Apple power mac g4 agp graphics User Manual
Have a look at the manual Apple power mac g4 agp graphics User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take ApartSupports, Front and Rear - 149 1. Using a 2.5 mm Allen wrench, remove the two screws securing each support to the computer. 2. Remove the support from the computer.
Take ApartLower Panels, Front and Rear - 150 Lower Panels, Front and Rear Before you begin, remove the front and/or rear support. ±Warning: When the computer is upside down or the lower supports are removed, the computer can be unstable.
Take ApartLower Panels, Front and Rear - 151 Note: The computer is shown upside down. 1. Lift the lower front panel or the lower rear panel from the chassis. There are no screws holding these panels to the chassis; the front and rear supports hold them in place. Important: These panels are keyed. The notch goes on the access panel side.
Take ApartFront Panel - 152 Front Panel Before you begin, remove: ¥ top front handle ¥ lower front support and lower front panel ¥ Power Mac G4 (PCI/AGP Graphics/GIgabit Ethernet/Digital Audio): CD/DVD drive bezel and CD/DVD drive carrier ¥ Power Mac G4 (QuickSilvers): CD/DVD/ Zip drive carrier ±Warning: When the lower support is removed, the computer can be unstable.
Take ApartFront Panel - 153 1. Open the side access panel. Locate the front panel tabs. 2. Using a screwdriver, carefully push the front panel tabs inward to release them from the chassis. 3. Pull the front panel off the chassis. Note: If you are installing a new front panel on Power Mac G4 (QuickSilvers), transfer the blank or Zip bezel from the original panel to the new panel.
Take ApartCD/DVD Drive Door, Power Mac G4 (QuickSilvers) - 154 CD/DVD Drive Door, Power Mac G4 (QuickSilvers) Before you begin, remove: ¥ top front handle ¥ lower front support and lower front panel ¥ CD/DVD/Zip drive carrier ¥ front panel ±Warning: When the lower support is removed, the computer can be unstable.
Take ApartCD/DVD Drive Door, Power Mac G4 (QuickSilvers) - 155 1. Remove the four mounting screws on the front of the computer.
Take ApartCD/DVD Drive Door, Power Mac G4 (QuickSilvers) - 156 2. Open the side access panel and remove the CD/DVD door shield from the chassis.
Take ApartCD/DVD Drive Door, Power Mac G4 (QuickSilvers) - 157 3. Using a flatblade screwdriver, gently press the CD/DVD door mounting pegs flush with the chassis. 4. Push the CD/DVD drive door forward, and remove the door from the computer.
Take Apart Rear Vented Panel - 158 Rear Vented Panel Before you begin, remove the following: ¥ top rear handle ¥ lower rear support ±Warning: When the lower support is removed, the computer can be unstable.