Home > Tascam > Music Mixer > Tascam FX D1000 Instrallation Manual

Tascam FX D1000 Instrallation Manual

Add to Favourites
    Download as PDF

    View the Tascam FX D1000 Instrallation Manual for free. All the Tascam manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . .INSTALLATION INSTRUCTIONS SOFTWARE LEVEL: Your TM-D1000 MUST be at software level 1.18 or higherfor this option to work properly. To check your software revision level: Power up the TM-D1000. 1) Press SHIFT and MEMO. The display should read: 2) Push DATA ENTRY button downwards 4 times until “SYSTEM” appears. 3) Rotate “DATA ENTRY(PUSH)” knob clockwise until the version appears. If the software version is LESS than 1.18, the...
    Page 2 FX-D1000 10/08/99 Page 2 of 6TASCAM TEAC Professional Division 7733 Telegraph Road Montebello, CA 90640 Phone (323) 726-0303 Fax (323) 727-7632INSTALLATION INSTRUCTIONS IMPORTANT WARNING!!! Special care should be taken when re-installing the bottom coverscrews. As the diagram above shows, the screws MUST be reinstalled in the same position as they wereremoved. Note the location of the special 5mm screw! If an 8mm screw is installed where the 5mm screwwas removed, the extra penetration by the 8mm...
    Page 3 FX-D1000 10/08/99 Page 3 of 6TASCAM TEAC Professional Division 7733 Telegraph Road Montebello, CA 90640 Phone (323) 726-0303 Fax (323) 727-7632INSTALLATION INSTRUCTIONS DetachAttachinto the plastic case supplied with the new PLD. Place it into the postage paid self-addressed envelope provided and return to TASCAM. Thank you! STEP 4: Installing the new PLD: CAUTION: The PLD is sensitive to static discharges and may bedamaged if improperly handled. It is highly recommended that the installer be well...
    Page 4 FX-D1000 10/08/99 Page 4 of 6TASCAM TEAC Professional Division 7733 Telegraph Road Montebello, CA 90640 Phone (323) 726-0303 Fax (323) 727-7632INSTALLATION INSTRUCTIONS STEP 7:Remove the FX-D1000 from its anti-static wrapping. Holding the FX-D1000 by its edges, orientit as shown in Figure 1.3. The component side of the board should be on the bottom. STEP 8:The connector on the FX-D1000 should be inserted into connector CN5 on the main PCB. Fit thethree retaining studs you installed into the Main PCB...
    Start reading Tascam FX D1000 Instrallation Manual

    Related Manuals for Tascam FX D1000 Instrallation Manual

    All Tascam manuals