Dell E6530 Service Manual

Back to Contents Page    
Camera and Microphone  
 
Removing the Camera and Microphone  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .  
3. Remove the  access panel .  
4. Remove the  hinge covers .  
5. Remove the  display assembly .   
6. Remove the  display bezel .   
7. Loosen the captive screw that secures the camera and microphone to the display panel.
   
8. Disconnect the data cable from the camera and microphone and remove lift the camera and...

Back to Contents Page    
Coin - Cell Battery  
 
Removing the Coin - Cell Battery  
   
1. Follow the procedures in  Before Working Inside Your Computer .  
2. Remove the  battery .   
3. Remove the  access panel .   
4. Disconnect the coin - cell battery cable from its connector on the system board. 
   
5. Lift the coin - cell battery up and away from the computer. 
   
Replacing the Coin - Cell Battery  
To replace the coin - cell battery, perform the above steps in reverse order.  
Back to Contents...

Back to Contents Page    
DC - In Port  
 
Removing the DC - In Port  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .   
3. Remove the  access panel .   
4. Remove the  subscriber identity module (SIM) card .   
5. Remove the  optical drive .   
6. Remove the  keyboard .   
7. Remove the  coin - cell battery .   
8. Remove the  hinge covers .   
9. Remove the  display assembly .   
10. Remove the  hard drive .   
11. Remove the  Latitude ON™ Flash card...

Back to Contents Page    
Diagnostics   
 
   Device Status Lights  
   Battery Status Lights  
   Battery Charge and Health   
   Keyboard Status Lights  
   LED Error Codes  
   
Device Status Lights  
Battery Status Lights  
If the computer is connected to an electrical outlet, the battery light operates as follows:  
l Alternately blinking amber light and blue light   —   An unauthenticated or unsupported, non - Dell AC adapter is attached to your laptop.   
l Alternately blinking amber light with...

Back to Contents Page    FLASH - ON - FLASH  
Display panel error 1. Reseat the display cable.   
2. Replace the display panel.   
3. Replace the video card/system board.   
OFF - FLASH - OFF  
Memory compatibility error 1. Install compatible memory modules.   
2. If two modules are installed remove one and test. Try the 
other module in the same slot and test. Test the other slot 
with both modules.   
3. Replace the memory.   
4. Replace the system board.   
ON - FLASH - ON  
Memory is detected but has...

Back to Contents Page    
ExpressCard Board  
 
Removing the ExpressCard Board  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .   
3. Remove the  ExpressCard .   
4. Remove the  access panel .   
5. Remove the  optical drive .   
6. Remove the  keyboard .   
7. Remove the  hinge covers .   
8. Remove the  display assembly .   
9. Remove the  palm rest assembly .   
10. Remove the screws that secure the ExpressCard board to the system board. 
   
11....

Back to Contents Page    
ExpressCard  
 
Removing the ExpressCard  
   
1. Press on the ExpressCard and release it from the computer.   
   
2. Slide the ExpressCard out of the computer.   
   
Replacing the ExpressCard  
To replace the ExpressCard, perform the above steps in reverse order.  
Back to Contents Page    
   
    WARNING:  Before working inside your computer, read the safety information that shipped with your computer. For additional safety best 
practices information, see the Regulatory...

Back to Contents Page    
Fingerprint Reader  
 
Removing the Fingerprint Reader  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .  
3. Remove the  access panel .  
4. Remove the  optical drive .  
5. Remove the  keyboard .  
6. Loosen the captive screw (labeled F) that secures the fingerprint reader to the computer. 
   
7. Open the clip that secures the fingerprint data cable and disconnect it from the system board. 
   
8. Push the fingerprint reader...

Back to Contents Page    
Hard Drive  
 
Removing the Hard Drive  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Place the computer upside down on a clean, flat surface.   
3. Remove the screws that secure the hard drive to the computer.  
   
4. Slide the hard drive out of the computer. 
   
5. Remove the screw that secures the face plate to the hard drive. 
   
6. Pull out the face plate to remove it from the hard drive. 
   
Replacing the Hard Drive  
To replace the hard...

Back to Contents Page    
Heat Sink and Fan Assembly  
 
Removing the Heat Sink and Fan Assembly  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .  
3. Remove the  access panel .   
4. Disconnect the cable that connects the fan to the system board. 
   
5. Remove the screws that secure the fan to the heat sink. 
   
6. Remove the fan from the computer. 
   
7. Loosen the captive screws that secure the heat sink to the system board. 
   
8. Lift the edge...