Stihl Ms230c Manual

{
STIHL MS 210, 230, 250
Instruction Manual
Manual de instrucciones
WARNING 
To reduce the risk of kickback injury 
use STIHL reduced kickback bar and 
STIHL PM3, PD3 (3/8 Picco) or RM3 (0.325“) 
chain depending on sprocket pitch or other 
available low kickback components.
ADVERTENCIA 
Para reducir el riesgo de lesionarse 
como resultado de un culatazo, utilice 
la barra de contragolpe reducido y la cadena 
PM3, PD3 (Picco de 3/8 pulg) o RM3 (0,325 
pulg) de STIHL, dependiendo de la rueda 
dentada usada...

Instruction Manual
1 - 70
Manual de instrucciones
71 - 146 

Original Instruction Manual Printed on chlorine-free paper
Printing inks contain vegetable oils, paper can be recycled. © ANDREAS STIHL AG & Co. KG, 2012
0458-208-8621-B. VA0.K12. 
0000001880_010_GB
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
1
{This instruction manual is protected by copyright. All rights reserved, especially the rights to reproduce, translate and process 
with electronic systems.
Contents
Allow only persons who fully understand 
this manual to operate your chain saw....

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
2
Pictograms
The meanings of the pictograms 
attached to or embossed on the 
machine are explained in this manual.
Depending on the model concerned, the 
following pictograms may be on your 
machine.
Symbols in Text
Many operating and safety instructions 
are supported by illustrations.
The individual steps or procedures 
described in the manual may be marked 
in different ways:
NA bullet marks a step or procedure.
A description of a step or...

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
3
WARNING
Reactive forces, including kickback, can 
be dangerous. Pay special attention to 
the section on reactive forces.
Have your STIHL dealer show you how 
to operate your power tool. All safety 
precautions that are generally observed 
when working with an ax or a hand saw 
also apply to the operation of chain 
saws. Observe all applicable federal, 
state and local safety regulations, 
standards and ordinances. When using 
a chain saw for...

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
4 These conditions reduce the hand's 
ability to feel and regulate temperature, 
produce numbness and burning 
sensations and may cause nerve and 
circulation damage and tissue necrosis.
All factors which contribute to white-
finger disease are not known, but cold 
weather, smoking and diseases or 
physical conditions that affect blood 
vessels and blood transport, as well as 
high vibration levels and long periods of 
exposure to vibration...

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
5 Be particularly alert and cautious when 
wearing hearing protection because 
your ability to hear warnings (shouts, 
alarms, etc.) is restricted.
Never operate your power tool unless 
wearing goggles or properly fitted 
protective glasses with adequate top 
and side protection complying with ANSI 
Z 87.1 (or your applicable national 
standard). To reduce the risk of injury to 
your face STIHL recommends that you 
also wear a face shield or...

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
6 allow any pressure build-up in the tank 
to release slowly. Never remove the fuel 
filler cap while the engine is running.
Select bare ground for fueling and move 
at least 10 feet (3 m) from the fueling 
spot before starting the engine. Wipe off 
any spilled fuel before starting your 
machine.
WARNING
WARNING
In order to reduce the risk of fuel spillage 
and fire from an improperly tightened 
fuel cap, correctly position and tighten 
the...

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
7 Screw Cap
WARNING
The screwdriver end of the STIHL 
combination wrench or other similar tool 
can be used as an aid in tightening 
slotted fuel filler caps.
See also the "Fueling" chapter in your 
Instruction Manual for additional 
information.
Before Starting
Take off the chain guard (scabbard) and 
inspect the saw for proper condition and 
operation. (See the maintenance chart 
near the end of the instruction manual.)
WARNING
Always...

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
8 With the first recommended method, the 
chain saw is started on the ground. 
Make sure the chain brake is engaged 
(see "Chain Brake" chapter in your 
instruction manual) and place the chain 
saw on firm ground or other solid surface 
in an open area. Maintain good balance 
and secure footing.
Grip the front handlebar of the saw firmly 
with your left hand and press down. For 
saws with a rear handle level with the 
ground, put the...