royal Line 1171 HST 1381 HST 2222 99 Instructions Manual

51
ENGLISHEN
4.2 CHOKE (5)
Used when starting a cold engine: The choke has two 
positions:
1. The choke is open
2. The choke is closed (for cold starting)
4.3 PRIMER (4)
Pressing the rubber prime-starter squirts fuel into the 
carburettor intake pipe to make it easier to start a cold 
engine. 
4.4 IGNITION KEY (3)
Must be fully inserted or the engine will not start. Do not turn 
the key!
1. Key fully inserted – engine can start.
2. Key pulled out – engine cannot start.
4.5 STARTING HANDLE (1)
Manual cord...

52
ENGLISHEN
5 USING THE SNOW THROWER
5.1 GENERAL
Never start the engine until all the above measures under 
ASSEMBLY have been carried out. 
Never use the snow thrower without first reading 
and understanding the instructions and all the 
warning and instruction stickers on the machine. 
Always use protective goggles or a visor during 
use, maintenance and service.
5.2 BEFORE STARTING
Some snow throwers are delivered without oil in the engine. 
Fill the engine with oil before using. The oil is supplied...

53
ENGLISHEN
3b. Machines with an electric starter:
With the engine running, keep the start button pressed in 
for a few seconds to prevent the starting motor freezing 
(see above for connecting electric cable). An unusual 
rattling noise occurs. This does not damage the engine.
4. Push the throttle to the bottom to position  .
5. Remove the ignition key. Do not turn the key!
If the machine is left unattended, stop the engine 
and remove the ignition key. 
5.7 STARTING
1.  Start the engine as above. Let...

54
ENGLISHEN
6.2 OIL CHANGE
Change the oil the first time after 2 hours of operation, and 
subsequently every 50 hours of operation or once a season. 
Change oil when the engine is warm.
The engine oil may be very warm if it is drained off 
directly after the engine is shut off. So allow the 
engine to cool a few minutes before draining the 
oil.
1.  Lean the snow thrower slightly to the right so that the oil 
draining plug (14 in fig. 1) is the lowest point of the 
engine.
2.  Unscrew the oil draining...

55
ENGLISHEN
7.1 TROUBLESHOOTING
7.2 ADJUSTING THE SCRAPER BLADE AND 
SHOES
The scraper blade and shoes gets worn after a long term of 
use.
Adjust the scraper blade (always together with the shoes) 
until desired distance to the ground.
The scraper blade and the shoes are reversible and can be 
used on both sides.
See “5.8”.7.3 GENERAL ABOUT BELTS
The drive belts should be checked (and adjusted if required) 
for the first time after 2 – 4 hours use and then the middle of 
each season. They should...

56
ENGLISHEN
7.5 DRIVE BELT, HST
7.5.1 Adjusting the drive belt
1. Dismantle the belt cover (1) by loosing the screw (2). See 
fig. 16.
2. Adjust the tension pulley (A in fig. 20) until a belt play of 
about 45 mm. See fig. 23.
Do not overtighten the belt. This will damage the 
belt and the bearings. Always check the belt 
tension according to the instructions below before 
using the machine.
3. Check the adjustment according to the instructions 
below.
4. Reassemble the belt cover. See fig. 16.
7.5.2...

57
ENGLISHEN
9 IF SOMETHING BREAKS
Authorised service workshops carry out repairs and 
guarantee service. Always use genuine spare parts.
Do you carry out simple repairs yourself? Always use 
genuine spare parts. They fit perfectly and make the work 
much easier. 
Spare parts are available at your retailer and service station.
When ordering spare parts: Specify the model, year of 
purchase, the engine model and type number.
10 PURCHASE TERMS
A full warranty is issued against manufacturing and material...

58
FRANÇAISFR
1 SYMBOLES
Les symboles suivants figurent sur la machine. Ils attirent 
votre attention sur les dangers d’utilisation et les mesures à 
respecter. 
Explication des symboles :
Attention.
 Lire le mode d’emploi avant d’utiliser la machine.
 Danger – fraise en rotation.
 Danger – ventilateur en rotation.
 Écarter les mains de l’éjecteur.
Éloigner les mains et les pieds des éléments en 
rotation. 
 Respecter une distance de sécurité suffisante.
 Ne jamais orienter l’éjecteur vers des personnes...

59
FRANÇAISFR
• Ne pas déneiger à proximité de clôtures, véhicules, 
fenêtres ou sur des pentes escarpées sans adapter le 
déflecteur déjection. 
• Éloigner les enfants des zones à déneiger et confier leur 
surveillance à un adulte.
• Ne pas surcharger la capacité de la machine en tentant de 
déneiger trop rapidement.
• Faire attention en changeant de direction. Regarder 
derrière soi avant et pendant la marche arrière pour 
vérifier l’absence d’obstacles.
•  Ne jamais orienter l’éjecteur vers des...

60
FRANÇAISFR
3.7 VÉRIFICATION DES CÂBLES DE 
COMMANDE
Il peut être nécessaire de procéder au réglage des câbles 
avant la première utilisation.
Voir ci-dessous: RÉGLAGE DES CÂBLES
3.8 PRESSION DES PNEUS
Vérifier la pression des pneus. Voir”6.4”.
4 COMMANDES
Le pot d’échappement est équipé d’une grille de 
protection. Ne démarrer le moteur que si la grille 
est en place et intacte.
Vo i r  f i g u r e  1 .
4.1 RÉGLAGE DES GAZ (2)
Contrôle du régime moteur. Trois positions sont possibles :
1. Plein...