Vodavi Starplus 1224ex Electronic Key System Installation Manual

‘. .‘., ‘> .,.. ‘...,;:.:..,;.” _’ 8. , c 
.-I . ...-,. .,.,, ‘in,,.+ 
--STARPLUS 1224EX KEY TELEPHONE SYSTEM 
DIALING SPECIFICATIONS 
DTMF DIALING 
Frr~y Deviation 
Duration of DTMF Signal 
Interdigit Time 
PULSE DIALING 
Pulse Dialing Rate @rogrammaMe) 
Percent Break/Make (programmable) 
DIALING MEMORY 
System Speed Dialing 
Station Speed Dialing 
Last Number Red&l 
Save Number Redial 
co Type +/- 1 Hz 
:: msec. 
i 00 msec minimum 
100 msec minimum 
i0 or20 pps 
60/40 or 66/33 
So numbers (16 digit)...

STARPLUS 1224EX KEY TELEPHONE SYSTEM 
Pl 
POWER FAILURE TFtANSFhi 
c ’ , w LINE 
THAU 
CO LINE 1 Co LINE 
CO LINE 
es-- 
-1  ---_ 
MUSIC ON HOLD 
J3 . EXTERNAL PAGE 1 ---_ 
-m-w 
---- 
---- 
---- 
---_ 
-m-v 
---- 
-e-v 
---- 
---_ 
---- 
---_ 
==L= 
---- 
---- 
---- 
m 
ITI 
11111111111111 lllllll lllllll llllll 
STARPLUS 
1224Ex  . 3 Pl ---_ 
---- 
---- 
---- 
---- 
---- 
---- CONTROL CONTACT 4 
f 
I ==== 
---- 
---- 
---- 
==== 
-- 
==,- 
1 BATTERY INPUT 
fi 
1 
AC CONNECTION 
W/SURGE PROTECTOR  Jl...

. : _,.., ,\.. __ _..,_ id..,‘._...,.__...: .‘.I _ .‘, .,_.. .I, ,. 
- 
STARPLUS 1224EX .-- KEY TELEPHONE SYSTEM 
RJllC CONNECTORS 
FOR CO LINE 
CONNECTIONS 
POWER FAILURE 
PI 
TRANSFER 
8 BGM 
I--; ADJ. 
’ MOH 
0 ADJ. 
MDF 
BATTERY BACK-UP 
CONNECTOR 
AC WWER’ 
CORD 
KSU - left side 
Figure 4.2 
JULY 1989 
4-6  

.,-, ,, : .,.i_. _.,_..,.,.~J_ WC< . . ::. ‘. . . : ‘. . , ._, .A. _.... 
. .*..a....: 
STARPLUS 1224EX KEY TELEPHONE SYSTEM 
500 lNST’ALlATlON 
500.1 SITE PLANNING 
The STARPLUS 1224EX Electronic Key Telephone 
System, like most electronic office equipment, 
should not be subjected to harsh environmental 
conditions. To assure easy servicing and relhble 
operation, several factors must be considered 
when planning the system installation. Always 
consider the following BEFORE installing the KSU 
and...

STARPLUS 1224= KEY TELEPHONE SYSTEM 
E. The AC power cord should not be used with 
a 3-wire-to-2wire plug adapter. Do not use ex- 
tension cords. A power line surge protector 
should be used to protect the power supply from 
electrical surges. The surge protector should 
be installed in accordance with the 
manufacturer’s instructions and applicable 
electrical codes. 
WAFiNING: DO NOT PLUG IN THE POWER CORD 
AT THIS TIME. 
500.5 KSU CABLING 
Four amphenol type connectors are provided on 
the left side...

_I I . . . . \..,. r~..:!~-r..,‘.... ..- . . . -, ‘,,.. . * 
STARPLUS 1224EX 
_ KEY TELEPHONE SYSTEM 
G. The telephone can now be mounted to the 
wail by matching the 2 keyhole slots on the 
baseplate with the lugs on the modular cover as- 
sembiy. Check to make sure that the modular 
connector on the baseplate is firmly connected 
to the wall jack. 
500.9 PHONE BOX INSTALLATION 
The 1224 Phone Box can make calls to preas- 
signed stations as well as receive intercom calls. 
The unit should be located in...

. 
?F 
&, 
STARPLUS 1224Ex KEY TELEPHONE SYSTEM 
500.14 LOUD BELL CONTROL/A- 
LEAD INDICATION 
delays or improper loading. A step-by-step 
checklist is provided for this purpose: 
The STARPLUS 
1224 system provides relay con- 
tact closure to activate external signaling equip- 
ment during incoming CO line ringing. The station 
or CO line that is to signal is selected by program- 
ming (see Section 600). A. Make sure that the KSU is properly grounded 
according to the instructions in Section 566.3. 
8....

1 . 
.., ,:,., :,L.>c,, ., i.. , . . . ._ __,. ,__il 
.-‘.. -.._ ia. 
STARPLUS 1224EX KEY TELEPHONE SYSTEM 
KSU. The baud rate is programmable in data base 
programming (300 or 1266 baud). 
5.1 
g RCU INSTALLATION 
A. Turn OFF power to KSU by unplugging from AC 
outlet. 
B. Remove program 
mdUk. 
C. Remove screws holding the KSU cover. 
Remove the cover. 
0. Open the RCU box and verify the contents: 
_ 1 each RCU module 
- 1 each battery 
_ 1 each plastic beaded tiewrap 
E. Locate the battery. The end...

STARPWS 1224u< KEY TELEPHONE SYSTEM 
. 
. 
?n 
‘.’ < 
w 
I - 
/ . 
D. Power Requirements 
_ Input: 117 VAC, 68 Hz 
_ Fused at 0.5 A, 250 V 
E. Environment 
- Temperature: O-50 C 
_ Humidity: 0.96% 
Ill. INSTALLATION 
A. Introduction 
See Figure 5.8 for the location of the input socket. 
The input socket of the key system must be a 
female Mate-N-Lok type connector. 
B. Installation Checklist 
The following items are required to install the BBU: 
- 1 BBU with wire kit (5 wires) and tlewrap 
- 4 No. 12...