Toshiba Strata S Electronic Key Telephone System Installation And Maintenance Manual

SYSTEM PROGRAMMING 
JULY 1994 
PROGRAM lo-PBX BACKUP 
 
KEY/LED X 
co3 
co2 
co1 
X = Connected to PBX line (LED on) 
Initialized Date: All LEDs off 
PROGRAM 1X-PBX ACCESS CODES 
CODE 
#l(ll) 
#2(12) 
#3(131 
#4(14) 
#5(15) 
#6(16) 
#7(17) 
#a(181 
NOTE: 
Enter Access Codes (maximum: 8) 
Initialized Data: None 
If the access code is a single dig& enter s’*Os in the second column. If all . 
combinations following a particular first digit are to be considered access 
codes (e.g., 91,92,93, etc.J, enter “D”...

SYSTEM PRUGNAMMlNG 
‘. 
JULY 1986 
PROGRAM 3XX-STATlON CO UNE ACCESS 
X = Select (LED on) Initialized Data: All LEDs on 
PROGRAM 4XX-STATION TYPE and FLEXIBLE KEY ASSIGNMENT 
(See Fiiure 1) 
X = Select (LED on) Initialized Data: INT LED on; all other LEDs off 
PROGRAM 5XX-STATION CLASS OF SERVICE 
. 
I I 
IIlIIIIlJ 
X = Select (LED onj Initialized Data: COs 3 & 1 & INT LEDs on; other LEDs off 
PROGRAM GXX-TOLL RESTRICTION CLASSIFICATION 
X = Select (LED on) Initialized Data: No Restriction  

SYSTEM PROGRAlWMlNG 
JULY 1984 ‘. 
PROGRAM 7XX-STATION OUTGOING 
e.. CALL RESTRICTION 
KEY/LED FEATURE STATION NUMBWS _ 
10 11 12 13 14 1116Y7 
co3 ReNliued 
co2 Restriclad 
CO1 Restriuad 
X = Select (LED on) Initialized Data: All LEDs off 
PROGRAM SXX-CO RINGING ASSIGNMENTS-DAY 
X = Select (LED on) Initialized Data: Station ID-all LEDs on; all others off 
PROGRAM 9xX-CO RINGING ASSIGNMENTS-NITE 
1 
X = Select (LED on) Initialized Data: Station 1 l-all LEDs on; all others off 
,. -  

TOSHBA SYSTEM PRACTICES 
ELECTRONIC KEY TELEPHONE SYSTEM OPERATING PROCEDURES 
SECTION 100-003-49D 
JULY 1994 
Strata S 
OPERATING PROCEDURES 
.  

TOSHIBA SYSTEM PfWTiCES 
ELECTRONIC KEY TELEPHONE SYSTEM 
m.. - 
OPERATING PROCEDURES 
SECTION 100-00340 
JULY 1984 
Strata S 
OPERATING PROCEDURES 
TABLE of CONTENTS 
PARAGRAPH 
SUBJECT PAGE 
01 
02 
02.00.0 
03 
03.00.0 
03.01 .o 
04 
05 
05.00.0 
05.01 .o 
06 
06.00.0 
06.01 .O 
06.02.0 
06.03.0 
06.04.0 
06.05.0 
06.06.0 
06.07.0 
06.08.0 
06.09.0 
06.10.0 
. 06.11.0 
06.12.0 
07 
07.00.0 
07.10.0 
07.20.0 
07.30.0 
07.40.0 
07.50.0 TABLE of CONTENTS ........................ 
INTRODUCTION...

P 
OPERATING PROCEDURES 
SECTlOW lOO40340 
JULY 1984 
e.. 
01 INfitODUCTlOfi 03 VOLUME CONTROLS 
01 .OO.l The operations of the various Struts 
S electronic key telephones (EKT) will be 
des- 
cribed in this section. These EKTs are specially 
designed telephones 
and are connected to the 
system using industry standard 2-pair wiring. 
02 KEY FUNCTIONS 
02.00.0 Standard Key Functions 
02.00.1 The standard Strata S EKT has 
either 13 or 14 line and feature keys and a push- 
button dial pad. The following...

OPERATING PROCEDURES 
SECTION 100-003-400 
JULY 1994 - 
05 MESSAGE WAITING 
0500.0 Message Center 
Station 10 or 11 on& 
0500.1 To use Message Waiting 
1) Call the appropriate station on intercom. _ _ 
2) If no answer, depress the IMW/FI] key on the 
Message Center EKT. 
l This illuminates the MW/FL LEDs on 
both EKTs. 
3) Hang up. 
l This extinguishes the Message Center 
MW/FL LED (LED on called station re- 
mains lit). 
05.00.2 To clear the MW/FL LED on the called 
EKT from the Message Center 
06...

v.. 3) Dial the desiredstation. . 
8 You will hear a single ring tone. 
4) Speak when the ring tone ends. 
5) Hang up when the call is completed. 
NOTE: 
Tone signalling is accomplished by dialing 
q aher the station number. An intercom call 
may be answered a? any station. 
06.01.2 To receive an intercom call 
1) You will hear a single long tone, followed by 
the caller’s voice. 
8 The INT LED will flash at the l-called rate. 
3) Dial the desired station number. 
4A) If you hear a single ring tone,...

OPERATlNG PROCEDURES 
SECTION 100-003-400 
itulY 1994 
06.05 .O Conferencing 
06.05.1 To conference one station and two 
CO lines 
1) 
2) 
3) 
4) 
5) 
6) 
7) 
8) 
9) 
Lift the handset. 
Depress any available a key. 
Dial the desired telephone number. 
Depress the Iml key after the called party 
answers. 
Depress a second available m key. 
Dial the second party’s telephone number. 
Depress the ml key after the second 
party answers. 
Depress the 
original [col key. 
l Station is now connected to both CO...

1- 
06.06.0 Automatic Dialing 
06.06.1 To dial a frequently called number 
automatically 
NO JE: 
See Paragraph 07.04.0 for optional key 
usage. 
A) Using the 
q key. 
1) Lii the handset. 
2) Depress any available m key. 
l Listen for dial tone. 
3) Depress the 
q key. 
4) Dial the 2-digit address code that corres- 
ponds to the desired telephone number. 
l Strata Swill automatically dial the 
number for you. 
5) Hang up when the call is completed. 
B) Using an m key. 
1) 
2) 
3) 
4) Lii the handset....