Comdial Executech 1432 KSU Instructions Manual

IMI 66-036 
Table Of Conter\.ys 
TABLE OF CONTENTS 
‘5 
CHAPTER 1 INTRODUC?ION 
......................................... 
l-l 
MANUAL SCOPE 
............................................. RELATED INFORMATION 
...................................... 11-i - 
STATION TYPES 
............................................ l-2 
INSTALLER/USER INFORMATION REGARDING 
FCC RULES AND REGULATIONS 
................................ 
l-2 
RINGER EGUIVALENCE 
NUMBER 
................................ l-4 
CHAPTER 
2...

, - .IMI 66-036 
i. Figure 2-l. 
Figure 2-2. 
Fi,gure 2-3. 
Figure 2-4. 
Figure 2-5. 
Figure 3-1. 
Figure 3-2. 
Figure 3-3. 
Fiyure 4-l. 
Figure 4-2. 
Table 2-1. Wiring For Station Connector Block J-1.............2- 9 
Table 2-2. Wiring For Station Connector 
Block J-2............2-10 
Table 2-3. Wiring For Station Connector Block J-3............2-11 
Table 2-4. Wiring For Auxiliary Connector Block J-4..........2-12 
Table 2-5. Wiring For CO/PBX Connector Block J-S.............2-13 Illustrations And...

IMI 66-036 
Introduction 
STArION TYPES 
This Key.Service Unit supports the operation of the following 
stations: 
e 22 Line/Feature Keyset 
0 Reused 3/S Line Keyset 
0 Single-Line 
Keyset 
l DSS/HLF Console 32-Key, 40-Key, and IO-Key 
INSTALLER/USER INFORMATION 
KtiGARDING FCC RULES AND REGULATIONS 
This electronic 
key system complies with Federal Communications 
- 
Commission (FCC) Rules, Part 6~. 
The FCC registration 
label on the KSU contains the FCC registration 
number, the ringer equivalence...

L 
i 
Introduction 
COflPMI~ILIIY WITH TE&EPHONE NETWORK 
__------- 
When necessary, 
the telephone operating company provides information 
on the maximum number of telephones or ringers that can be connected 
to one line, as well as any other applicable technical information. 
The telephone operating company can temporarily discontinue service 
and make changes which could effect the operation of this equipment. 
They must, however, 
provide adequate notice, in writing, of any future 
equipment changes...

IMI 66-03b Introduction 
Operation of this equipment in a residential area may 
cause 
interference to radio and television reception; in which case the user 
is encouraged to take whatever measures may 
be required to correct the 
interference. 
If this equipment does 
cause interference to radio or television 
reception, which can 
be determined by turning the equipment off and 
on; the user is encouraged to try to correct the interference by one 
or more of the following measures: 
Reorient the...

I‘M1 66-036 Installation 
CHAPTER 2 
INSTALLATION 
MOUNTING CONSIDERATIONS 
0 The KSU 
surface. cabinet should 
be attached vertically to any sturdy, flat, 
It may 
be vertically rack mounted if desired. 
0 The KSU must 
be located within six (6) feet of a proper electrical 
outlet. 
The KSU power supply requires a dedicated 117VAC 15 AMP 
circuit, 
with a third-wire ground, 
electrical outlet. supplied to a NEMA S-15R 
0 The distance between the KSU and the TELCO/PSX 
jacks must be 25 feet 
or less as...

4. 
5. 
IMI 66-036 
Installation 
Drill holes in the mounting surface of a proper size to 
accotimodate the hardware being used. 
holes vJith inserts, If necessary, 
prepare these 
anchors or other attachment devices as 
dictated by the type of mounting surface. 
Attach the KSU to the mounting surface with four (4) screws 
installed through the 
KSU mounting flange and into the mounting 
surface holes. 
Note that the flange holes are elongated with an 
enlargement at one end of the hole. 
This feature...

i 
IMI 66-036 
Installation 
SYSTEM 
HIRING 
System cabling may be routed concealed or visible as the installation 
location requires. Good engineering practices 
must 
be observed and 
all applicable building codes 
must be adhered to. 
Tables 2-1 through 
2-5 and Figures 2-2 through 2-5 illustrate the system wiring and 
connection points. 
AC Power Connection 
- 
To apply AC power to the KSU, 
connect the AC power cord to the NEMA 
S-1SK outlet which supplies the dedicated 117VAC @ 15 AMP electrical...