Acer Aspire 2930 User Manual

							Chapter 371
Removing the Finger Print Reader
1.See “Removing the Upper Cover” on page 68.
2.Remove the single securing screw from the Finger Print Reader bracket.
3.Remove the bracket as shown.
4.Using your fingers, gently lift the Finger Print Reader board from the Upper Cover.
StepSizeQuantityScrew Type
Finger Print 
ReaderM2*3 1 
						

							72Chapter 3
Removing the TouchPad Bracket
1.Remove the Upper Cover. See “Removing the Finger Print Reader” on page 71.
2.Lift up the locking lever (1) and remove the Touch Pad FFC from the Touch Pad board (2).
NOTE: To replace the Touch Pad, the entire Upper Cover must be replaced.
3.Remove the single securing screw.
StepSizeQuantityScrew Type
TouchPad 
BracketM2*3 1
1
2 
						

							Chapter 373
4.Grasp the left side of the bracket and angle upwards to remove. 
						

							74Chapter 3
Removing the Launch Board
1.See “Removing the Upper Cover” on page 68.
2.Remove the three securing screws.
 
3.Remove the Launch Board from the upper cover.
IMPORTANT:Take note of the FFC and ensure it does not catch on the upper cover.
 
StepSizeQuantityScrew Type
Launch Board M2*3 3 
						

							Chapter 375
Removing the USB Board
1.See “Removing the Upper Cover” on page 68.
2.Unlock the securing latch and release the FFC.
3.Remove the securing screw.
4.Grasp the module by the ends and lift to remove.
StepSizeQuantityScrew Type
USB Board M2*3 1 
						

							76Chapter 3
Removing the I/O Board
1.See “Removing the Upper Cover” on page 68.
2.Remove the single securing screw.
3.Grasp the module by the end, pivot and lift the board to remove.
StepSizeQuantityScrew Type
I/O Board M2*3 1 
						

							Chapter 377
Removing the Bluetooth Module
1.Remove the USB Board. See “Removing the USB Board” on page 75.
2.Lift the Bluetooth module away from the base.
3.Disconnect the Bluetooth cable and remove the module. 
						

							78Chapter 3
Removing the Modem Module
1.See “Removing the Upper Cover” on page 68.
2.Peel back the adhesive strip to expose the cabling.
3.Remove the cable as shown.
4.Remove the two securing screws from the modem module.
StepSizeQuantityScrew Type
Modem Module M2*3 2 
						

							Chapter 379
5.Lift the module from the mainboard. 
						

							80Chapter 3
Removing the Mainboard
1.See “Removing the Upper Cover” on page 68.
2.Remove the Bluetooth Module. See “Removing the Bluetooth Module” on page 77.
3.Remove the three securing screws.
4.Remove the DC-IN jack from its socket.
 
StepSizeQuantityScrew Type
Mainboard M2*3 3