1991 1999 ford explorer chilton User Manual

Vehicle certification labels
Click to enlarge
HOW TO USE THIS BOOK
26 Vehicle Data 

Other important vehicle data labels can be found on the drivers door, near the latch
The vehicle data appears on the Safety Compliance Certification Label on the second and third lines following
the identification number. The code set (two numbers or a number and letter) above COLOR identify the
exterior paint color, with two sets of codes designating two tone paint. The three digits under W.N. designate
the wheelbase in inches. The letter and three digits under TYPE/G.V.W. designate the truck model...

Safety Compliance Certification Label
Safety compliance labelClick to enlarge
The English Safety Compliance Certification Label is affixed to the door latch edge on the drivers side door.
The French Safety Compliance Certification Label is affixed to the door latch edge on the passengers side
door. The label contains the following information: name of manufacturer, the month and year of
manufacture, the certification statement, and the Vehicle Identification number. The label also contains
information...

The safety compliance label is found on the drivers door, near the latch
Emission Calibration Label
Emission calibration labelClick to enlarge
The emission calibration number label is attached to the left side door or the left door post pillar. This label
plate identifies the engine calibration number, engine code number and the revision level. These numbers are
used to determine if parts are unique to specific engines. The engine codes and calibration are necessary for
ordering parts and asking...

Engine
The engine identification code is a letter located in the eighth digit of the Vehicle Identification Number
stamped on a metal tab that is riveted to the instrument panel close to the windshield. Specific engine data is
located on a label attached to the timing cover.
Transmission
The transmission code may be found in two places on the vehicle. One is on the Safety Standard Certification
label attached to the left drivers side door lock post. The code appears as a letter in the Trans column of...

combination in the Axle column of the label. The rear axle identification code is also stamped on a metal tag
hanging from the axle cover-to-carrier bolt at the 2 oclock position in the cover bolt circle.
Chilton® Automotive Information Systems. © 2004 Thomson Delmar Learning. HOW TO USE THIS BOOK
Rear Axle 31 

ROUTINE MAINTENANCE AND TUNE-UP
Introduction
UNDERHOOD MAINTENANCE COMPONENT LOCATIONS Click to enlarge
ROUTINE MAINTENANCE AND TUNE-UP 33 

UNDERVEHICLE MAINTENANCE COMPONENT LOCATIONS
Click to enlarge
HOW TO USE THIS BOOK
34 Introduction 

Ranger underhood maintenance component locations for the 2.3L engine-2.5L engine similar
Click to enlarge
HOW TO USE THIS BOOK
Introduction 35 

Ranger underhood maintenance component locations for the 2.9L engine
Click to enlarge
Ranger underhood maintenance component locations for the 3.0L engine Click to enlarge
HOW TO USE THIS BOOK
36 Introduction