BEKO WKD 75100 User Manual

EN5
Specifications
Specifications of this appliance may change without notice to improve th\
e quality of 
the product. Figures in this manual are schematic and may not match your\
 product 
exactly. 
Values stated on the machine labels or in the documentation accompanying\
 it are 
obtained in laboratory in accordance with the relevant standards.  Depen\
ding on 
operational and environmental conditions of the appliance, values may va\
ry.
Models
WKD 75100
WKD 75100 S
WKD 75080Maximum dry laundry...

EN6
Please	read	the	following	information.	
Otherwise,	there	may	be	the	risk	of	
personal injury or material damage. 
Moreover,	any	warranty	and	reliability	
commitment will become void.
General Safety
•	 Never	place	your	machine	on	a	carpet	covered	floor.	Otherwise,	
lack of airflow from below of your 
machine may cause electrical 
parts to overheat. This may cause 
problems with your washing 
machine.
•	 If	the	power	cable	or	mains	plug	is	 damaged you must call Authorized 
Service for repair.
•	 Check...

EN7
companies that produce detergents 
for your machine.
Safety instructions
•		 This	appliance	must	be	connected	to an earthed outlet protected by a 
fuse of suitable capacity.
•		 The	supply	and	draining	hoses	must	 always be securely fastened and 
remain in an undamaged state.
•	 Fit	the	draining	hose	to	a	washbasin	 or bathtub securely before starting 
up your machine. There may be a 
risk of being scalded due to high 
washing temperatures!
•	 Never	open	the	door	or	remove	the	 filter while there is...

EN8
Removing packaging 
reinforcement
Tilt the machine to remove the 
packaging reinforcement. Remove the 
packaging reinforcement by pulling the 
ribbon.
Opening the transportation 
locks
C Transportation safety bolts must 
be removed before operating the 
washing	machine!	Otherwise,	the	
machine will be damaged!
1.   Loosen all the bolts with a spanner 
until	they	rotate	freely	(“C”)
2.   Remove transportation safety bolts 
by turning them gently. 3. 
Fit the covers (supplied in the bag 
with	the...

EN9
3.		 Important:	Tighten	all	lock	nuts	up	again.
Connecting to the water 
supply.
Important:
•		 The	water	supply	pressure	required	to run the machine must be 1-10 
bar	(0,1	–	1,0	MPa).	Attach	a	
pressure-reducing valve if the water 
pressure is higher.
•		 Connect	the	special	hoses	supplied	 with the machine to the water intake 
valves on the machine. The hose 
bearing	the	“red”	sign	(90°C	max)	
is the hot water inlet and the hose 
bearing	 the	“blue”	 sign	(25°C	 max)	is	
for the cold water inlet.
•...

EN10
•	 The	end	of	the	drain	hose	can	be directly connected to the 
wastewater drain or to the 
washbasin. The fitting must be 
secured in all types of connections. 
Your	house	may	be	flooded	if	the	
hose falls out of its housing during 
water discharging.
•	 The	hose	should	be	attached	to	a	 height of at least 40 cm, and 100 
cm at most.
•	 In	case	the	hose	is	elevated	 after laying it on the floor level or 
close to the ground (less than 
40	cm	above	the	ground),	water	
discharge becomes more difficult...

EN11
Sorting the laundry
•	 Sort	the	laundry	according	to	type	of fabric, color, and degree of soiling 
and permissible water temperature.
  Always follow the advice on the 
garment labels.
Preparing clothes for washing
Laundry items with metal attachments 
such as, bras, belt buckles and metal 
buttons will damage the machine. 
Remove metal attachments or place the 
items in a clothing bag, pillow case, or 
something similar. •		 Empty	pockets	and	remove	all	
foreign objects such as coins, pens 
and...

EN12
Following weights are given as 
examples. 
Laundry typeWeight	(gr.)
Bathrobe 1200
Napkin 100
Duvet cover 700
Bed Sheet 500
Pillowcase 200
Tablecloth 250
Towel 200
Evening gown 200
Underclothing 100
Men’s	coveralls 600
Men’s	shirt 200
Men’s	pajamas 500
Blouse 100
Loading door
The door is locked during program 
operation. The door can be opened after 
some time following the program end.
•	 Open	the	door.
•	 Place	laundry	items	loosely	in	the	
machine.
•	 Push	the	door	until	it	clicks	into	 place...

EN13
Detergent 
quantity
for prewashing 1/2 measure
for main 
washing 1 measure
with hard water an additional 
1/2 measure
Softener
Put	the	softener	into	the	softener	
compartment of the detergent 
dispenser.
•		 Use	the	proportions	recommended	 on the packet.
•		 Never	exceed	the	(>	max	

EN14
7 – Spin Speed Adjustment Button
8	-	Time	Delaying	Button	(+/-)
9 - Temperature Adjustment Button
10	-	Start/Pause/Cancel	Button
11 - Auxiliary Function Buttons
	 a-	Prewash
 b- Quick Wash
	 c-	Rinse	Plus
  d- Anti-creasing
12	-	Program	Selection	Knob
13 - Display
14	-	On	/	Off	Button
Control panel
Figure 2
5  Selecting a program and operating your machine
+
Reset
mini 30
super
40
F1 F2F3F43’’
14
12
10
11d
11c
11b
11a
8
7
13
9
On/Off Reset
3 sn. Coton
Start
Pause S
ynthetics
Woollens...