Toshiba Projector Tdp P75 User Manual

							
 
English
Owner’s Manual
DATA Projector
TDP-P75 
						

							SAFETY PRECAUTION   2 
English
SAFETY PRECAUTION
The lightning flash with arrowhead symbol, within an equilateral triangle, is 
intended to alert the user to the presence of uninsulated dangerous voltage 
within the products enclosure that may be of sufficient magnitude to constitute 
a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user 
to the presence of important operating and maintenance (servicing) 
instructions in the literature accompanying the appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT 
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH 
VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN 
THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
WARNING: Handling the cord on this projector, or the cords associated with accessories 
sold with this projector, will expose you to lead, a chemical known to the State 
of California to cause birth defects or other reproductive harm. Wash hands 
after handling. 
WARNING: The lamp used in this projector contains mercury. Disposal of mercury may be 
regulated due to environmental considerations. For disposal or recycling 
information, please contact your local authorities or the Electronic Industries 
Alliance: www.eiae.org.
MODEL NAME: TDP-P75 
FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to 
the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation. This 
equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communications.
However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures: TRADE NAME: DATA PROJECTOR                     MODEL NAME: TDP-P75
Te s t e d  To  C o m p l y
With FCC Standards
FOR HOME OR OFFICE USE
USA only
USA only
USA only 
						

							SAFETY PRECAUTION3 
English
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RESPONSIBLE PARTY: TOSHIBA AMERICA INFORMATION SYSTEMS, INC.
 9470 Irvine Blvd., Irvine, CA 92618-1697 U.S.A
 Phone: (949) 583-3000
WARNING:  Changes or modifications made to this equipment, not expressly approved 
by Toshiba, or parties authorized by Toshiba, could void the user’s authority 
to operate the equipment.
Notice:        This Class B digital apparatus complies with Canadian ICES-003. Cet 
appareil numérique de la classe B est conforme à la norme NMB-003 du 
Canada.
USA only
CANADA only 
						

							IMPORTANT SAFETY INSTRUCTIONS   4 
English
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS 
GIVEN IN THIS OWNERS MANUAL AND THOSE MARKED ON THE UNIT. 
RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
This set has been designed and manufactured to ensure personal safety. Improper use 
can result in electric shock or fire hazard. The safeguards incorporated in this unit will 
protect you if you observe the following procedures for installation, use and servicing. This 
unit is fully transistorized and does not contain any parts that can be repaired by the user.
DO NOT REMOVE THE CABINET COVER OR YOU MAY BE EXPOSED TO 
DANGEROUS VOLTAGE. REFER SERVICING TO QUALIFIED SERVICE 
PERSONNEL ONLY. 
1. Read owners manual
After unpacking this product, read the 
owners manual carefully, and follow 
all the operating and other 
instructions.
2. Power sources
This product should be operated only 
from the type of power source 
indicated on the marking label. If you 
are not sure of the type of power 
supply to your home, consult your 
product dealer or local power 
company. For products intended to 
operate from battery power or other 
sources, refer to the operating 
instructions.
3. Source of light
Do not look into the lens while the 
lamp is on. The strong light from the 
lamp may cause damage to your eyes 
or sight.
4. Heat
The product should be situated away 
from heat sources such as radiators, 
heat registers, stoves, or other 
products (including amplifiers) that 
produce heat. 
						

							IMPORTANT SAFETY INSTRUCTIONS5 
English
 
5. Ventilation
Openings in the cabinet are provided 
for ventilation to ensure reliable 
operation of the product and protect it 
from overheating. These openings 
must not be blocked or covered. The 
openings should never be blocked by 
placing the product on a bed, sofa, rug 
or other similar surface. This product 
should not be placed in a built-in 
installation such as a bookcase or 
rack unless proper ventilation is 
provided or the manufacturers 
instructions have been adhered to.
6. Water and moisture
Do not use this product near water (for 
example, near a bath tub, wash bowl, 
kitchen sink, or laundry tub; in a wet 
basement; or near a swimming pool).
7. Cleaning
Unplug this product from the wall 
outlet before cleaning. Do not use 
liquid cleaners or aerosol cleaners. 
Use a soft cloth for cleaning.
8. Power cord protection
Power-supply cords should be routed 
so that they are not likely to be walked 
on or pinched by items placed upon or 
against them, paying particular 
attention to cords at plugs, 
convenience receptacles, and the 
point where they exit from
the product.
9. Overloading
Do not overload wall outlets; extension 
cords, or integral convenience 
receptacles as this can result in a risk 
of fire or electric shock.
10. Object and liquid entry
Never push objects of any kind into 
this product through the openings, as 
they may touch dangerous voltage 
points or short-out parts that could 
result in a fire or electric shock. Never 
spill liquid of any kind on the product. 
						

