Toshiba C55a Manual

2. Grasp the disc tray gently and pull until it is fully opened.Figure 4-2 Pressing the eject button and pulling the disc tray open1. Eject button2. Disc tray
3. Lay the disc, label side up, in the disc tray. Figure 4-3 Inserting a disc
1. Laser lensWhen the disc tray is fully opened, the edge of the computer covers the
disc tray slightly. Therefore, you must turn the disc at an angle when you place it in the disc tray. After seating the disc, however, make sure it liesflat.Do not touch the laser lens or...

If the disc is not seated properly when the disc tray is closed, the disc might
be damaged. Also, the disc tray might not open fully when you press the
eject button.
Removing discs
To remove the disc, do the following:
Do not press the eject button while the computer is accessing the optical disc drive. Wait for the optical disc drive indicator to go out before you openthe disc tray. Also, if the disc is spinning when you open the disc tray, wait
for it to stop before you remove it.
1. To pop the disc...

Writable discsThis section describes the types of writable discs. Check the specificationsof your drive to see the types of discs it can write.
CDs
CD-R discs can be written only once. The recorded data cannot be
erased or changed.
CD-RW discs including multi speed CD-RW discs, high-speed CD-RW
discs and ultra-speed CD-RW discs can be recorded more than once.
DVDs
DVD-R, DVD+R, DVD-R DL and DVD+R DL discs can be written only
once. The recorded data cannot be erased or changed.
DVD-RW, DVD+RW and DVD-RAM...

Disclaimer
TOSHIBA does not assume responsibility for the following:
Damage to any disc that might be caused by writing or rewriting with
this product.
Any change or loss of the recorded contents of media that might be
caused by writing or rewriting with this product, or for any business
profit loss or business interruption that might be caused by the change or loss of the recorded contents.
Damage that might be caused by using third party equipment or
software.
Given the technological limitations of...

DVD-RW:
DVD Specifications for Recordable Disc for Version 1.1 or version 1.2
MITSUBISHI KAGAKU MEDIA CO., LTD. (for 4x and 6x speed media)DVD+RW:
MITSUBISHI KAGAKU MEDIA CO., LTD. (for 4x and 8x speed media)DVD-RAM: (DVD Super Multi drive only)
DVD Specifications for DVD-RAM Disc for Version 2.0, Version 2.1 or
Version 2.2
Panasonic Corporation (for 3x and 5x speed media)BD-R:
Panasonic CorporationBD-R DL:
Panasonic CorporationBD-RE:
Panasonic CorporationBD-RE DL:
Panasonic CorporationBD-R TL:
TDK...

Do not perform any of the following actions:
Change users in the Operating Systems.
Operate the computer for any other function, including such tasksas using a mouse or Touch Pad, or closing/opening the display
panel.
Start a communication application.
Apply impact or vibration to the computer.
Install, remove or connect external devices, including such items
as a memory media card, USB device, external monitor or an optical digital device.
Use the audio/video control button to reproduce music or voice....

Do not play back video while watching or recording television
programs using other applications. Failure to do so might cause video
playback or television program recording errors. In addition, if
prescheduled recording starts during video playback it might cause
video playback or television program recording errors. Please view
video during times when there is no recording prescheduled.
The resume function cannot be used with some discs on the
CyberLink PowerDVD for TOSHIBA.
It is recommended that the...

Do not change the display device while running the CyberLinkPowerDVD for TOSHIBA.
Starting CyberLink PowerDVD for TOSHIBA Use the following procedure to start CyberLink PowerDVD for TOSHIBA.1. Insert a DVD-Video in the optical disc drive while the operating system is running.
When a DVD-Video disc is set in the DVD drive (for models with DVD drive), CyberLink PowerDVD for TOSHIBA might start automatically.
2. Click  CyberLink PowerDVD for TOSHIBA  in the Apps view to start
CyberLink PowerDVD for...

Make sure to connect the AC adaptor of the computer when playing a
video.
TOSHIBA Blu-ray Disc Player supports AACS (Advanced Access
Control System) copy protection technology. Renewal of the AACS
key integrated into this product is required for uninterrupted enjoyment
of Blu-ray Disc™. An Internet connection is required for renewal.
AACS key renewal is provided free of charge for 5 years after the purchase of this product, however renewal beyond 5 years is subject
to conditions specified by the software...

Display Devices & Audio
If the video image is not displayed on an external display or television,stop the TOSHIBA Blu-ray Disc Player, and change the screen resolution. To change the screen resolution, click  Control Panel ->
Appearance and Personalization -> Display -> Adjust resolution
under  Windows System  group in the Apps view. However, video
cannot be output to some external displays and televisions due to
output or playback conditions.
When viewing video on an external display or TV, change the...