Yamaha Dpx 830 User Manual

37
Others
If the following problem occurs after the lamp is replaced, check the following first.
ProblemSolution
The exhaust vents emit warm 
air. This air comes out after cooling the inside of the projector. It may feel hot, but this is not a malfunction.
The menu can not be used.  The microcomputers inside the projector may be wrongly operating because of noise.
➜Press the STANDBY/ON button to turn off the lamp and unplug the power cable from the wall outlet.
Wait about 10 minutes, plug the power...

38
This projector has two indicators, each of which shows the operation condition of the projector.
Refer to Troubleshooting for additional indication signals.
◆Normal conditions
◆Abnormal conditions
*1: When LAMP MODE of the SETUP menu is set to CINEMA. 
*2: When LAMP MODE is set to STANDARD, this duration will be decreased to 2000 hours.
POWER STATUS CONDITION NOTE
Steady red Off
Stand-by.
Steady green Blinking green
Warming up period (about 1 minute).The STANDBY/ON button cannot be used 
until the...

39
◆Projector specifications
The specifications and outside appearance of the projector are subject to change without prior notice.
Type DLP™ projector
Model DPX-830
Display Technology 0.65-inch Single chip DMD
Pixel 1280 × 768 = 983040 pixels
Projection lens F 2.4 – 2.6 f= 23 – 27.6 mm
Light-source lamp 200 W
Image size (Projection distance) 40 min. to 275 max. (Projection distance 1.4 to 10.1 m (16:9 screen))
Maximum resolutionComputer signal Maximum resolution: 1280 x 1024 dots (Analog) / compressed...

40
◆Composite / S-video signal specifications
Signal mode Resolution 
(H × V)Horizontal frequency 
(kHz)Vertical frequency 
(Hz)Default mode for 
16:9 screen 
(H × V)
*1
Default mode for  
4:3 screen 
(H × V)
*2
Through mode 
(H × V)
TV60 (525i) – 15.73 59.94 1280 × 720 1024 × 576 –
TV50 (625i) – 15.63 50.00 1280 × 720 1024 × 576 –
◆Component signal specifications
Signal mode Resolution 
(H × V)Horizontal frequency 
(kHz)Vertical frequency 
(Hz)Default mode for 
16:9 screen 
(H × V)
*1
Default mode for...

41
*1: When ASPECT in the INITIAL menu is set to DEFAULT, and SCREEN ASPECT in the SETUP menu is set to 16:9.
*2: When ASPECT in the INITIAL menu is set to DEFAULT, and SCREEN ASPECT in the SETUP menu is set to 4:3.
*3: Available with RGB-CS (4 line) sources from SCART terminal.
*4: Same resolution as the DEFAUL mode depending on the each SCREEN ASPECT.
Important
 This projector can recognize 1280 × 768 pixels as the maximum resolution, however, it is programmed to recognize 1280 × 
720 or 1024 × 768...

DPX-830
Digital Cinema Projector
Projecteur Cineme Numerique
OWNER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES BRUKSANVISNING
GEBRUIKSAANWIJZINGYAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADAYAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, GERMANYYAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70...