Zenith Projector Dsv 100 User Manual

21
20
21
7.2 Set-up menuSet-up menuIn the set-up menu the following 
sub-menus are available:•
Picture orientation
•
Language
•
Mouse system
•
Quick key assignment
•
ZAP keys assignment
•
Accumulated lamptime
•
TV-tuner
7.2.1 Picture orientation Picture orientationThe picture orientation menu is used for rotat-
ing and mirroring the picture.NormalNormal is used when the projector is standing
on a table projecting a picture on a screen.MirrorMirror is used when the projector is projecting
a picture from...

23
22
23
selected in this menu. In this example, the first
time you click on the quick key you will activate
the volume function. A volume bar will be dis-
played at the bottom of the projected image
where you can adjust the volume up and
down. You adjust the bar by either pressing
the pressure-sensing pad right or left or you
may use one of the two zap keys on the
remote control. To accept the adjustment, and
terminate the quick menus click on the left
mouse button. To get back to the original vol-
ume,...

Show accumulated lamp timeIn this window you can see the accumulated
time that the lamp has been in use. You also
use this window to reset the accumulated lamp
time after the lamp has been replaced.7.2.7 Television programsThis menu is only displayed if the optional TV
tuner is installed and a TV tuner is selected as
the source. The television program menu is
then activated by pressing the ”television pro-
gram” icon.
The television program menu is divided in two
parts:•
Automatic TV station 
•
Program...

When PAL/SECAM video is connected 
brightness, contrast and saturation will be
available. 
All options will be available when NTSC video
is connected. 
Select OK to save your changes and exit, or
select Cancel to exit without saving your
changes. Selecting Default restores factory set-
tings.
7.3.2 Audio controlAudio controlSelect this function when you have connected
an audio signal to the ‘Audio in’ on the projec-
tor connectors (or through the EVC cable). Use
the four sliders to adjust volume, bass,...

No image appears on the screen
Possible causes and remedies:1. The projector is left in Standby mode. If
the product is in standby mode, there will
be a red light next to the stand-by button.
Press the 
stand-by button or the Menu key on the
remote control.
2. The lamp does not function. Check the
light on the control panel. If the light is
orange, the lamp does not function.
Contact your Zenith dealer. 
3. The product is set in ‘blank mode’. Press
the zap keys on the remote control.
4. The brightness is...

31
30
Specifications:Projector Type DLP™Display Device DMD™Resolution (native) SVGA (800x600)Resolution (compressed) XGA (1024x768)
Light Output, DSV-100 (ANSI, Typical) 800 LumensLight Output, DSV-110 (ANSI, Typical) 700 LumensProjection Lamp 150W UHPLamp Life (typical) 2,000 Hrs.Video Input Capability NTSC M, PAL, B/D/G/I/H/M, SECAMHorizontal Sync Input Frequency 15 – 60 kHzVertical Sync Input Frequency 48 – 85 Hz
Aspect Ratio Capability (DSV-100) 4:3Aspect Ratio Capability (DSV-110) 4:3 & 16:9...

206-3651
© Copyright 2000 Zenith Electronics Corporation