Vodavi Starplus 96ex Hybrid Key Telephone System Installation Manual

C. Dial parking location (790 to 795) where the  C. If you hear busy tone, press TRANS and dial 
call was parked.  another parking location. 
Retrieving a Parked Call 
A. Lift handset or press ON/OFF button. 
B. Dial pound [#I]. 
300.17 CALL PICK-UP: GROUP 
When intercom tone ringing, transferred outside 
line ringing, or recall ringing is heard at an unat- 
tended telephone: 
A. Lift the handset or press the ONIOFF button, 
B. Dial [281] on the dial pad or press the pre-pro- 
grammed PICK UP button to...

A. Go on-hook with present call. Camp-On wili 
ring through, or 
B. Place present call on hold. Then go on-hook. 
Camp-On will ring through. 
300.21 CO LINE ACCESS 
To access outside line: 
A. Press idle CO line button, Pool button, or dial 
CO line group access code or LCR access 
code. 
B. Dial number desired for outside call. 
C. Lift handset to converse or use speaker- 
phone. 
. 300.22 QUEUING 
A station can queue only one line at a time. If you 
see that a particular outside line is busy and you...

sTARPLUS@ 96EX Key Telephone System 
button must be programmed for this feature !o 
operate. Refer to flex button programming. 
300.25 DIRECT INWARD SYSTEM AC- 
CESS (DISA) 
A. Call the phone number or the system admin- 
istrator specified of the DISA line. 
B. The system answers and returns intercom 
dial tone. 
C. Enter the DISA access code also specified by 
the system administrator, if applicable. 
D. Dial tone is returned. 
To place an outgoing call: 
A. Dial a group access code: 9,81 - 87. 
B. CO...

%ARPLUS@ 96EX Key Telephone System 
300.29 EXECUTIVE/SECRETARY TRANS- 
FER 
If you are designated the Executive station and 
your phone is busy or in DND, all calls will be 
routed to the Secretary station. 
If you are the designated Secretary station, you 
can signal the Executive that is busy or in DND by 
using the Camp On feature. 
300.30 FLASH 
When connected to an outside line: 
A. Press FLASH button to disconnect outside 
line and reseize outside line dial tone. . 
300.31 FLASH ON INTERCOM 
When...

sTARPLUS@ 96EX 
Key Telephone System 
To program flexible buttons: 
A. Press SPD button twice. 
B. Press the assigned button to be programmed 
(it must be programmed in data base as a 
multi-function button). 
C. Dial desired code (Refer to Button Program- 
ming Codes). 
To erase a flexible button: 
A. Press SPD button twice. 
B. Press the button to be erase 
C. Press FLASH button. 
D. Replace handset or press ON/OFF button. 
300.33 HEADSET MODE 
If you wish to use a headset and have been given 
the...

STA~PLUS@ 96EX 
Key Telephone System 
. 
lf no lines are available in the same group, station 
will receive busy tone and can queue for a line. 
if the station user preselects a line before activat- 
ing LNR, the preselection will override the line 
which was used originally. 
300.37 LEAST COST ROUTING 
To place an outside call when LCR has been 
enabled in the system: 
A. Dial [9]. 
B. Dial desired telephone number (ie: I+ area 
code+number) 7-digit number. 
C. Wait for answer. Lift handset or use...

*2 Internal Zone 2 
*3 Internal Zone 3 
*4 internal Zone 4 
*5 Internal All Call 
*6 External Zone 
l 0 All Call 
C. Speak in normal tone of voice to deliver mes- 
sage. 
Stations off-hook or in DND will not hear the page 
announcement. 
NOTE: When making a zone page or All Call page 
and the zone is busy, fhe page initiafor will receive 
ringback fone until fhe zone becomes available. 
You will then hear a warning fone and an make 
the page announcement 
300.44 PBXICENTREX TRANSFER 
While connected to...

sTARPLUS@ 96EX 
Key Telephone System 
To erase your name: 
A. Dial [29!3]. 
B. Press SPD button. 
Station Speed Bin 00 is used to store name in 
display information. 
300.50 PULSE TO TONE SWITCHOVER 
The signaling on an outside line can be changed 
from dial pulse to tone (DTMF) manually while 
dialing out. 
To perform the change-over 
A. Dial an [*] 
B. Remaining digit will be sent using DTMF. 
The Pulse to Tone Switchover command may also 
be included into a speed dial bin. Refer to speed 
dial...

no line appearance for the line programmed into 
the speed bin, that line will come up under the Night Answer must have a loop button appearance 
Loop button or Pool button when accessed. if the ringing outside line does not appear at 
their 
phone. 
300.56 SYSTEM SPEED DIAL 
If no outside line has been specified in program- 
ming, one will be chosen automatically or you can 
choose one now. 300.59 VOICE MAIL OPERATION (VM) 
Forward Callers to vour Mail box 
Intercom and Transferred CO callers may 
be...

300.60 VOLUME CONTROLS 
There are two volume control wheels on the right 
side of the Key Telephone. Spinning the switch 
toward you decreases the volume. The front 
switch is for voice, background music, and speak- 
erphone volume. The back switch is for tone 
ringing volume. 
SINGLE LINE TELEPHONE FEATURE3 
.300.61 ACCOUNT CODE 
SLT stations can enter an account code to identify 
the call or calling station. 
Entering Account Code before a call: 
A. Lift the handset. 
B. Dial [80]. 
C. Dial the account...