							IMPORTANT SAFETY INSTRUCTIONS   6 
English
11. Lightning storms
For added protection for this product 
during a storm, or when it is left 
unattended and unused for long 
periods of time, unplug it from the 
wall outlet. This will prevent damage 
to the product due to lightning and 
power line surges. However, while it 
is thundering or lightning, do not 
touch the apparatus and any 
connected cable and/or equipment. 
This will prevent you from receiving 
the electric shock by an electric 
surge.
12. Do not place the product 
vertically.
Do not use the product in the upright 
position to project pictures at the 
ceiling, or any other vertical 
positions. The product may fall over, 
causing personal injury or product 
damage.
13. Attachments
Do not use attachments not 
recommended by the product 
manufacturer, as they may cause 
hazards.
14. Do not stack components.
Do not stack other equipment on this 
product or stack this product on 
other equipment. The top and 
bottom surfaces of this product 
develop heat and may damage the 
other unit.
15. Accessories
Do not place this product on an 
unstable cart, stand, tripod, bracket, 
or table. The product may fall, 
causing serious injury to a child or 
adult, and serious damage to the 
product. A product and cart 
combination should be moved with 
care. Quick stops, excessive force, 
and uneven surfaces may cause the 
product and cart combination to 
overturn.
S3125A 
						

							IMPORTANT SAFETY INSTRUCTIONS7 
English
16. Damage requiring service
Unplug this product from the wall outlet 
and refer servicing to qualified service 
personnel under the following 
conditions: 
a) when the power-supply cord or plug is 
damaged;
b) if liquid has been spilled or objects 
have fallen into the product;
c) if the product has been exposed to rain 
or water;
d) if the product does not operate 
normally by following the operating 
instructions (adjust only those controls 
that are covered by the operating 
instructions as an improper adjustment 
of other controls may result in damage 
and will often require extensive work 
by a qualified technician to restore the 
product to its normal operation);
e) if the product has been dropped or 
damaged in any way; or
f) when the product exhibits a distinct 
change in performance.
17. If glass components, 
including the lens and lamp, 
should break, contact your 
dealer for repair service.
This product incorporates glass 
components, including the lens and 
lamp. If such parts should break, 
please handle with care to avoid injury. 
Contact your dealer for repair service. 
The broken pieces of glass may cause 
injury. In the unlikely event of the lamp 
rupturing, thoroughly clean the area 
around the projector and discard any 
edible items placed in that area.
18. Servicing
Do not attempt to service this 
product yourself, as opening or 
removing covers may expose you 
to dangerous voltage or other 
hazards. Refer all servicing to 
qualified service personnel.
19. Replacement parts
When replacement parts are 
required, be sure the service 
technician has used replacement 
parts specified by the 
manufacturer or that have the 
same characteristics as the 
original part. Unauthorized 
substitutions may result in fire, 
electric shock, or other hazards.
(The lamp is the only 
user-replaceable part.)
20. Safety check
Upon completion of any service or 
repairs to this product, ask the 
service technician to perform 
safety checks to determine that the 
product is in proper operating 
condition. 
						

							POWER SUPPLY CORD SELECTION   8 
English
POWER SUPPLY CORD SELECTION
If your line voltage is 220 to 240V, use one of the following types of cable.
21. Do not leave thermal-paper 
documents or easily 
deformed items on top of the 
unit or near the air exhaust 
for long periods of time.
The heat from the unit could erase the 
information on the thermal paper, or 
cause deformation or warping.
22. Do not use the product in a 
closed installation state.
Do not place the product in a box or in 
any other closed installation state. 
Otherwise it may overheat. This could 
result in a risk of fire.
Plug 
configurationPlug type Line 
voltagePlug 
configurationPlug type Line 
voltage
EURO 220 - 240V Australian
240V
10A200 - 240V
UK 220 - 240V Switzerland
240V
6A200 - 240V
Use a 5A fuse approved by ASTA or BSI 
to BSI362.
Always replace the fuse cover after
changing the fuse.North 
American
240V
10A200 - 240V 
						

							IMPORTANT PRECAUTIONS9 
English
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever 
have to ship your projector. For maximum protection, repack the set as it was 
originally packed at the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm 
location. When the unit is exposed to such a change in temperature, moisture 
may condense on the crucial internal parts. To prevent the unit from possible 
damage, do not use the unit for at least 2 hours after there is an extreme or 
sudden change in temperature.
Location and Installation
•  Do not place in hot locations, such as near a heater. Doing so could cause 
malfunction and shorten the life of the projector.
•  Avoid locations with oil or cigarette smoke, which can affect the quality and 
useful life of the product’s optical parts and darken the screen.
•  Do not use the product vertically in any upright position or slantwise at an angle 
of 20 degrees or more.
•  Using this product near a TV or radio may cause interference in the image or 
sound. If this happens, move it away from the TV or radio.
•  In a high-altitude location where the air is thin, cooling efficiency is reduced; 
therefore, use the projector in a cool area.
Avoid Volatile Liquids
Do not use volatile liquids, such as an insect spray, near the unit. Do not leave 
rubber or plastic products touching the unit for a long time. They will leave marks 
on the finish. If cleaning with a chemically saturated cloth, be sure to follow the 
products precautions.
In the spaces provided below, record the model and serial numbers located at the 
bottom of your projector.
Model No.  Serial No.
Retain this information for future reference. 
						

							EXEMPTION CLAUSES   10 
English
EXEMPTION CLAUSES
•  Toshiba Corporation bears no responsibility in the case of damages arising from 
natural disaster such as earthquakes, lightning, etc., fire not liable to Toshiba 
Corporation, acts by third parties, other accidents, or use under abnormal 
conditions including erroneous or improper operation and other problems.
•  Toshiba Corporation bears no responsibility for incidental damages (lost profit, 
work interruption, corruption or loss of the memory contents, etc.) arising from 
the use of or the inability to use this unit.
•  Toshiba Corporation accepts no liability whatsoever for any damages arising 
from not having followed the descriptions in this Instruction Manual.
•  Toshiba Corporation accepts no liability whatsoever for any damages arising 
from malfunctions arising from combination with equipment or software that is 
not related to Toshiba Corporation.