Toshiba Wt10-a Manual

The AC adaptor should not be disconnected with the "USB Data and
Charge Y-Cable" if it is connecting with USB device and tablet at the
same time. If the USB device works with USB bus power, which
comes from "USB Data and Charge Y-Cable", the disconnection of AC
adaptor would cause power loss. Even if the USB device has its own
power source, the device will stop around 60 miliseconds because
USB controller would detect with “no bus power” due to sudden
disconnection with AC adaptor. The...

2. Plug the other smaller end of the HDMI cable into the Micro HDMI port
on your tablet.
3.
Turn the HDMI display device's power on. Figure 4-5 Connecting an HDMI cable 1. Micro HDMI port
2. HDMI cable (Type D connector)Please do not plug/unplug an HDMI device under the following conditions:
The system is starting up.
The system is shutting down.
When you connect a television or external monitor to the Micro HDMI port,
the display output device is set to HDMI.
When you unplug the HDMI cable and...

While data is being read or written.
While communication is being carried out.Selecting HD Format
To select the display mode, follow the steps as detailed below:
1. Tap Desktop Assist -> Control Panel -> Appearance and 
Personalization -> Display -> Change display settings ->
Advanced settings -> List All Modes
2. Select one of the modes at List All Modes.
Wireless display Your tablet supports Wireless display, a wireless technology which utilizes
Wi-Fi to allow the tablet to be wirelessly connected to...

You can also manually manage how the external displays will work and
change the display settings by tapping  Projector in the Devices charm. If
you disconnect the external display before you turn the tablet's power off,
be sure to switch to the internal display.
TOSHIBA Bluetooth Keyboard for Encore 2 TOSHIBA Bluetooth Keyboard for Encore 2 is provided with some models
of TOSHIBA WT10-A. It provides Bluetooth keyboard with powerful
features and great convenience when using your tablet.
Grand tour The...

Figure 4-7 Magnets location (Keyboard)
Product appearance depends on the model you purchased.
The Keyboard contains magnets that may interfere with pacemakers,
defibrillators or other medical devices. If you wear a pacemaker, keep at
least 6 inches (approximately 15cm) of separation between your medical
device and the Keyboard. If you suspect that the Keyboard is interfering
with your medical device, discontinue use and consult your physician for
information related to your specific device. The circled...

Setting up the Keyboard
Fit your tablet into the Keyboard properly. The Keyboard supports two
modes when using it.Stand mode
You can put your tablet onto the Keyboard cover and operate like a laptop
when in this mode. Figure 4-8 Stand modeProduct appearance depends on the model you purchased.
Portable mode
This mode provides you the convenience to carry the Keyboard and
prevent damange or scratch to it.
Figure 4-9 Portable modeProduct appearance depends on the model you purchased.
Charging the Keyboard...

To charge the Keyboard, you can use the provided AC adaptor and Micro-
USB cable. Please follow the steps as detailed below to charge the
Keyboard:
1.
Plug the USB connector of the Micro-USB cable into the AC adaptor.
2. Plug the the smaller connector of the Micro-USB cable into the Micro- USB port on your Keyboard.
Figure 4-10 Charging the Keyboard Product appearance depends on the model you purchased.
3.

Plug the AC adaptor into a live wall outlet.
A full charge takes about 3 hours. If you are not...

If you want to pair more than one Keyboard with your tablet, it is
recommended to do pairing one by one.
One Keyboard only supports one tablet in Bluetooth connecting.
To manually disconnect the Keyboard, tap 
Bluetooth Keyboard and
tap Remove device . The touch pad may not work properly by immediate use after turning
on the Bluetooth keyboard. If it happens, please turn off/on the
keyboard again and wait for over three seconds.
Reconnecting the Keyboard Under any of the following conditions, the...

Pinch or stretch
Place two fingers down on the Touch Pad and
move them toward each other (pinch) or away
from each other (stretch). This will show different
levels of information or visually zooms in or out. Two-Finger Scroll
Place two fingers down and slide them vertically
or horizontally from anywhere on the Touch Pad.
This allows you to operate the scroll bars of a
window. Swipe
Quickly move your finger in from the edge of the
Touch Pad, without pausing when you first touch
it.
Swipe from the left...

Special
function mode
Standard F1-
F12 modeFunction
F4 FN + F4 Changes the active display device.
To use a simultaneous mode, you
must set the resolution of the internal
display panel to match the resolution
of the external display device.
F5 FN + F5 Enables or disables the Touch Pad.
F6 FN + F6 Moves media backward.
F7 FN + F7 Plays or pauses media playback.
F8 FN + F8 Moves media forward.
F9 FN + F9 Decreases the computer's volume.
F10 FN + F10 Increases the computer's volume.
F11 FN + F11...