AEG S 53600 Css0 User Manual

• do not store warm food or evaporat-
ing liquids in the refrigerator
• do cover or wrap the food, particularly
if it has a strong flavour
• position food so that air can circulate
freely around it
5.4 Hints for refrigeration
Useful hints:
Meat (all types) : wrap in polythene bags
and place on the glass shelf above the
vegetable drawer.
For safety, store in this way only one or
two days at the most.
Cooked foods, cold dishes, etc..: these
should be covered and may be placed
on any shelf.
Fruit and...

6. CARE AND CLEANING
6.1 Cleaning the interior
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abra-
sive powders, as these will dam-
age the finish.
CAUTION!
Unplug the appliance before car-
rying out any maintenance oper-
ation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and...

6.4 Defrosting the freezer
A certain amount of frost will always form
on the freezer shelves and around the
top compartment.
Defrost the freezer when the frost layer
reaches a thickness of about 3-5 mm.
To remove the frost, follow the
instructions below:
• pull out the plug from the wall socket
or switch off the appliance
• remove any stored food, wrap it in
several layers of newspaper and put it
in a cool place
• remove the freezer drawers
• put insulating material around the
drawers, e.g. blankets or...

ProblemPossible causeSolution
 The door is not closed
correctly.Refer to "Closing the
door".
 The door has been
opened too frequently.Do not keep the door
open longer than necessa-
ry.
 The product temperature
is too high.Let the product tempera-
ture decrease to room
temperature before stor-
age.
 The room temperature is
too high.Decrease the room tem-
perature.
Water flows on the
rear plate of the re-
frigerator.During the automatic de-
frosting process, frost de-
frosts on the rear plate.This...

ProblemPossible causeSolution
The temperature in
the refrigeration is
too high.There is no cold air circu-
lation in the appliance.Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high.Products are too near to
each other.Store products so that
there is cold air circulation.
The appliance does
not operate.The appliance is switched
off.Switch on the appliance.
 The mains plug is not
connected to the mains
socket correctly.Connect the mains plug to
the...

8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
8.2 Location
AB
100 mm
min 20 mm
The appliance should be installed well
away...

8.4 Rear spacers
2
431You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.Release the screw.
2.Engage the spacer below the screw.
3.Turn the spacer to the right position.
4.Tighten again the screws.
8.5 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
8.6 Removing the shelf holders
A
B
C
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the...

8.7 Door reversibility
E
F A
B
D C
WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
• Remove the spacer (A) and move to
the other side of the hinge pivot (B).
• Remove the doors.
• Remove the left-hand cover pin of the
middle hinge (C,D) and move to the
other side.
• Fit the pin of the middle hinge...

2
1
• Remove the plugs on the upper side
of both doors and move them to the
other side
• Re-insert the lower door on the lower
hinge pivot .
• Insert the middle hinge into the left
drill of the lower door.
• Unscrew the upper hinge pivot and
place it on the opposite side.
• Fit the upper door on the upper door
pivot.
• Re-insert the upper door on the mid-
dle hinge pivot slightly tilting both
doors.
• Re-screw the middle hinge . Do not
forget the plastic spacer .
A C B
• Remove the covers (B). Remove...

BRRR! HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
CLICK!CLICK!
BRRR!
BRRR!
BLUBB!BLUBB!
40www.aeg.com